7245-005

7245-005
Pub. DS7245-005
GAI-TRONICS® CORPORATION
A HUBBELL COMPANY
Model 7245-005 Indoor
Remote Subset Amplifier Enclosure
General Information
This data sheet applies to the Model 7245-005 Indoor Remote Subset Amplifier Enclosure, which is
intended for use in GAI-Tronics Page/Party® and SmartSeries ADVANCE systems. It enables the
amplifier, speaker, and field cabling of subset stations to be remotely mounted. This indoor amplifier
enclosure is constructed of fabricated steel and is equipped with a 24-position remote subset connector.
For proper operation Page/Party® operation, the Model 7245-005 Amplifier Enclosure must be installed
with a Model 723-005 or 723-905 Remote Amplifier and with a subset from the following list:
Single Party Subsets:
Multi-Party Subsets:
Model 726-101 Desktop Subset
Model 7265-101 Desktop Subset (5-party)
Model 711-102 Desk-Edge Subset
Model 7115-102 Desk-Edge Subset (5-party)
Model 716-102 Flush-Mount Subset
Model 7165-102 Flush-Mount Subset (5-party)
NOTE: Subsets containing an RF hookswitch are not supported.
The Model 7245-005 Indoor Remote Subset Amplifier Enclosure provides terminations for the following:
•
•
•
Connectorized subset cabling
Plug-in remote amplifier
External speaker(s)
•
•
System cabling
Auxiliary input signals (SmartSeries stations only)
Figure 1. Typical Desk-edge Installation
Figure 2. Typical Flush-mount Installation
GAI-Tronics Corporation 400 E. Wyomissing Ave. Mohnton, PA 19540 USA
610-777-1374 „ 800-492-1212 „ Fax: 610-796-5954
VISIT WWW.GAI-TRONICS.COM FOR PRODUCT LITERATURE AND MANUALS
Model 7245-005 Indoor Remote Subset Amplifier Enclosure
Pub. DS7245-005
Page: 2 of 2
Specifications
Environmental
Temperature range ............................................................................ −22° F to +158° F (−30° C to +70° C)
Relative humidity................................................................................................ Non-condensing 85% max.
Indoor environmental rating ..................................... Meets the requirements of IP20; NEMA 2 (Type 20)
Mechanical
Construction/finish.................................................... 16-gauge cold-rolled steel/textured gray polyurethane
Mounting.......................................... Wall or column, four 0.312-inch (7.92 mm) diameter mounting holes
Connections ............................................................................... Internal screw-type barrier terminal blocks
Dimensions ................................................................ 8.1 H × 8.1 W × 5.1 D inches (206 × 206 × 129 mm)
Shipping weight .................................................................................................................... 5.4 lbs. (2.5 kg)
Approval
CE Mark
f:\standard ioms - current release\data sheets\ds7245-005.doc
11/10
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement