Fabric Filler End Caps (60848)

Fabric Filler End Caps (60848)
End Cap with Fabric Filler Installation Instructions
NOTE: Before proceeding with filler, see owners manual on typical weather
seal application for end caps and finish that step first.
CAUTION: DO NOT STAND OR WALK ON END CAP OR FABRIC FILLER
Fabric Filler
Attached To
Rope Channel
Rope
Channel
Weather Seal
Drive Rivot (10x)
1
With cap laying on flat surface, apply weather seal to
bottom of end cap as shown. Align rope channel along
bottom of cap with opening facing as shown. Cut rope
channel flush with ends of cap. Drill approximately
ten 7/32” holes evenly spaced. Insert rivet and set with
hammer.
2
Align one end of rope/hem in fabric filler with rope
channel on end cap and slide fabric fully on to end cap.
Finish Mounting End Cap
With Standard Hardware
Here. Refer To Owwner’s
Manual For Details.
Tarp Straps
Attached To Side
Of Box (Tarp Straps
Not Included In Kit)
Fabric Filler
Squared With Box
3
Set cap with fabric filler on top of box and position
it so filler sides hang over box. Adjust until filler
pulls snug and squares up with corners of box. Then
center end cap on box and center filler on cap. With
pieces centered, at each end of cap drill a 5/16 hole top
down next to wind deflector of cap and into box rail
as shown. Turn a 3/8 self threading screw tight. Use
Owner’s Manual to finish mounting cap to box.
Part No. 60848_
4
Attach tarp straps (not included with kit) to D-Rings
on fabric filler and pull snug tight and attach to suitable
locations on box.
Copyright 2009 AGRI-COVER, INC. ALL RIGHTS RESERVED
112809
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising