Yamaha | HR-3000B | Owner's Manual | Yamaha HR-2000B Owner's manual

Yamaha HR-2000B Owner's manual
 YAMAHA
BASS AMPLIFIER
AMPLIFICATEUR POUR GUITARE BASSE
HR-2000B
HR-3000B
Owners Manual
Mode d'emploi
Thank you for purchasing the Yamaha Bass
Amp HR-2000B/HR-3000B.
This high-performance, compact bass
amplifier offers a built-in compressor, dou-
ble volume and triple tone controls for
precise, no compromise sound control.
Please read this owner's manual carefully,
and enjoy your HR-2000B/HR-3000B for a
long time.
CONTENTS
PRECAUTIONS ..............eomeecconenreccao Y
CONTROL PANEL -.............eeeenevnrenoo 2/3
REAR PANEL ...............reescancecoraneonmen 3
SETTING EXAMPLES ..............e...eemeo. 4
SPECIFICATIONS -............eormnennmecocano 5/6
BLOCK DIAGRAM ..................e.eecevcas 14
SERVICE -...............e.eneacsnenrenavoreoaieea 15
PRECAUTIONS
e Check for correct voltage before connecting the power cord to your AC outlet.
e When connecting the electric guitar and the amplifier, make sure to plug in the guitar before plugging
in the amplifier. Plugging in the amplifier first may cause damage to the speaker.
e Be sure to turn the VOLUME control of the amplifier counterclockwise to its minimum position when
plugging or unplugging the guitar cord and turning the power supply ON and OFF,
e Always handle the amplifier with care. Rough handling or dropping it may result in deterioration of its
performance. |
e Disconnect the power cord from the AC outlet whenever there is thunderstorm to prevent accidents
that may resuit from lightning.
CONTROL PANEL
*HR-20008
BASS AMPLIFIER HR-2000R
4 85,
S
à à
*HR-3000B
BASS AMPLIFIER HR-30008B
© INPUT
Connect the bass guitar to this terminal.
O VOLUME/ @ MASTER VOLUME
These controls set the volume. When using bass
guitars with pickups of different output levels,
set the input level using the VOLUME control, and
then set the final volume using MASTER
VOLUME. It is also possible to intentionally make
the sound distorted. As you turn the VOLUME
up, the sound will become more distorted.
*If you lower either of these controls to 0”,
there will be no sound.
@ BASS
This controls the low frequencies (around 80Hz).
When the control is set to ‘’5’’, the sound is nor-
mal, and as you turn it toward 10” the lower
frequencies are boosted, producing a heavy and
deep sound. As you turn it toward “O”, the lower
frequencies are cut, producing a lighter sound.
When using round-wound strings and playing
chopper style, use this control to cut the lower
frequencies, and boost the middle and upper
frequencies.
O MIDDLE (HR-2000B only)
This controls the middle frequencies (around
800Hz). When the control is set to “5”, the
sound is normal, and as you turn it toward “10”
the middle frequencies are boosted, producing
a richer sound. As you turn it toward “0”, the
middle frequencies are cut, producing a softer
sound. When you want the sound to move out
front, use this control to boost the middle
frequencies.
® MID. FREQ. (HR-3000B only)
This control sets the center frequency of the
midrange equalization. The midrange EQ frequen-
cy is continuously variable from 200 Hz to 1 kHz.
© MID. LEVEL (HR-3000B only)
This control sets the amount of boost or cut pro-
duced at the midrange center frequency deter-
mined by the MID FREQ control. Set at “0” there
is no boost or cut, and therefore no change in the
sound. As the MID LEVEL control is rotated
clockwise toward the ‘“5”’’ setting the midrange
frequencies are boosted, and rotated counter-
clockwise towards the ‘*—D’’ setting the
midrange frequencies are cut.
© TREBLE
This controls the high frequencies {around 2kHz).
When the control is set to “5”, the sound is nor-
mal, and as you turn it toward ‘10°’ the high fre-
quencies are boosted, producing a clear, attacky
sound. As you turn it toward “0”, the high fre-
quencies are cut, producing a soft, round sound.
When playing strong melodious riffs, use this
control to boost the high frequencies.
© COMPRESSOR
This control adjusts the amount of compression
applied by the internal compressor. As the con-
trol is rotated towards the ‘’10”’ setting, greater
compression is applied, smoothing out the overall
level of the instrument sound. The compressor
can be used to smooth out uneven picking and
variation in the attack of “chopper” bass lines,
etc.
Set the COMPRESSOR control to the “OFF”'posi-
tion {the control will’ ‘click’’ into place) to turn the
compression effect off.
O PHONES
Connect a set of headphones to this jack. Head-
phones are useful for onstage tuning, or for late-
night practicing.
* When headphones are connected, no sound
will come from the speaker.
OQ POWER
When this switch is set in the upward position,
the power indicator will light and power will be
applied to the unit. When the switch is set in the
downward position, power is off.
REAR PANEL
*HR-2000B
LINECUT
© EFFECT LOOP OUT/IN
(HR-3000B only)
External effect units can be connected to these
terminals.
A signal which has been processed through the
amplifier's compressor and volume control is
delivered via the EFFECT LOOP QUT jack.
Signals returned to the EFFECT LOOP IN jack are
sent to the power amplifier stage via the
equalizer.
External effect units may be connected between
these jacks, or a signal processed by an external
pre-amplifier may be fed to the equalizer and
power amplifier sections via the EFFECT LOOP
IN jack — a wide range of applications is
available.
* HR-30008
EFFECT 1 00P
OUT IN
COMPRESSOR 1INEQUT
FOOT SW.
O COMPRESSOR FOOT SW.
(HR-3000B only)
A Yamaha FC5 or equivalent footswitch can be
connected to this ¡ack to provide foot ON/OFF
switching of the compressor.
@ LINEOUT
The signal which has been processed through the
last-stage power amplifier is delivered at a level
of — 10 dB via this jack. This can be used to send
the amplifier's signal to a second power
amplifier/speaker for increased power, or to line-
feed a mixing console.
SETTING EXAMPLES
1. HEAVY METAL
HR-2000B
BASS AMPLIFIER HR-2000B J 4
1; + E т. ta E a 107 4 a 1 + es
` ? f > # % т 7 и т : # a, : . М X : “3 x : Vo N ©» Е 1
4 | - -_ = =r r= + “o Hz el N
i A . À: A ÿ - J XS Y - i ЗА do NN 3
Ч Ng WF a NA A Ни - Os NI AS ;
, `
HR-3000B
BASS AMPLIFIER HR-30008
a 5
X
y
À
a
This setting has a fat, emphasized midrange. The TREBLE control can be set at about 7”: when
finger-picking to provide better projection.
2. CHOPPER/FUSION
HR-20008
BASS AMPLIFIER HR-20008
BASS AMPLIFIER HR-30008
a 5 =
а 4
ROLE arly
Iu, и da
© 3 ; 7 ©)
ÉL +2
о “o e I
e
< 3
> <
& © SS
This setting produces a natura! sound that is ideal for a broad variety of styles.
SPECIFICATIONS
HR-2000B
HR-3000B
Output Power
30Wr.m.s. {8 ohms, T.H.D.10%)
50Wr.m.s. (8 ohms, T.H.D.10%)
Speaker 25cm x 1 30cm x 1
input Jack INPUT (HIGH GAIN) x 1 INPUT (HIGH GAIN) x 1
EFFECT LOOP IN x 1
Output Jack PHONES x 1 PHONES x 1
LINE OUT x 1 EFFECT LOOP OUT x 1
LINE OUT x 1
External Control — COMPRESSOR FOOT SW. x 1
Terminals
Input Sensitivity
VOLUME) (1kHz)
VOL.
EQ
Noise — 45dB (VOLUME —max., — 30dB (VOLUME »max.,
MASTER VOL.—max.) MASTER VOL. max.)
— 65dB (VOLUME —max., — 60dB (VOLUME —max.,
MASTER VOL. > min.) MASTER VOL. min.)
Controls VOLUME VOLUME
MASTER VOL. MASTER VOL.
BASS (80Hz, + 10dB variable) BASS (BOHz, + 10dB variable)
MIDDLE (B00Hz, + 15dB variable)
TREBLE (2kHz, = 15dB variable)
COMPRESSOR .
MID. FREQ. (200Hz ~ 1kHz)
MID. LEVEL (+ 15dB variable)
TREBLE (2kHz, + 15dB variable)
COMPRESSOR
HR-2000B
HR-3000B
Headphone
Output Power
100mW (impedance 8 ohms)
100mW (impedance 8 ohms)
Line Out Jack
— 10dB
— 10dB
Power
Requirements
U.S. & Canadian
models
General model
120V AC, 60Hz
110V/120V/220V/240V AC,50/60Hz
120V AC, 60Hz
110V/120V/220V/240V AC,50/60Hz
Power Consumption
U.S. & Canadian
models
General model
58W
83W
85W
120W
Size (W x H x D}
385 x 488 x 220mm
(15-1/8'' х 19-1/4''х 8-5/8'')
429x514 x 234mm
{(16-7/8"" x 20-1/4"" x 9-1/4""})
Weight
10kg (221bs. 1025.)
12.6kg (271bs. 120zs.)
* OdB = 0.775 Vr.m.s.
* To improve the product, specifications and appearance are subject to change without notice.
BLOCK DIAGRAM
SCHEMA SYNOPTIQUE
e HR-2000B
EQUALIZER
ondo
© MIDDLE ©
BASS TREBLE
©
e Y MASTER
AMP VOLUME AMP VOLUME
e @ COMPRESSOR | CONTROL SPEAKER
INPUT | (80)
| POWER 7
COMPRESSOR AMP
; [onto
o
+ À | PHONES
—M—o— 4 ®
| LINE OUT
* HR-3000B
— EQUALIZER —
e © 6 ©
MID MID
BASS FREQ. LEVEL TREBLE
o MASTER
VOLUME AMP, VOL. AMP
TH CONTROL + > SPEAKER
(en)
PHONES
©
VT] LINE OUT
— O
|
|
|
|
|
|
|
|
f
|
| — e + OUT
|
| J EFFECT LOOP
©
1
1
{
I
1
COMPRESSOR COMPRESSOR |
ON/OFF
—v in —
IN
vn COMPRESSOR
1 FOOT SW.
©
14
Printed in Japan
==: €) YAMAHA
HAMAMATSU, JAPAN
SERVICE
The HR-2000B/HR-3000B are supported by Yamaha's
worldwide network of factory trained and qualified
dealer service personnel. In the event of a problem,
contact your nearest Yamaha dealer.
SERVICE APRES-VENTE
Le HR-2000B/HR-3000B est supporté par un réseau
mondial de services apresvente Y amaha animés par
un personnel de vente et des techniciens dépanneurs
qualifiés et formés en usine. N'hésitez pas a vous en
remettre au distributeur Yamaha le plus proche de
votre domicile en cas de doute ou de panne.
PSQXK50176
F0587P1097
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising