AFTERCARE INSTRUCTIONS

AFTERCARE INSTRUCTIONS
AFTERCARE INSTRUCTIONS
Your fitting has a high quality finish and should be treated with care to preserve the
visible surfaces.
All surface finishes will wear if not cleaned correctly, the only safe way to clean your
mixer is to wipe with a soft damp cloth. Stains can be removed using washing up
liquid. All bath cleaning powders and liquids will damage the surface of your fitting,
even the non-scratch cleaners. NOTE: Never use abrasive detergents or
disinfectants or those containing alcohol, hydrochloric acid or phosphoric
acid.
GUARANTEE
All products are manufactured to the highest standards and a 5 year guarantee
covers any defect in manufacture.
NOTE: The 5-year guarantee on the cartridge is invalidated if damaged by any
waterborne debris.
All products must have access for servicing or replacement during the life of
the product.
In the interests of continuous product development we reserve the right to alter
specification as necessary
Renaissance
Bridge Sink Mixer
PRODUCT CODE: RS DSM C/ BN/ G
PRODUCT IDENTIFICATION CODE LASER ETCHED ON PRODUCT
Installer please fill in code here
. (Where applicable)
TELEPHONE HELPLINE! +44 (0)844 701 6273
Bristan Group Limited
Birch Coppice Business Park
Dordon
Tamworth
Staffordshire
B78 1SG
UK
A Masco Company
Website: www.bristan.com
Telephone:+44 (0) 844 701 6274
Facsimile: +44 (0) 844 701 6275
Email: enquire@bristan.com
Fitting Instructions
& Contents List
Please keep these instructions for future reference and request of
replacement part
(FI BRDSM)
(Rev.D6)
WATER PRESSURE
INSTALLATION
This mixer is suitable for use at all supply pressures.
If the fitting is installed at low pressure (tank fed), then the minimum height from the
outlet of the nozzle to the underside of the cold tank should be at least 2 metres to
ensure adequate shower performance.
1. Identify all components and check for completeness, particularly before
arranging fitting.
This mixer should be installed in compliance with the Water Regulations. Where the
supplies are unbalanced, i.e. hot water from cylinder tank / cold from the mains,
approved check valves must be fitted in the supply pipes.
For further details contact your Local Water Authority.
2. Fit the nozzle to the body, using the brass ‘C’ washer in the groove above the
‘O’ rings.
3. Fit the legs to the body using the plastic sealing washers.
4. Install the fitting into the sink, using the washers and backnuts provided.
5. Connect the hot and cold water supplies.
6. Turn on the water supplies. Open both valves letting the water flow for a few
minutes to flush the system.
7. Check all joints and connections for leaks.
8. See over the page for aftercare instructions.
N.B. Please write the name and product code of your fitting in the spaces
provided overleaf. This will ensure a speedier service if you should need to
phone the help line.
MAINTENANCE
Traditional type valves:- If the fitting leaks from the spindle
1. Remove fitting handle (if necessary)
2. Tighten gland nut on top of valve.
All valves types:- If the fitting begins to drip
1. Turn off the water supply.
2. Remove fitting handle and valve.
3. Carefully clean seating and rubber washer.
4. Replace valve and turn on the water supply.
5. Contact our helpline if problem persists.
PLEASE NOTE:
In the unlikely event you find a part missing, please contact our Customer Service
helpline on 0844 701 6273 for immediate dispatch of part
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising