MuxLab HD CCTV Pass-Thru Balun Datasheet

HD CCTV Pass-Thru Balun with Cable Leads

(500720-CL)

Overview

The HD CCTV Pass-Thru Balun with Cable

Leads (500720-CL) allows one HD CCTV (HD-

SDI) video channel plus remote power and PTZ control to be transmitted between the HD CCTV camera and the DVR via Cat5e/6 cable in the HD

CCTV environment. The 500720-CL is used in conjunction with either another 500720-CL or in conjunction with the 500700 or 500721.

Applications

Campus, highways, airports, hotels, casinos, commercial complexes, remote parking lots, selfstorage, hospitals, car dealerships.

Specifications

Environment

Signal transmission

Devices

Standard supported

Compatible baluns

Speed

Insertion Loss per balun

Connectors

Maximum distance

Features

HD-SDI video, power and PTZ over one Cat5e/6

Supports SD & HD (720p, 1080i)

Works in pairs or with 500720 or 500721

Supports Cat5e/6 cable

HD CCTV; SDI single link : SD & HD

Signal: SDI (no analog),

Power: 12VDC or 24VAC 2A max,

Control signal: any signal using a balanced pair, 1A max.

HD-SDI CCTV cameras, monitors, DVR HD CCTV equipment.

SD (270 Mb/s): SMPTE 259M (480i, 576i)

HD (1.485 Gb/s):: SMPTE 292M (720p, 1080i)

500720, 500720-CL, 500721

270Mb/s & 1.485Gb/s

<6 dB: 5 – 1 000 MHz.

One BNC 75 ohm male cable lead

One 2-wire cable lead for remote power

One 2-wire cable lead for PTZ control

One RJ45S for Cat 5e/6 unshielded or shielded twisted pair.

When used with another 500720 or 500720-CL

SD: 120m (400ft) for CAT 5E UTP

150m (500ft) for CAT 6 UTP

HD (720p, 1080i): 45m (150ft) using Cat 5E UTP

45m (150ft) for CAT 6 UTP

Remote Power

Cable – UTP

Cable – Coax

When used with 500721:

SD: 150m (500ft) for CAT 5E UTP

150m (500ft) for CAT 6 UTP

HD (720p, 1080i): 45m (150ft) using Cat 5E U TP

.

45m (150ft) for CAT 6 UTP

Note: Maximum distance is dependent on the receiving equipment. Dedicated

Cat5E/6 cables are recommended with no patch panels

Supports up to 20VA/2A via two (2) twisted pairs

Supports up to 30VA/2A via three (3) twisted pairs

Maximum voltage: 28V

24 gauge or lower solid copper twisted pair wire. Impedance: 100 ohms at 1 MHz

Maximum capacitance: 20 pf/foot. Attenuation: 6.6 dB/1000 ft at 1 MHz

Impedance: 75 Ω at 1 MHz. (RG59/U)

 MuxLab 2014 HD CCTV Pass-Thru Balun with Cable Leads

Head Office

8495 Dalton Road, Mount Royal, Quebec, H4T 1V5

Tel: (+1) 514-905-0588 Fax: (+1) 514-905-0589

Toll Free: 877 689-5228 URL:www.muxlab.com

E-mail: [email protected]

HD CCTV Pass-Thru Balun with Cable Leads

(500720-CL)

RJ45 Pin Configuration

*Reverse polarity sensitive if 12VDC camera is used

Connectors

Temperature

Humidity

Enclosure

Dimensions

Weight

Regulatory

Warranty

Order Information

Typical Applications

Signal

Power A (+) *

RJ45 pin

1, 3

Power B (-) *

Control (+)

Control (-)

SDI Video BNC Center (Tip)

SDI Video BNC Ground (Ring)

5

7

8

2, 6

4

Video: BNC-M

PTZ: 2-wire cable lead

Remote Power: 2-wire cable lead

Cat5e/6 Link: RJ45S

Operating: -40° to 60°C (-40° to 140°F) Storage: -40° to 85°C (-40° to 185°F)

Maximum 95% (non-condensing)

Cast Aluminum

2 x 2.6 x 4.7 cm (0.8” x 1.85” x 1.05”) excluding cables

2 oz (60g)

FCC and CE.

Lifetime

500720-CL HD CCTV Pass-Thru Balun with Cable Leads

 MuxLab 2014 HD CCTV Pass-Thru Balun with Cable Leads

Head Office

8495 Dalton Road, Mount Royal, Quebec, H4T 1V5

Tel: (+1) 514-905-0588 Fax: (+1) 514-905-0589

Toll Free: 877 689-5228 URL:www.muxlab.com

E-mail: [email protected]