Replacement Flex Drive on Grain Boxes (60850)
SRT-2 Flex Drive and Handle Assembly
NOTICE INSTALLER: USE THESE INSTRUCTIONS TO REPLACE BOLT-ON FLEX DRIVE TO HANDLE
AND TO REPLACE FLEX DRIVES WELDED TO HANDLE
WHEN FLEX DRIVE AND HANDLE ARE BOTH PREPPED FOR BOLT-ON ASSEMBLY:
Tools: 1/2’’ Wrench (2), Torque Wrench Ft. lb.
with 1/2” Socket
BOLT
1) Slide open end of flex drive onto open end of handle.
Align holes.
2) Insert bolt through handle, turn nut on and tighten.
See diagram A.
LOCK NUT
3) Torque bolt to 19 ft. lbs.
Diagram A
TO CONVERT AN EXISTING WELDED-ON FLEX DRIVE TO A BOLT-ON ASSEMBLY:
NOTE: The purpose of the cutting and grinding procedure is to keep the integrity of the handle intact by allowing the new
hole to be drilled through a double layer of metal (inside the end of the handle) for the bolted connection.
Tools: Protective Eyewear, Metal Hand Saw, Metal Grinding Tool, Drill with 5/16” Drill Bit, 1/2” Wrench (2),
Torque Wrench Ft. lb. with 1/2” Socket
MAKE SAW CUT IN
CENTER OF HEX
HEAD FITTING
EXISTING FLEX
DRIVE WELDED
TO HANDLE
90°
ALIGN HOLE
WITH CENTER OF
FLAT SURFACE
ON HANDLE
HEX HEAD FITTING
REPLACEMENT FLEX
DRIVE
90°
HANDLE
Diagram B
Diagram C
1) Cut existing flex drive off handle.
2) Grind weld and fitting flush with
Cut should be in center of hex shaped
handle until new flex drive slides
fitting and square with handle.
fully onto handle.
(For best results, leave enough weld
to secure existing hose fitting inside
handle.)
Part No. 60850_
5/16” BIT
HEX FITTING AND WELD
GROUND FLUSH WITH
HANDLE
Diagram D
3) Use hole in new flex drive as guide,
align it with flat surface of handle and
drill 5/16” hole. Insert bolt and tighten
with nut. See Diagram A above. Then
torque bolt to 19 ft. lbs.
Copyright 2009 AGRI-COVER, INC. ALL RIGHTS RESERVED
122309
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement