Installation Guide: MMK-G1-CBF-T

Installation Guide: MMK-G1-CBF-T
Crestron MMK-G1-CBF-T
Mud Ring Mount Kit for Cameo®
Installation Guide
This document was prepared and written by the Technical Documentation department at:
Crestron Electronics, Inc.
15 Volvo Drive
Rockleigh, NJ 07647
1-888-CRESTRON
Regulatory Compliance
As of the date of manufacture, the MMK-G1-CBF-T has been tested and found to comply with specifications for
CE marking and standards per EMC and Radiocommunications Compliance Labelling.
All brand names, product names and trademarks are the property of their respective owners.
©2010 Crestron Electronics, Inc.
Crestron MMK-G1-CBF-T
Mud Ring Mount Kit for Cameo®
Contents
Mud Ring Mount Kit for Cameo®: MMK-G1-CBF-T
1
Introduction ............................................................................................................................... 1
Setup .......................................................................................................................................... 3
Supplied Hardware ...................................................................................................... 3
Installation ................................................................................................................... 3
Resources................................................................................................................................... 8
Further Inquiries .......................................................................................................... 8
Future Updates ............................................................................................................ 8
Return and Warranty Policies .................................................................................................... 9
Merchandise Returns / Repair Service ........................................................................ 9
CRESTRON Limited Warranty................................................................................... 9
Installation Guide – DOC. 6988A
Contents • i
Mud Ring Mount Kit for Cameo®
Crestron MMK-G1-CBF-T
®
Mud Ring Mount Kit for Cameo :
MMK-G1-CBF-T
Introduction
This Mud Ring Mount Kit for Cameo® is the preferred mounting option
for first and second-generation Cameo flush-mount keypads. This kit
allows Cameo flush-mount keypads to be mounted in a 1-gang electrical
box. This kit also provides a mounting solution for when cutouts made in
the mounting surface are too large.
Specifications for the MMK-G1-CBF-T are listed in the following table.
MMK-G1-CBF-T Specifications
SPECIFICATION
Dimensions
Height
Width
Depth
Weight
Installation Guide – DOC. 6988A
DETAILS
4.50 in (114 mm)
2.80 in (72 mm)
0.64 in (17 mm)
1 oz (28 g)
Mud Ring Mount Kit for Cameo®: MMK-G1-CBF-T • 1
Mud Ring Mount Kit for Cameo®
Crestron MMK-G1-CBF-T
MMK-G1-CBF-T Overall Dimensions
1.80 in
(46 mm)
0.90 in
(23 mm)
0.68 in
(18 mm)
3.60 in
(92 mm)
3.82 in
(97.0 mm)
4.50 in
(115 mm)
2.88 in
(74 mm)
3.28 in
(84 mm)
2.80 in
(72 mm)
1.51 in
(39 mm)
0.64 in
(17 mm)
2 • Mud Ring Mount Kit for Cameo®: MMK-G1-CBF-T
0.02 in
(0.5 mm)
Installation Guide – DOC. 6988A
Mud Ring Mount Kit for Cameo®
Crestron MMK-G1-CBF-T
Setup
Supplied Hardware
The hardware supplied with the MMK-G1-CBF-T is listed in the
following table.
Supplied Hardware for the MMK-G1-CBF-T
DESCRIPTION
PART NUMBER
QUANTITY
4510974
4510975
1
1
Mud Ring
Template
Installation
It is assumed that the keypad has been assembled and that the template
Wall
Mounting supplied with the keypad has been used to prepare a hole in the wall. It is
also assumed that the drywall in place has an irregular rectangular cutout
that requires the use of the mud ring mount kit.
The only tools or materials required and not supplied are:
• Level
• Hand saw suitable for cutting a hole in the drywall
• Four #6 standard drywall screws
• #2 Phillips screwdriver
• Tools/material to apply drywall joint compound
The figure on the following page (not to scale) illustrates the supplied
template used to prepare the hole in the wall or other mounting surface for
the mud ring.
NOTE: Use only the original template, not a photocopy, to prepare the
hole. Photocopies usually alter the size of the image slightly, which would
make the hole the wrong size.
Installation Guide – DOC. 6988A
Mud Ring Mount Kit for Cameo®: MMK-G1-CBF-T • 3
Mud Ring Mount Kit for Cameo®
Crestron MMK-G1-CBF-T
Mounting Template
TEMPLATE - OV40109
FOR MMK-G1-CBF-T
1 OF 2
CUT ALONG THIS LINE
CUT ALONG THIS LINE
TEMPLATE - OV40109
FOR MMK-G1-CBF-T
2 OF 2
5 in
(127 mm)
CL
3-11/16 in
(94 mm)
CL
2-7/8 in
(74 mm)
CL
CL
CLEARANCE AREA
FOR BEZEL
2-3/8 in
(61 mm)
3-5/16 in
(85 mm)
1. Use the level to position the supplied template over the irregular
rectangular cutout.
2. Secure the template in position and use a drywall handsaw to
straighten and enlarge the hole as necessary to accommodate the
mud ring.
3. Insert the mud ring into the enlarged cutout, as shown in the
illustration on the following page (The C2N-CBF-T keypad is
shown for reference).
4 • Mud Ring Mount Kit for Cameo®: MMK-G1-CBF-T
Installation Guide – DOC. 6988A
Crestron MMK-G1-CBF-T
Mud Ring Mount Kit for Cameo®
Installing the Mud Ring in a Wall Cutout
Wall
Cutout 1-1/2 in x 2-7/8 in
(39 mm x 74 mm)
Screws (4) #6 Drywall
(Not Supplied)
4. When the mud ring is in position, loosely secure with four #6
drywall screws (not supplied). The length of the screws should not
exceed the wall thickness by more than 1/2 inch (13 mm).
5. Verify that the mud ring is level.
6. Use a screwdriver to tighten the drywall screws by hand so that
they slightly dimple into the holes in the mud ring.
NOTE: Do not over tighten the screws. Doing so may over-dimple
or rip the mud ring.
7. Apply drywall compound as needed to finish the cutout.
8. When dry, refer to the latest version of your Cameo Keypad
Operation & Installation Guide to complete the installation.
Installation Guide – DOC. 6988A
Mud Ring Mount Kit for Cameo®: MMK-G1-CBF-T • 5
Mud Ring Mount Kit for Cameo®
Mounting
in a
1-gang
box
Crestron MMK-G1-CBF-T
It is assumed that the keypad has been assembled and the drywall in place
around the box has an irregular rectangular cutout that requires the use of
the mud ring mount kit.
The only tools or materials required and not supplied are:
• Level
• Two #06-32 standard electrical box screws
• #2 Phillips screwdriver
• Tools/material to apply drywall joint compound
1. Insert the mud ring into the electrical box as shown in the
following illustration. (The C2N-CBF-T keypad is shown for
reference.)
Installing the Mud Ring in a Single Gang Box
Screws (2) #06-32
(Not Supplied)
1-Gang Box
6 • Mud Ring Mount Kit for Cameo®: MMK-G1-CBF-T
Installation Guide – DOC. 6988A
Crestron MMK-G1-CBF-T
Mud Ring Mount Kit for Cameo®
2. When the mud ring is in position, loosely secure with two #06-32
standard electrical box screws (not supplied).
3. Verify that the mud ring is level.
4. Use a screwdriver to tighten the screws by hand so that they
slightly dimple into the holes in the mud ring.
NOTE: Do not over tighten the screws. Doing so may over-dimple
or rip the mud ring.
5. Apply drywall compound as needed to finish the cutout.
6. When dry, refer to the latest version of your Cameo Keypad
Operation & Installation Guide to complete the installation.
Installation Guide – DOC. 6988A
Mud Ring Mount Kit for Cameo®: MMK-G1-CBF-T • 7
Mud Ring Mount Kit for Cameo®
Crestron MMK-G1-CBF-T
Resources
Further Inquiries
If you cannot locate specific information or have questions after
reviewing this guide, please take advantage of Crestron's award winning
customer service team by calling Crestron at 1-888-CRESTRON
[1-888-273-7876].
You can also log onto the online help section of the Crestron website
(www.crestron.com/onlinehelp) to ask questions about Crestron products.
First-time users will need to establish a user account to fully benefit from
all available features.
Future Updates
As Crestron improves functions, adds new features and extends the
capabilities of the MMK-G1-CBF-T, additional information may be
made available as manual updates. These updates are solely electronic
and serve as intermediary supplements prior to the release of a complete
technical documentation revision.
Check the Crestron website periodically for manual update availability
and its relevance. Updates are identified as an “Addendum” in the
Download column.
8 • Mud Ring Mount Kit for Cameo®: MMK-G1-CBF-T
Installation Guide – DOC. 6988A
Crestron MMK-G1-CBF-T
Mud Ring Mount Kit for Cameo®
Return and Warranty Policies
Merchandise Returns / Repair Service
1.
No merchandise may be returned for credit, exchange or service without prior authorization
from CRESTRON. To obtain warranty service for CRESTRON products, contact an
authorized CRESTRON dealer. Only authorized CRESTRON dealers may contact the factory
and request an RMA (Return Merchandise Authorization) number. Enclose a note specifying
the nature of the problem, name and phone number of contact person, RMA number and
return address.
2.
Products may be returned for credit, exchange or service with a CRESTRON Return
Merchandise Authorization (RMA) number. Authorized returns must be shipped freight
prepaid to CRESTRON, 6 Volvo Drive, Rockleigh, N.J. or its authorized subsidiaries, with
RMA number clearly marked on the outside of all cartons. Shipments arriving freight collect
or without an RMA number shall be subject to refusal. CRESTRON reserves the right in its
sole and absolute discretion to charge a 15% restocking fee plus shipping costs on any
products returned with an RMA.
3.
Return freight charges following repair of items under warranty shall be paid by CRESTRON,
shipping by standard ground carrier. In the event repairs are found to be non-warranty, return
freight costs shall be paid by the purchaser.
CRESTRON Limited Warranty
CRESTRON ELECTRONICS, Inc. warrants its products to be free from manufacturing defects in materials
and workmanship under normal use for a period of three (3) years from the date of purchase from
CRESTRON, with the following exceptions: disk drives and any other moving or rotating mechanical
parts, pan/tilt heads and power supplies are covered for a period of one (1) year; touchscreen display and
overlay components are covered for 90 days; batteries and incandescent lamps are not covered.
This warranty extends to products purchased directly from CRESTRON or an authorized CRESTRON
dealer. Purchasers should inquire of the dealer regarding the nature and extent of the dealer's warranty, if
any.
CRESTRON shall not be liable to honor the terms of this warranty if the product has been used in any
application other than that for which it was intended or if it has been subjected to misuse, accidental
damage, modification or improper installation procedures. Furthermore, this warranty does not cover any
product that has had the serial number altered, defaced or removed.
This warranty shall be the sole and exclusive remedy to the original purchaser. In no event shall
CRESTRON be liable for incidental or consequential damages of any kind (property or economic damages
inclusive) arising from the sale or use of this equipment. CRESTRON is not liable for any claim made by a
third party or made by the purchaser for a third party.
CRESTRON shall, at its option, repair or replace any product found defective, without charge for parts or
labor. Repaired or replaced equipment and parts supplied under this warranty shall be covered only by the
unexpired portion of the warranty.
Except as expressly set forth in this warranty, CRESTRON makes no other warranties, expressed or
implied, nor authorizes any other party to offer any warranty, including any implied warranties of
merchantability or fitness for a particular purpose. Any implied warranties that may be imposed by law are
limited to the terms of this limited warranty. This warranty statement supersedes all previous warranties.
Trademark Information
All brand names, product names and trademarks are the sole property of their respective owners. Windows is a registered trademark
of Microsoft Corporation. Windows95/98/Me/XP/Vista/7 and WindowsNT/2000 are trademarks of Microsoft Corporation.
Installation Guide – DOC. 6988A
Mud Ring Mount Kit for Cameo®: MMK-G1-CBF-T • 9
Mud Ring Mount Kit for Cameo®
Crestron MMK-G1-CBF-T
This page is intentionally left blank.
10 • Mud Ring Mount Kit for Cameo®: MMK-G1-CBF-T
Installation Guide – DOC. 6988A
Crestron MMK-G1-CBF-T
Mud Ring Mount Kit for Cameo®
This page is intentionally left blank.
Installation Guide – DOC. 6988A
Mud Ring Mount Kit for Cameo®: MMK-G1-CBF-T • 11
Crestron Electronics, Inc.
15 Volvo Drive Rockleigh, NJ 07647
Tel: 888.CRESTRON
Fax: 201.767.7576
www.crestron.com
Installation Guide – DOC. 6988A
(2027556)
05.10
Specifications subject to
change without notice.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement