Dobson Pendant Installation Instructions for 700FJDBS_ G

Dobson Pendant Installation Instructions for 700FJDBS_ G
920FJDOBS
Installation Instructions for
Dobson Pendant
700FJDBS_
1.0
P ENDANTS -L OW V OLTAGE
GENERAL PRODUCT INFORMATION:
This product is ETL listed and suitable only for indoor dry
locations and approved for use at any height above the
finished floor.
This product is patented (U.S. PAT. 6,183,297).
Adjust The Fixture Height
1A
1C
ALLEN WRENCH
SET SCREW
5
1
1
Back out (do not remove) the set screw on tip of the
connector with the provided Allen wrench.
4
Cut the coaxial cable to the desired length.
5
Gently twist the end of the coaxial cable between thumb
and forefinger.
1B
1D
ALLEN WRENCH
SET SCREW
SURFACE
2
PLATE
6
3
2
3
Back out (do not remove) the set screw on the conical
connector with the provided Allen wrench.
6
Pull the coaxial cable out.
1
Tap the conical connector on a hard surface with the set
screw facing down, so the plate inside drops into place.
1H
1E
11
7
CONICAL CONNECTOR
OUTER WRAPPED
WIRE STOPS HERE
7
11 Firmly tighten the set screw on the conical connector.
Feed and push the coaxial cable into the conical
connector. The coaxial cable will come to a stop point
after being inserted 3/4" into the conical connector.
1F
1I
WRINKLE ON OUTER
WRAPPED WIRE
8
12
INNER WIRE STOPS HERE
8
Keep pushing the coaxial cable into the connector while
rotating the connector to ease feeding the inner wire
into the tip of the connector. The outer wrapped wire
will start wrinkling while being inserted another 1/2" into
the connector.
12 Pull the coaxial cable toward the fixture to smooth the
wrinkles.
1G
ALLEN WRENCH
INNER WIRE
10
9
SIGHT HOLE
9
Look into the sight hole on the top of the connector to
make sure that the inner wire is contacting the end of
the connector.
10
Hold the coaxial cable in place and tighten the set screw
on tip of the connector with the provided Allen wrench.
Make sure this set screw connection is tight.
2
Replacing the Lamp
2B
C AUTION: To reduce the risk of a burn or electric
shock during relamping, disconnect the power to
the fixture.
2A
4
METAL SHADE
3
2
1
SOCKET
MR16 LAMP
SOCKET
For incandescent versions, use MAX 50 Watt
Mr16 Front Cover Halogen lamp.
MR16 LAMP
1
Move the fixture metal shade up to expose the socket.
For LED versions, use provided MAX 8 Watt LED
MR16 Bi-Pin Lamp.
3
2
Remove the old lamp.
3
Push the new lamp pins completely into the socket.
4
Lower the metal shade back on top of the socket
assembly.
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
847.410.4400
www.techlighting.com
© 2016 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
A Generation Brands Company
4
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising