GE ZISS480DHSS Monogram® 48" Built-In Side-by-Side Refrigerator Quick Specs


Add to my manuals

advertisement

GE ZISS480DHSS Monogram® 48

GE Monogram ® 48" Built-In Side-by-Side Refrigerator

SPECIFICATIONS

Overall Width

Overall Height

Overall Depth

Door Clearance

Cutout Width

Cutout Height

Cutout Depth

Plumbing Requirements

Shipping Weight

48" (121.92 cm)

84" (213.36 cm)

25 3/4" (65.41 cm)

28 5/8" (72.7 cm)

47 1/2" (120.7 cm)

83 1/2" - 84 1/2"

(212.1 - 214.6 cm)

24" (61 cm)

1/4" OD copper tubing or GE

SmartConnect kit

775 lb

ATTENTION ELECTRICIAN:

A 115 volt 60Hz., 15 or 20 amp power supply is required. An inidividual properly grounded branch circuit or circuit breaker is recommended.

Install a properly grounded 3-prong electrical receptacle recessed into the back wall.

ZISS480DHSS

OVERALL DIMENSIONS

48"

(121.9)

25 3/4"

(65.4)

23 7/8"

(60.7)

25 3/4"

(65.4)

23 7/8"

(60.7)

48"

(121.9)

2"

(5.1)

2"

(5.1)

13 1/2"

(34.3)

*84"

(213.4)

13 1/2"

(34.3)

*84"

(213.4)

64 3/8"

(163.5)

64 3/8"

(163.5)

*71 7/8"

(182.6)

*71 7/8"

(182.6)

*83 1/2"

( 212.1)

*83 1/2"

( 212.1)

40"

(101.6)

40"

(101.6)

*6 1/4"

(15.9)

FRONT VIEW *6 1/4"

(15.9)

* Shipping height. Use leveling legs and wheels for maximum

1" height adjustment from shipping height.

FRONT VIEW

47"

1" height adjustment from shipping height.

(119.4)

47"

(119.4)

Case width

** Allow

15"

door swing

(38.1) min

clearance for 130˚

** Allow

15"

door swing

(38.1) min

clearance for 130˚

*3 3/8"

(8.6)

*3 3/8"

(8.6)

SIDE VIEW

SIDE VIEW

** Allow

20"

door swing

(50.8) min

clearance for 130˚

** Allow

20"

door swing

(50.8) min

clearance for 130˚

28 5/8"

(72.7)

TOP VIEW

28 5/8"

(72.7)

TOP VIEW

** Allow

4"

(10.2) min

clearance to a wall for 90˚

door swing

** Allow

4"

(10.2) min

clearance to a wall for 90˚

door swing

4"

(10.2) min

ZISS480DXSS

** Allow

4"

(10.2) min

clearance to a wall for 90˚

full 130° door swings for pan removal. If the 90° door stop position is used, pan access is

maintained, but pan removal is restricted.

** These refrigerators are equipped with a 2-position door stop. The factory-set 130° door

swing can be adjusted to 90° if clearances to adjacent cabinets or walls is restricted. Allow

full 130° door swings for pan removal. If the 90° door stop position is used, pan access is

maintained, but pan removal is restricted.

Dimensions in parentheses are in centimeters unless otherwise noted.

ZISS480DXSS

Product Specification Created 6/14

GE Monogram ® 48" Built-In Side-by-Side Refrigerator ZISS480DHSS

STANDARD INSTALLATION

47 1/2"

(120.7)

A

20"

(50.8)

47 1/2"

E

20"

(50.8)

6"

(15.2)

E

5"

(12.7)

(212.1-214.6)

*Trim will overlap additional 7/16"

(212.1-214.6)

*Trim will overlap additional 7/16"

75"

(190.5 )

From floor to bottom of electrical

75"

(190.5 )

From floor to bottom of electrical area

4"

(10.2)

4"

(10.2)

5"

(12.7)

B

WATER

FRONT VIEW

WATER

FRONT VIEW

5"

(12.7)

3 1/2"

(8.9)

ANTI-TIP BRACKET

C

SOFFIT

SOFFIT

D

24"

(61.0)

2"

(5.1)

24"

(61.0)

7/16"

(1.1)

Trim overlap

7/16"

(1.1)

Trim overlap

3 1/2"

(8.9)

SIDE VIEW

W

SIDE VIEW

W

The refrigerator will project forward, slightly beyond adjacent cabinetry.

2" x 4"

Cut to 35" Length

2" x 4"

Cut to 35" Length

SIDE VIEW INSTALLED

UNDER SOFFIT

SIDE VIEW INSTALLED

UNDER SOFFIT

SIDE VIEW INSTALLED

WITH WOODEN WALL STUDS

AND NO SOFFIT

SIDE VIEW INSTALLED

WITH WOODEN WALL STUDS

AND NO SOFFIT

Screws mounted into vertical wall studs

*84"

(213.4) studs

*Or installation height from floor

*84"

(213.4)

*Or installation height from floor

E

3/4"

Min.

Top Case Trim

Side View Top

Case Trim

Top Case Trim

Side View Top

Case Trim

Install Screws

Through Trim and Into

3/4" Min. Wood Brace

FRONT VIEW INSTALLED

WITH METAL WALL STUDS

AND NO SOFFIT

FRONT VIEW INSTALLED

WITH METAL WALL STUDS

AND NO SOFFIT

ZISS480DXSS

ZISS480DXSS

NOTES

A Mounting the junction box in this location will also allow for front accessability through access panel.

B Water supply area.

WARNING:

The refrigerator is top heavy and must be secured to prevent the possibility of tipping forward. Failure to do so may result in death or serious injury.

The information below is for cabinet design only.

When installing the antitip system you must use the product installation instructions.

Determine your installation construction and required anti-tip configuration:

C Installed Under Soffit

After installing unit into installation opening, raise grille panel and screw metal case sides to adjacent cabinet. When installed under a soffit, the soffit cannot exeed 24” deep. The top case trim overlaps the bottom of the soffit.

D Wooden Wall Studs and

No Soffit

• Cut a 2” x 4” block and secure to brackets provided.

• Secure brackets to back wall of opening at 84” or your installation height from the floor.

E Metal Wall Studs and

No Soffit

This method requires securely fastened cabinets on both sides and a ¾” minimum wood brace above unit, with it’s front surface 24” from back wall.

• After installing unit into opening, raise grille panel and attach metal case top trim to ¾” minimum wood brace.

• The brace spanning the enclosure must be securely fastened to cabinets on both sides.

See Installation

Instructions for detailed instructions.

Product Specification Created 6/14

GE Monogram ® 48" Built-In Side-by-Side Refrigerator

CUSTOM SIDE PANELS

F

24"

(61.0)

3/16"

(.5)

1 7/8"

(4.8)

*3" - 4"

(7.6 - 10.2)

*Depending on installation height

2 9/16"

(6.5)

(213.4)

*Depending on installation height

ZISS480DHSS

NOTES

F Side panels must be used whenever the sides of the refrigerator will be exposed. The 1/4” side panels will slip into the side case trim.

Secure the panels to the refrigerator with stick-on hook and loop fastener strips. Order the side panels from the cabinet manufacturer.

ZIF360NXLH_ZIF360NXRH _ZIFP360NXLH_ZIFP360NXRH_ ZIFS360NXLH_ZIFS360NXRH

ZIR360NXLH_ZIR360NXRH_ZIRP360NXLH_ZIRP360NXRH_ZIRS360NXLH_ZIRS360NXRH

Product Specification Created 6/14

GE Monogram ® 48" Built-In Side-by-Side Refrigerator

FEATURES AND BENEFITS

Halogen Light Columns - Located in the freezer and fresh food compartments, extend the full length of the interior compartments providing brilliant, all-level illumination

LED Lighting - Located at the top of the fresh food compartment, and inside the vegetable and climate-control drawers, illuminates contents without compromising space

Advanced Temperature Management System

with Multi-Shelf Air Tower - Provides even distribution of air throughout the refrigerator

Climate-Control Drawer - Allows you to expresschill beverages, express-thaw meats and select specific temperatures for perishable foods

Dispenser with Proximity Sensor - Designed to accommodate glassware of all sizes, from pitchers to tumblers; control graphics light up as you approach and automatically switch off when you walk away

Filter-Change Indicator Light - Located on the upfront control panel, provides a visual reminder when it's time to replace the filter for the water dispenser

GE ® Water Filter - Has been moved from the fresh food compartment to the overhead cabinet, where it is discreetly out of sight

Dairy Bin with Center Divider - Has a unique magnetic seal that locks in freshness

ZISS480DHSS

R

Product Specification Created 6/14

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Frequently Answers and Questions

What is the overall width of the refrigerator?
The overall width is 48 inches (121.92 cm).
What is the overall height of the refrigerator?
The overall height is 84 inches (213.36 cm).
What is the overall depth of the refrigerator?
The overall depth is 25 3/4 inches (65.41 cm).
What is the required door clearance?
The required door clearance is 28 5/8 inches (72.7 cm).
What are the cutout dimensions?
The cutout width is 47 1/2 inches (120.7 cm), the cutout height is 83 1/2 - 84 1/2 inches (212.1 - 214.6 cm), and the cutout depth is 24 inches (61 cm).
What plumbing requirements are necessary?
1/4" OD copper tubing or GE SmartConnect kit is required.
What is the shipping weight of the refrigerator?
The shipping weight is 775 lb.

advertisement