EverFocus | M099-VDE101-002 | Specifications | EverFocus M099-VDE101-002 Specifications

EverFocus M099-VDE101-002 Specifications
M099-VDE101-002
HIGH RESOLUTION
VANDAL DOME CAMERA
O P E R AT I ON M ANUAL
Thank you for choosing our high quality camera.
Before attempting to connect operate this unit, please read and follow these instructions.
CONTENTS
1 . Cau ti o ns
2 . F eatu re s
3 . P ackag e
4 . O vervi ew and func tion
5 . I n stal l ation
6 . Co n n ection
7 . Dimen sions
8 . S p ecific ations
9 . O S D Menu Str uc tur e
3
1. CAUTIONS
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions;
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.
Note
This equipment has been tested and found to comply with limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio / tv technician for help.
Caution
Any changes or modifications in construction of this device which are not expressly
approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
1. A regulated DC12V 1A power supply is recommended for use with this camera
for the best picture and the most stable operation.
An unregulated power supply can cause damage to the camera.
When unregulated power supply is applied, product warranty will be out of subject.
2. It is recommended that the camera is used with a monitor that has a CCTV quality
75 video impedance level.
If your monitor is switched to high impedance then please adjust accordingly.
3. Do not attempt to disassemble the camera to gain access to the internal componets.
Refer servicing to your dealer.
4. Never face the camera towards the sun or any bright or reflective light, which may
cause smear on the picture and possible damage to the CCD.
5. Do not remove the serial sticker for the warranty service.
6. Do not expose the camera to rain or other types of liquid.
7. The apparatus must be connected to a mains socket-outlet with a protective earthing
connection.
4
1. CAUTIONS
Correct Disposal of This Product
(Waste Electrical & Electronic Equipment)
(Applicable in the European Union and other European countries with
separate collection systems)
This marking shown on the product or its literature, indicate that it should not
be disposed with other household wastes at the end of its working life. To
prevent possible harm to the environment or human health from uncontrolled
waste disposal, please separate this from other types of wastes and recycle it
responsibly to promote the sustainable reuse of material resources.
This product should not be mixed with other commercial wastes purchased this
product, or their local government office, for details of where and how they can
take item for environmentally safe recycling.
Business users should contact their supplier and check the terms and
conditions of the purchase contract.
Household users should contact either the retailer where they for disposal.
5
2.Featur es
• 1/3 960H SONY EXview HAD CCD II
• High Resolution of 700TV Lines
• OSD Function
• Multi Language
(ENGLISH / JAPANESE / GERMAN / FRENCH / RUSSIAN / PORTUGUESE / SPANISH / CHINESE)
• 2DNR
• Privacy Zone
• Motion Detect
• DC12V / AC24V Dual Voltage
• ATR(Adaptive Tone-curve Reproduction / Digital WDR)
The function provides gradation compensation to improve the contrast of subjects both
low-luminance areas and high luminance areas exist in the same picture
• 3-Axis Gimbal
Pan Rotation
Tilt Rotation
Horizontal Rotation
CAUTION panning the bracket in excess of 3 rotations in one direction maycause damage to the cable.
• Service Video connector
The Service Video Connector also provides the installer with an easy way of configuring the
camera.
6
3.Packa ge
1
VANDAL DOME CAMERA
2
SURFACE MOUNT
3
VIDEO OUTPUT TEST CABLE
4
OPERATION MANUAL
5
SCREW(M4x10) - 4ea
SCREW(5x30) - 4ea
SCREW(M4x40.SUS) - 4ea
L WRENCH - T20
6
MOUNT GUIDE
7
4.Over view and function
• Name (LED Type)
• CONTROL FUNCTION
(OSD JOYSTICK)
LEFT
• Name (Standard)
UP
RIGHT
MENU
DOWN
8
5. Installation
Mount Guide
LED Type
9
Standard Type
5. Installation
1. Installation of Flush Mount
① Installation of the camera with SURFACE
CASE(using M4x40)
② Installation of the camera with SCREWS
③ Installation of the camera with JUNCTION BOX
PIPE
2. Installation of Surface Mount
PIPE
① Installation of the camera on the wall
② Installation of the camera on the 3/4” NPT PIPE
③ Installation of the camera on the JUNCTION BOX
NOTE
Check the safe wire which
should be entirely inserted into camera
housing during locking the dome cover to
maintain Waterproof condition.
10
When using the camera
without LED take off the rubber.
6.Connection
• DUAL(DC 12V/AC24V)
• DC 12V
When you install the camera, please glue up the end of cable to
keep it stable in order to protect the camera from the humidity problems.
11
7.Dimensions
Unit : mm
Surface Mount Type
Type A
Type B
Flush Mount Type
45˚
70˚
Standard Type
LED Type
When you fix the focus around 22.0mm in f9.0-22.0mm Varifocal lens, please
set short distance focus approximately 3M and do not set long distance focus
12
8.Specifications
Signal Format
NTSC
Image Device
PAL
1/3˝ 960H SONY EXview HAD CCD II
Scanning System
2:1 Interlace
H.Resolution
700TV Lines
H:15.734KHz, V:59.94Hz
H:15.625KHz, V:50Hz
Total Pixels
Scanning Frequency
1020(H) X 508(V)
1020(H) X 596(V)
Effective Pixels
976(H) X 494(V)
976(H) X 582(V)
1/60 sec
1/50 sec
Electronic Shutter Speed
S/N Ratio
More than 50dB(AGC Off)
Gamma
r=0.45
Min. Illumination
COLOR : 0.05Lux/F1.2, BW : 0.02 Lux/F1.2
Sync System
Internal
Video Output
1.0 Vp-p Composite(75Ω)
OSD
Built in (Inner Key / Joystick)
BLC
OFF / BLC / HLC
White Balance
ATW / PUSH / USER1 / USER2 / ANTI CR / MANUAL / PUSH-LOCK
2DNR
OFF / ON (Level adjustable)
ATR
OFF / ON (Level adjustable)
Function
MIRROR / BRIGHTNESS / CONTRAST / SHARPNESS / HUE / GAIN
Privacy Masking
4 Zones
Motion Detection
4 Zones
Day & Night
AUTO
ENGLISH / JAPANESE / GERMAN / FRENCH / RUSSIAN/
PORTUGUESE / SPANISH / CHINESE
Language
IP Rating
Power
Consumption
IP66 (Weatherproof)
DC12V
Dual
DC 12V (±10%) Max.120mA
DC 12V (±10%) Max.150mA , AC 24V (±10%) Max. 2.3W
Operating Temperature
-10℃ ~ +50℃
Storage Temperature
-20℃ ~ +60℃
Operating Humidity
Less than 80%
Options
Dual Power, Fan
• Surface Mount Type A : Approx. 1.38kg / Type B : Approx. 1.1kg
• Flush type : Approx. 730g
Weight
Dimension(mm)
143.0(Φ) x 104.0(mm)
LED TYPE
Power
Consumption
DC12V
Dual
DC 12V (±10%) Max. 360mA
DC 12V (±10%) Max 430mA , AC 24V (±10%) Max. 5.2W
Min. Illumination
0 Lux (IR LED ON)
IR LED
850nm, 30ea
IR Beam Range
Up to 30M
IR LED Operation
On : 1 Lux, Off : 3 Lux
Specifications and designs are subject to change for improving the functionality of this product without notice.
13
9. OSD MENU STRUCTURE
MAIN
MENU
1st Sub
MENU
2nd Sub
MENU
3rd Sub
MENU
4th Sub
MENU
MANUAL
LE NS
AUTO
T YPE
DC
M ODE
AUTO,OPE N ,C LOS E
SPEED
( 0 00 ~ 255)
RET URN
HIGH L UM INANCE
AUTO
L OW L UM INANCE
M OD E
SHUT,AUTO IRIS, SHUT+AUTO IRIS
BRIGH TN E S S
(000 ~ 255)
M OD E
A GC ,OFF
BRIGH TN E S S
x0.25,x0.50,x0.75,x1.00
RET URN
S HU T T ER
/ AGC
MANUAL
M ODE
SHU T+A GC
SHUT T ER
1 /50(PA L),1/100(N TS C )
1 /60(N TSC ),1/120(P A L)
1 /250,1/500,1/1000
1 /2000,1/4000,1/10000
AGC
6 ,12,18,24,30,36,42,44.8
RET URN
ATW
SPEED
( 0 00 ~ 255)
DEL AY CNT
( 0 00 ~ 255)
AT W F RAM E
x0 .50,x1.00,x1.50,x2.00
ENVIRONM ENT
IND OOR ,OU TD OOR
RET URN
PUSH
WH I T E
BA L
USER1
B- GAIN
( 0 00 ~ 255)
R- GAIN
( 0 00 ~ 255)
RET URN
USER2
B- GAIN
( 0 00 ~ 255)
R- GAIN
( 0 00 ~ 255)
RET URN
ANTI CR
MANUAL
L EVEL
2 4 ~ 103
RET URN
PUSH LOC K
BACK LIGHT OFF,BLC,H LC
P IC
A D JUS T
MIRROR
OF F ,ON
BRIGHTNE SS
(000 ~ 255)
CONTRAS T
(000 ~ 255)
SHARPNESS
(000 ~ 255)
HUE
(000 ~ 255)
GAIN
(000 ~ 255)
RETURN
ATR
ON
L UM INANCE
LOW,MID ,H IGH
CONT RAST
LOW,MIDLOW,MID,MIDHIGH,HIGH
RET URN
OFF
*SH UT+ I RI S : Both the Shutter and the Mechanical Iris are automatically adjusted according to brightness.
*Auto Iris(Default): The Shutter stays at the manually selected value and only the Mechanical Iris adjusts to brightness.
14
9. OSD MENU STRUCTURE
MAIN
MENU
1st Sub
MENU
2nd Sub
MENU
3rd Sub
MENU
DETECT SENSE
( 000 ~ 255)
BLO CK DI SP
OFF,ON,ENABLE (CONTROLER)
M O NI TO R AREA
ON ,OFF
4th Sub
MENU
1/4, 2/4, 3/4, 4/4
MO T I O N
DE T
ON
AREA SEL
TOP
NTSC:(000 ~ 244) / PAL: (000 ~ 288)
BOTTOM
NTSC:(000 ~ 244) / PAL: (000 ~ 288)
LEFT
NTSC:(000 ~ 474) / PAL: (000 ~ 468)
RIGH T
NTSC:(000 ~ 474) / PAL: (000 ~ 468)
RETURN
OFF
NEXT
E X IT
S A V E ALL
1/4, 2/4, 3/4, 4/4
AREA SEL
P RIV A CY
ON
TOP
NTSC:(000 ~ 244) / PAL: (000 ~ 288)
BOTTOM
NTSC:(000 ~ 244) / PAL: (000 ~ 288)
LEFT
NTSC:(000 ~ 474) / PAL: (000 ~ 468)
RIGH T
NTSC:(000 ~ 474) / PAL: (000 ~ 468)
CO LO R
( 1 ~ 8)
TRANSP
0.00, 0.50, 0.75, 1.00
M O SAI C
OFF,ON
RETURN
OFF
NR
NR MODE
O FF, Y, C, Y/ C
C LEVEL
( 000 ~ 015)
Y LEVEL
( 000 ~ 015)
RETURN
C A ME RA
ID
LANGUAGE
ON
EDI T M O DE
RETURN
OFF
ENGLISH , 日 本 語, DEUTSCH, FRANCA I S , Р у с с к и й , P O R T U G U Ê S , E S P A Ñ O L , 中 文
CAMERA
RESET
BACK
EXIT
SAVE ALL
*Important Note :
- A ny c h an ge s ma de to t he c am er a s et t ings m us t be s a v e d p r i o r t o e x i t i n g t h e O S D m e n u .
E lse all cha ng es will be dis c ar ded.
- B y ch a ng ing the len s opt ion in t he O SD f r om M ANU A L t o A U T O w i l l a u t o m a t i c a l l y c h a n g e t h e
S H UTTER/AGC settin g f r om AUTO I RI S t o SHUT+ A U T O I R I S . ( D e f a u l t : A U T O I R I S )
15
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising