FIMCO LG-40-SS 40 Gallon, Skid-Mounted Sprayer Assembly / Operation Instructions / Parts

Below you will find brief information for Sprayer LG-40-SS 40 Gallon, Skid-Mounted. The Sprayer LG-40-SS 40 Gallon, Skid-Mounted is a powerful 40 gallon sprayer equipped with a 12-volt diaphragm pump, adjustable pressure range, and a 25-foot handgun hose. It's ideal for a range of applications, including weed control, pest management, and fertilizing. The sprayer comes fully assembled and features a pressure switch for automatic shut-off at 45 PSI.

PDF Download

Document

5301335

MODEL: LG-40-SS

40 Gallon, Skid-Mounted Sprayer

ASSEMBLY / OPERATION INSTRUCTIONS / PARTS

BEFORE RETURNING THIS PRODUCT

FOR ANY REASON, PLEASE CALL

1-800-831-0027

IF YOU SHOULD HAVE A QUESTION OR

EXPERIENCE A PROBLEM WITH YOUR

FIMCO INDUSTRIES PRODUCT:

1-800-831-0027

BEFORE YOU CALL, PLEASE HAVE THE

FOLLOWING INFORMATION AVAILABLE:

SALES RECEIPT & MODEL NUMBER. IN MOST

CASES, A FIMCO INDUSTRIES EMPLOYEE CAN

RESOLVE THE PROBLEM OVER THE PHONE.

Your authorized dealer is the best source of replacement parts and service. To obtain prompt, efficient service, always remember to give the following information.

1. Correct part description and part number.

2. Model number of your sprayer.

3. Serial number of your sprayer.

Part number and descriptions can be obtained from the illustrated parts list section of this manual. Whenever you need parts or repair service, contact your distributor / dealer first. For warranty work always take your original sales slip, or other evidence of purchase date, to your distributor

/ dealer.

TECHNICAL SPECIFICATIONS

• 40 Gallon Polyethylene Tank

• 12 Volt Diaphragm Pump - 3.8 G.P.M.

• Adjustable Pressure Range 0 - 45 P.S.I.

• 25 Foot Handgun Hose

• Pistol Grip Handgun

• Suction Line Filter

ASSEMBLY

The sprayer is fully assembled at the factory. Hook up the wiring to an existing 12 volt power source. The red wire of the two wire set must be connected to the positive post on the battery or the “Hot” connection on a switch or to the ammeter. The brown wire may be grounded or connected to the negative battery post.

OPERATION

GENERAL INFORMATION

The purpose of this manual is to assist you in operating your sprayer. Please read it carefully as it furnishes information which will help you operate and maintain your sprayer.

WARNING

DO NOT USE PUMP IN AN EXPLOSIVE

ENVIRONMENT. DO NOT USE TO PUMP

FLAMMABLE FLUIDS, GASOLINE,

KEROSENE FUEL, OIL, ETC.

WARRANTY / PARTS / SERVICE

Products are warranted for one year from date of purchase against manufacturer or workmanship defects.

The pump on the sprayer is factory set to shut off automatically at a maximum of 45 PSI. The handgun may be shut off at any time when the pump is running. The pump will shut off when there is no discharge from the handgun.

The pumping system draws solution from the tank and to the pump. The pump forces the solution under pressure to the handgun.

w w w . F I M C O I N D U S T R I E S . C O M

1000 FIMCO LANE • P.O. BOX 1700 • NO. SIOUX CITY, SD 57049

TOLL FREE: 800-831-0027 • TOLL FREE FAX: 800-494-0440

Form No. 850 (5004623 6/07) Printed In U.S.A.

It is important to test the sprayer with plain water before attempting actual spraying. This will enable you to check the sprayer for leaks in the plumbing system.

1. Open tank lid and be sure the tank is clean and free of foreign material. Fill the tank about half full with plain water.

wARNING: Some chemicals will damage the pump valves if allowed to soak untreated for a length of time. Always flush the pump after use. Do not allow chemicals to sit in pump for extended times of idleness. Follow chemical manufacturers instructions on disposal of all waste water from the sprayer.

CAUTION

PRESSURE SWITCH OPERATION

Pressure switch is pre-set at the factory. Improper adjustment of the pressure switch, may cause severe overload or premature failure. If the pump is subjected to rapid cycling during normal operation, or infrequent periods, damage may occur.

AFTER SPRAYING

Refill the tank about half full with plain water and use a chemical neutralizer such as NUTRA-SOL or equivalent and repeat cleaning instructions above. Flush the entire sprayer with the neutralizing agent. Follow the chemical manufacturers disposal instructions of all wash and rinsing water.

WINTER STORAGE

Drain all water out of the sprayer paying special attention to pump, valves, and spray gun. These items are especially prone to damage from chemicals and freezing weather.

The sprayer should be winterized before storage by pumping a solution of RV anti-freeze through the entire plumbing. Proper care and maintenance will prolong the life of the sprayer.

Page 2

Page 3

Hello! I am an AI chatbot specifically trained to assist you with the LG-40-SS 40 Gallon, Skid-Mounted Sprayer Assembly / Operation Instructions / Parts. I have thoroughly reviewed the document and can help you locate the exact information you need or explain the content in clear and simple terms. Whether you’re looking for guidance on specific features, troubleshooting steps, or general usage, feel free to ask your questions. The more details you provide about your concerns or needs, the more accurately and effectively I can assist you!

Show related prompts

Assistant typing

Assistant terminated

Key features

40 Gallon Polyethylene Tank
12 Volt Diaphragm Pump - 3.8 G.P.M.
Adjustable Pressure Range 0 - 45 P.S.I.
25 Foot Handgun Hose
Pistol Grip Handgun
Suction Line Filter
Automatic shut-off at 45 PSI
Easy assembly

Frequently asked questions

Connect the red wire of the two-wire set to the positive post on the battery or the “Hot” connection on a switch or to the ammeter. The brown wire may be grounded or connected to the negative battery post.

After use, fill the sprayer part way with water, start the sprayer and allow clear water to be pumped through the plumbing system and out through the handgun. Use the handgun to thoroughly wash all internal parts of tank and tank cover. Refill the tank about half full with plain water and use a chemical neutralizer such as NUTRA-SOL or equivalent and repeat cleaning instructions above. Flush the entire sprayer with the neutralizing agent. Follow the chemical manufacturers disposal instructions of all wash and rinsing water.

Drain all water out of the sprayer paying special attention to pump, valves, and spray gun. These items are especially prone to damage from chemicals and freezing weather. The sprayer should be winterized before storage by pumping a solution of RV anti-freeze through the entire plumbing. Proper care and maintenance will prolong the life of the sprayer.