FP-59 1991-Newer Ford Crown Victoria Police Interceptor 07/09

FP-59 1991-Newer Ford Crown Victoria Police Interceptor 07/09
07/09
FP-59
1991-Newer Ford Crown Victoria
Police Interceptor
Installation Instructions
The FP-59 (Ford Police Interceptor base) is a no-holes passenger side base. The base consists of two main
components: a base and an adjustable upper tube assembly. Installing a no-holes base does not require drilling
any holes into the vehicle.
Installing the FP-59 Base in the vehicle:
1. Place the passenger seat in its most rearward position- Remove the hardware that fastens the seat
brackets to the vehicle floor pan.
2. Place the mount in the passenger foot well with the slotted mounting holes positioned towards the seat and
the pole next to the transmission hump.
3. Tilt the seat back and slide the base in between the seat bracket and the vehicle floor pan. Make sure to
line up the holes in the base with the seat bracket holes.
4. Re-install the seat bracket hardware removed in step 1 and tighten- The base should now be held firmly in
position.
Installing the head and adjusting the mount:
1. If not already done, install the head or rack on the base following the instructions furnished with the head or
rack.
2. Loosen the bolt at the top of the post one turn. If necessary, tap the top of the bolt until the upper part of the
tube assembly moves freely within the lower part.
3. Adjust the assembly to the desired height, point the post top plate directly towards the back of the car, and
tighten the bolt.
4. Pivot and tilt the head to all possible positions (see instructions for head) and check for comfortable reach
and clearance with the dash and other obstructions and adjust if necessary.
Product Mounting Disclaimer
Lund Industries, Inc. is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or
consequential damages for personal injury or other damage of any nature arising directly or indirectly as a result of the improper installation or
use of its products in vehicle or any other application. In order to safely install and use Lund Industries, Inc. products full consideration of vehicle
occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety
equipment is required. Lund Industries, Inc. specifically disclaims any responsibility for the improper use or installation of its products not
consistent with the original vehicle manufactures specifications and recommendations, Lund Industries, Inc. product instruction sheets.
Specialists in Emergency Vehicle Products Since 1978 Design, Manufacturing, Distribution & Installation
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement