User manual | Installation instructions for linear LED modules

Installation instructions for linear LED modules
The following instructions demonstrate how easy it is to install linear LED modules.*
Product overview
The following products are required for the installation of
linear LED modules:
• LINEARlight module
• Matching OPTOTRONIC control gear
• Feeder: CONNECTsystem
• End caps (one for the input side and one for the
output side)
• Mounting clips
Instructions
1.
Connect the feeder with the module. Attention: The
cable on the connector at the end of the feeder has to
point upward.
2.
Attach the optional end cap (accessory) with
OSRAM stamp to get the strain relief function
on the input side.
3.
Attach the optional end cap (accessory) without
OSRAM stamp in order to finish the module and to
get the strain relief function for the connecting cables.
4.
Open the cap of the control gear.
*Please observe the safety and mounting information specified in the product data sheets.
1
4.
Connect the power supply cables (observe correct
polarity) and close the cap.
5.
Completed system with mounting clips for easy installation on walls or ceilings.
2

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project