Vigilant VS Control

Vigilant VS Control
Frame these instructions and mount on the wall next to the control panel.
Vigilant Fire Alarm Control Panel Operating Instructions
For models: VS1-G, VS1-GD, VS1-R, VS1-RD, VS1-G-2, VS1-R-2, VS1-GL, VS1-GL-F,
VS2-G, VS2-GD, VS2-R, VS2-RD, VS2-G-2, VS2-R-2, VS2-GL-F
For additional information, refer to the Vigilant Technical
Reference Manual P/N 310113.
RESPONDING TO ALARM SIGNALS
1.
2.
3.
Evacuate the area.
Notify the proper authorities immediately and state the
nature and location of the emergency.
Be prepared to provide directions to firefighters when
they arrive.
TO SILENCE THE PANEL BUZZER
1.
Press Panel Silence.
The buzzer turns off. Any new events turn the buzzer back
on. Trouble conditions not cleared resound the buzzer after
a predetermined time.
WARNING! Trouble conditions may affect the panel's ability
to provide early detection and indication of a fire. Clear
trouble conditions immediately.
TO SILENCE ALARM NOTIFICATION SIGNALS
RESPONDING TO SUPERVISORY SIGNALS
WARNING! Alarm notification signals should not be silenced
until after all occupants have been evacuated.
1.
2.
1.
Press Signal Silence.
The Signal Silenced LED turns on and all audible notification
circuits turn off. New alarm events turn the notification
circuits back on.
Note: Panel programming may delay alarm silence for up to
one minute, may prevent alarm silencing when water flows
through the sprinkler system, and may not turn off visible
notification circuits.
TO RETURN THE SYSTEM TO NORMAL AFTER AN ALARM OR
SUPERVISORY EVENT
1.
2.
Make sure all smoke detectors are free from smoke and
all manual pull stations are reset.
Press Reset.
Note: Panel programming may delay panel reset for up to
one minute after alarm notification circuits turn on.
TO INITIATE A FIRE DRILL
1.
Press Drill.
Silence the panel buzzer.
Investigate the cause of the supervisory signal and
notify the authorized service personnel immediately.
RESPONDING TO MONITOR SIGNALS
1.
2.
Silence the panel buzzer.
Investigate the cause of the monitor signal and notify
the authorized service personnel immediately.
PERIODIC TEST RECOMMENDATIONS
See “Maintenance and Testing,” in the Vigilant Technical
Reference Manual for test instructions and references.
Installed by
Name:
Company:
Address:
Phone:
Per NFPA 72
†
Protected Premises Fire Alarm System, Local
†
Auxiliary Fire Alarm System
TO PERFORM A LAMP TEST (panel and remote annunciators)
†
Remote Supervising Station Fire Alarm System
1.
2.
3.
4.
†
Central Station
All audible notification circuits turn on. This function will not
automatically notify the fire department.
Press the Menu button.
Choose Test.
Choose Lamp Test.
Press Enter.
TO PERFORM A REMOTE ANNUNCIATOR LAMP TEST
1.
2.
Press and hold the Silence button on the LCRA for five
seconds.
LEDs on remote annunciators will remain on until silence
button is released.
Date:
For service contact
NAC DIVISIONS
Company:
2014 Lincoln Way East
Address:
Chambersburg, PA 17202
(717) 261-0123
service@nacdivisions.com
Phone:
Acceptance Inspection by
RESPONDING TO TROUBLE SIGNALS
1.
2.
Silence the panel buzzer.
Investigate the cause of the trouble and notify the
authorized service personnel immediately.
Operating Instruction Placard
Vigilant - Fire Alarm Control Panel
Nac Divisions Reference Document
Date:
P/N: 3101106 REV: 1.0
1/1
Operating Instructions
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising