Methven Kiri System Drencher shower system Installation guide

Below you will find brief information for Kiri System Drencher. The Kiri System Drencher is a shower system that comes with a fixed overhead shower and a handheld shower head. It can be installed on a wall and has a minimum height of 1800mm from the floor level. For best performance, the system requires a minimum pressure of 150 kPa and a maximum pressure of 500 kPa. The system also has a maximum operating temperature of 70°C.

PDF

Document

KIRI SYSTEM DRENCHER
INSTALLATION GUIDE
TECHNICAL SPECIFICATIONS
Operating Pressure:
Min 150 kPa, Max 500 kPa.
Recommended installation of a pressure limiting
valve if supply exceeds 500 kPa.
Operating Temperature:
Max 70˚C
NB: New Zealand building code clause G12 - water
supplies specifies all outlets used primarily for
personal hygiene shall deliver water at a safe
temperature.
Methven warrants this product against manufacturing defects and that it is suitable for use
under the operating conditions specified in this instruction sheet.
For your warranty please refer to www.methven.com or call Customer Service: 0800 804 222
433232
Issue B
1.
2.
4.
3.
RECOMMENDED MINIMUM HEIGHT 1800mm FROM
FLOOR LEVEL
Top Rail
Connector
Top Rail
Connector
m
Min 10m
800mm
Max
○ 25mm
Top Rail
Bracket
Bottom Rail
Connector
Bottom Rail
Bracket
Install a &frac12;&quot; male threaded connection at the desired
height on wall, ensuring that a minimum of 10mm of
thread protrudes past the finished wall.
Apply thread tape (or similar) to the &frac12;&quot; connection,
then screw the top rail connector to the connection.
5.
6.
Screw the bottom rail connector to a wall stud
making sure it is vertically in line with the top rail
connector. Maximum centre distance between the
top and bottom shower connections is 800mm.
CLEANING
Water contains lime which remains on the surface
after the water has evaporated. These lime deposits
can be prevented from forming by wiping
immediately after use.
Filter Washer
Check the grub screws are wound out. Push the rail
brackets onto the top and bottom rail connectors
until they are against wall. Secure with grub screws.
To clean the chrome-plated surfaces use a soft
cloth, soap and warm water. Never use cleaning
agents that contain a corrosive acid or a scouring
additive.
Backflow
Prevention
Device
Ball Joint
Clean filter washer
periodically.
Do not use any
sharp objects to
clean nozzles
Remove the protective cap from the showerhead ball
joint and screw the unit onto the overhead arm
ensuring the filter washer is in place.
Make sure a washer is in both ends of the hose.
Screw hose onto lower outlet on wet rail, attach
handset and place firmly in holder. Tilt and rotate
head to the desired position.
NOTE: Removal of the flow restrictor in the ball joint may be necessary to optimise flow performance
in low or unequal pressure systems only.
">

Hello! I am an AI chatbot specifically trained to assist you with the Methven Kiri System Drencher Installation Guide. I have thoroughly reviewed the document and can help you locate the exact information you need or explain the content in clear and simple terms. Whether you’re looking for guidance on specific features, troubleshooting steps, or general usage, feel free to ask your questions. The more details you provide about your concerns or needs, the more accurately and effectively I can assist you!

Show related prompts