42004-730L2BQG

42004-730L2BQG
Pub. 42004-730L2BQG
GAI-TRONICS® CORPORATION
A HUBBELL COMPANY
ICS AC-Powered Page/Party Plug-in Amplifiers - Quick Installation Guide
®
Important Safety Instructions
This equipment is suitable for use in Class I, Division 2, Groups A, B, C and D, Class II Division 2, Groups F, and G, Class III OR non-hazardous locations only.
Combinations of equipment in your system are subject to investigation by the local Authority Having Jurisdiction at the time of installation.
Read, follow, and retain instructions – All safety and operating instructions should be read and followed before operating the unit. Retain instructions for future
reference.
Heed warnings – Adhere to all warnings on the unit and in the operating instructions.
Attachments – Attachments not recommended by the product manufacturer should not be used, as they may cause hazards. Maximum system cable length is not to
exceed two miles.
Servicing – Do not attempt to service this unit by yourself. Opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to
qualified service personnel.
This permanently connected apparatus must have a UL Listed 15-amp circuit breaker incorporated in the electrical installation of the building.
WARNING – EXPLOSION HAZARD – Do not disconnect equipment unless power has been removed or the area is known to be non-hazardous. Averttissement –
Risque d’explosion – avant de déconnector l’equipment, couper le courant ou s’assurer que l’emplacement est désigné non dandereux.
USA and Canada Consult the National Electrical Code (NFPA 70), Canadian Standards Association (CSA 22.1), and local codes for specific requirements regarding
your installation. Class 2 circuit wiring must be performed in accordance with NEC 725.55.
General Information and Available Options
This quick guide covers the installation of the ICS AC-Powered Plug-in Amplifiers. See the chart below for applicable models.
ICS Amplifier
Model
Description
751-001ICS
Speaker Amplifier
701-302ICS
Handset/Speaker Amplifier
701-304ICS
Handset/Speaker Amplifier with
Auxiliary Jack
751-001ICSVC
Speaker Amplifier with VLC
701-302ICSVC
Handset/Speaker Amplifier with
VLC
701-304ICSVC
Handset/Speaker Amplifier with
Auxiliary Jack and VLC
751-901ICS
SmartSeries Speaker Amplifier
701-902ICS
SmartSeries Handset/Speaker
Amplifier
701-904ICS
SmartSeries Handset/Speaker
Amplifier with Auxiliary Jack
Figure 1. ICS AC-Powered Page/Party® Plug-in Amplifier Installation
Refer to Pub. 42004-730L2 at the “Manuals & Specs” link at www.gai-tronics.com for detailed explanations of the available models
and their settings, adjustments and warranty.
Installing the ICS Page/Party® Plug-in Amplifier
1.
2.
3.
Plug the amplifier directly into the enclosure. Use extra care not to damage the protruding latch wings of connector P6 located on
the top right edge of the amplifier during installation.
Attach the amplifier to the enclosure with the hardware provided. See Figure 1.
Apply power to the station.
GAI-Tronics Corporation 400 E. Wyomissing Ave. Mohnton, PA 19540 USA
610-777-1374 „ 800-492-1212 „ Fax: 610-796-5954
VISIT WWW.GAI-TRONICS.COM FOR PRODUCT LITERATURE AND MANUALS
®
ICS AC-Powered Page/Party Plug-in Amplifiers Quick Installation Guide
Pub. 42004-730L2BQG
Page: 2 of 2
Enclosure RTU Connection (if applicable)
Amplifiers with VLC or SmartSeries PCBAs can be connected via an enclosure ribbon cable to provide a double-pole, Form “C” relay
and one fuse-protected contact. If an RTU is present in the enclosure, connect the ribbon cable provided to the receptacle on the top
side of the amplifier.
Available Adjustments
Most models are preconfigured to a default standard at the factory. The following is a partial list of the available adjustments and
settings that may be needed. Refer to Pub. 42004-730L2 for complete information.
Standard AC-Powered
ICS Plug-in Amp
• Speaker Volume
• Speaker Mute
• Speaker Gain
• Transmit Level
• Receiver Volume
ICS Plug-in Amp with VLC
• Speaker Volume
• Speaker Mute
• Speaker Gain
• Transmit Level
•
•
•
•
Receiver Volume
Audio Alignment
Page Disable Control
Remote Signaling (RTU)
SmartSeries AC-Powered Plugin Amp
• Address
• ALS Minimum Level
• ALS Offset Level
• SmartSeries VLC Level
• FSK Signal Gain
NRTL Listed for USA and Canada.................................................................................. Class I, Groups A, B, C, and D, Division 2;
Class II, Groups F and G, Division 2;
Class III, Division 2 Hazardous Locations
Temperature code, T4
f:\standard ioms - current release\42004-xxxxqg quick guides\42004-730l2bqg.doc
04/11
Warranty
Equipment.
GAI-Tronics warrants for a period of one (1) year from the date of shipment, that any
GAI-Tronics equipment supplied hereunder shall be free of defects in material and workmanship, shall
comply with the then-current product specifications and product literature, and if applicable, shall be fit
for the purpose specified in the agreed-upon quotation or proposal document. If (a) Seller’s goods prove
to be defective in workmanship and/or material under normal and proper usage, or unfit for the purpose
specified and agreed upon, and (b) Buyer’s claim is made within the warranty period set forth above,
Buyer may return such goods to GAI-Tronics’ nearest depot repair facility, freight prepaid, at which time
they will be repaired or replaced, at Seller’s option, without charge to Buyer. Repair or replacement shall
be Buyer’s sole and exclusive remedy. The warranty period on any repaired or replacement equipment
shall be the greater of the ninety (90) day repair warranty or one (1) year from the date the original
equipment was shipped. In no event shall GAI-Tronics warranty obligations with respect to equipment
exceed 100% of the total cost of the equipment supplied hereunder. Buyer may also be entitled to the
manufacturer’s warranty on any third-party goods supplied by GAI-Tronics hereunder. The applicability
of any such third-party warranty will be determined by GAI-Tronics.
Services.
Any services GAI-Tronics provides hereunder, whether directly or through subcontractors,
shall be performed in accordance with the standard of care with which such services are normally
provided in the industry. If the services fail to meet the applicable industry standard, GAI-Tronics will
re-perform such services at no cost to buyer to correct said deficiency to Company's satisfaction provided
any and all issues are identified prior to the demobilization of the Contractor’s personnel from the work
site. Re-performance of services shall be Buyer’s sole and exclusive remedy, and in no event shall GAITronics warranty obligations with respect to services exceed 100% of the total cost of the services
provided hereunder.
Warranty Periods.
Every claim by Buyer alleging a defect in the goods and/or services provided
hereunder shall be deemed waived unless such claim is made in writing within the applicable warranty
periods as set forth above. Provided, however, that if the defect complained of is latent and not
discoverable within the above warranty periods, every claim arising on account of such latent defect shall
be deemed waived unless it is made in writing within a reasonable time after such latent defect is or
should have been discovered by Buyer.
Limitations / Exclusions.
The warranties herein shall not apply to, and GAI-Tronics shall not be
responsible for, any damage to the goods or failure of the services supplied hereunder, to the extent
caused by Buyer’s neglect, failure to follow operational and maintenance procedures provided with the
equipment, or the use of technicians not specifically authorized by GAI-Tronics to maintain or service the
equipment. THE WARRANTIES AND REMEDIES CONTAINED HEREIN ARE IN LIEU OF AND
EXCLUDE ALL OTHER WARRANTIES AND REMEDIES, WHETHER EXPRESS OR IMPLIED BY
OPERATION OF LAW OR OTHERWISE, INCLUDING ANY WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Return Policy
If the equipment requires service, contact your Regional Service Center for a return authorization number
(RA#). Equipment should be shipped prepaid to GAI-Tronics with a return authorization number and a
purchase order number. If the equipment is under warranty, repairs or a replacement will be made in
accordance with the warranty policy set forth above. Please include a written explanation of all defects to
assist our technicians in their troubleshooting efforts.
Call 800-492-1212 (inside the USA) or 610-777-1374 (outside the USA) for help identifying the
Regional Service Center closest to you.
(Rev. 10/06)
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement