Cross Technologies 2017-02A Up+Downconverter, 70 MHz 950-2150 MHz (for L-Band Modems) Data Sheet

Below you will find brief information for L-band Up/Downconverter 2017-02A Up/Downconverter. This device converts 70 MHz to 950-2150 MHz (Up) and 950-2150 MHz to 70 MHz (Down) in 1 MHz steps with low group delay and flat frequency response. The 2017-02A has lower RF level out of the upconverter and higher RF level into the downconverter than the 2017-02 and is typically used to interface an L-band modem to a 70 MHz IF upconverter and downconverter. It features a multifunction push button switches to select RF frequency, gain and other parameters. The device also includes front panel LEDs that provide indication of DC power (green), PLL alarm for up and downconverters (red), remote operation (yellow), and Upconverter mute (yellow). Gain can be manually adjusted over a -25 to +15 dB range for the upconverter and over a 0 to +50 dB range for the downconverter by the front panel multifunction push-button switches. Remote operation allows selection of frequency and gain. Parameter selection and frequency and gain settings appear on the LCD display. Connectors are BNC female for IF and the optional external reference input and output, and Type F female for RF. A high stability (±0.01ppm) option is also available. It is powered by a 100-240 ± 10% VAC power supply and housed in a 1.75” X 19” X 16” 1RU chassis.

PDF Download
Document
L-band Up/Downconverter 2017-02A Up/Downconverter Datasheet | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Converts 70 MHz to 950-2150 MHz (Up) and 950-2150 MHz to 70 MHz (Down)
  • Low group delay and flat frequency response
  • Multifunction push button switches for RF frequency, gain and other parameters selection
  • Front panel LEDs for power, alarm, remote operation and mute indication
  • Gain can be manually adjusted
  • Remote operation for frequency and gain selection
  • BNC female for IF and Type F for RF connectors
  • High stability (±0.01ppm) option available
  • Powered by 100-240 ± 10% VAC power supply

Frequently asked questions

The upconverter converts 70 MHz to 950-2150 MHz.

The downconverter converts 950-2150 MHz to 70 MHz.

The frequency step size is 1 MHz.

You can select the RF frequency, gain, and other parameters using the front panel multifunction push-button switches, or remotely.

The IF connectors are BNC female, and the RF connectors are Type F female.

The device requires a 100-240 ± 10% VAC power supply.
Preparing document for printing…
0%