Condair JetSpray JS60, JS600, JS600DS, JS600M Atomising Nozzle System Technical Manual

The JetSpray JS60, JS600, JS600DS and JS600M Atomising Nozzle Systems are designed for direct air, or in-duct humidification in industrial applications. Each system is pre-commissioned at the factory and every control panel includes PureFlo Ag+ with Argentosan™ for hygienic humidification. The systems use air and water under pressure to produce finely atomised sprays which rapidly evaporate to raise the relative humidity to the desired level. Operation is fully automatic and regulated by a humidity sensor, humidistat or external controls. The system is designed for use with potable mains or treated water and is completely sealed and with no open tanks, ensuring freedom from contamination and a healthy working environment.

PDF Download
Document
JetSpray JS60, JS600, JS600DS, JS600M Technical Manual | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Direct air or in-duct humidification
  • Pre-commissioned at factory
  • PureFlo Ag+ with Argentosan™ for hygiene
  • Fully automatic operation
  • Potable mains or treated water
  • Sealed system with no open tanks
  • Modulating control (JS600M only)

Frequently asked questions

The PureFlo Ag+ cartridge uses silver to inhibit the growth of bacteria, moulds and fungi in the water supply.

Refer to the cleaning and disinfection instructions in this manual.

The JS60, JS600 and JS600DS models have a fixed output, while the JS600M model has a modulating output.

The maximum output of the JS60 is 60l/h, the maximum output of the JS600, JS600DS and JS600M is 600l/h.

The JetSpray system requires a clean, potable mains water supply with a pressure of 4 - 7 Bar (58 - 102 PSI) and a temperature of 20 Degrees Centigrade or less.
Preparing document for printing…
0%