50108 | Manualzz

Trim Ring
Product Installation Drawing
Document Number: 50108 Rev: B
ECN: 95-076 4/26/95
This Product Installation Drawing is to be used for installing the following Trim Ring Model
Numbers:
TR-A3N, TR-B3N, TR-C3N, TR-D3N and TR-ABS4DN.
The trim ring consists of eight pieces:
ü Top and bottom pieces which are symmetrical.
ü Left and right pieces which are symmetrical.
ü Four corner pieces which are identical.
No hardware is needed for securing the trim ring. It's made of a grey molded plastic with an
adhesive backing.
Installation Instructions
Top
0.75 Typ.
Sides
The top and the two sides should be
put together first. Take one of the
four corner pieces, and laying it over
the top and side tab, press into place.
Do the same for the other corner.
Then peel the plastic strip off the
back, and press the adhesive backing to the wall, lining up the trim
ring over the box. Mount bottom
piece to the wall at bottom of box,
then apply corner pieces.
The distance from the front of the
box to the face of the wall should
be at least two inches, to allow room
for the key to fit in once the trim
ring is installed.
Bottom

Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project