C4006

C4006
INSTALLATION INSTRUCTIONS
P/N’S C4006 , C4007, C4008
INSTALLATION
1. Remove the engine and transmission from the car.
2. Unbolt the stock engine frame mounts from the frame. (This step may be omitted if the stock engine
location is not being changed).
3. Bolt the stock engine mounts to the engine along with the stock frame mounts.
4. Bolt the mid mount engine plate (if used) between the transmission bell housing and engine. Temporarily
install the headers to make sure they don’t interfere with the mid mount plate.
Note: Whatever transmission you are using, be sure that the crossmember location has already been
determined and in place before installation of the front mount engine plate or mid mount engine
plate.
5. Reinstall the engine and transmission in the car allowing the front of the engine to sit on the stock
mounts and the transmission to sit on the crossmember. (Do not bolt down either).
6. Install the headers in the car.
7. Bolt on the front engine plate.
8. The engine may be moved to the right, left, or raised for additional header clearance. Make sure that the
transmission mount is sitting on the crossmember and is not more than a 1/2” to the right or left of being
centered between the frame rails.
9. The mounting bracket location for the engine plate or plates may vary with each vehicle. Find a suitable
bracket location, tack weld in place, check clearances.
10. Final welding should be finished before transfer drilling the holes from the plate to the mount.
For Technical Assistance, call Competition Engineering's Tech Line at
(203) 458-0542,(203) 458 0546 8:30am-5:00pm Eastern Time
COMPETITION ENGINEERING
80 Carter Drive • Guilford, CT 06437
PHONE: (203) 453-5200 • Fax: (203) 453-6906
Rev D
062512
Visit Us At www.competitionengineering.com
C4006INST
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement