Universal Tool UT8748E angle cut-off tool User manual

Below you will find brief information for angle cut-off tool UT8748E. The angle cut-off tool UT8748E is designed to operate on 90 PSIG. Lower pressure (below 90 PSIG) will reduce performance of the tool. Higher air pressure (over 90 PSIG) raises the performance of the tool beyond its rated capacity and could cause serious damage to the tool and the user. This angle cut-off tool is designed to be used with a cutting wheel, which is installed on the spindle of the tool. To use the tool, you must first connect it to an air supply, and then engage the throttle lever.

PDF Download
Document
Angle Cut-Off Tool UT8748E User Manual | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • 4-in. extended angle
  • 1.0 HP motor
  • 17,000 RPM
  • rear exhaust
  • safety lock-off mechanism
  • cutting wheel installation
  • tool lubrication process
  • troubleshooting guide
  • limited warranty information
  • service parts and exploded view drawing

Frequently asked questions

First, disconnect the tool from the air supply. Then, remove the screws and flange nut with the 4 MM hex wrench and 17 MM spanner. Mount the cutting wheel on the spindle. Replace the flange nut and re-tighten the screw using the 4 MM hex wrench and 17 MM spanner.

The angle cut-off tool is designed to operate on 90 PSIG. Lower pressure (below 90 PSIG) will reduce performance of the tool. Higher air pressure (over 90 PSIG) raises the performance of the tool beyond its rated capacity and could cause serious damage to the tool and the user.

Recommended lubricants: Air tool oil or any other high grade turbine oil containing moisture absorbent, rust inhibitors, metal wetting agents, and an EP (extreme pressure) additive.
Preparing document for printing…
0%