GL-EXP-SW-CN Crestron Green Light® Switching Expansion Module, Cresnet®

GL-EXP-SW-CN Crestron Green Light® Switching Expansion Module, Cresnet®
GL-EXP-SW-CN
Crestron Green Light® Switching Expansion Module, Cresnet®
The Crestron Green Light® GL-EXP Series delivers a family of
professional lighting control modules for Cresnet® or DALI® based
lighting systems. Designed for easy installation on a wall or above a
suspended ceiling, these modules offer a perfect solution for adding
extra lighting zones to any system without requiring an additional
lighting cabinet.
The GL-EXP-SW-CN is a single-channel expansion module designed to
switch incandescent, magnetic low-voltage, electronic low-voltage,
neon/cold cathode, fluorescent ballast, high-intensity discharge, LED,
and motor loads.
This module interfaces with a Crestron® control system via
Cresnet,[1] a simple 4-wire network bus that acts as the
communications backbone for Crestron lighting dimmers, keypads,
shades, thermostats, and other devices.
In the event that Cresnet communications should be disrupted for any
reason, the GL-EXP-SW-CN includes an override feature, which allows a
single dimming preset to be saved at setup and activated at any time
via an external contact closure.
The GL-EXP-SW-CN is designed to be mounted to a vertical surface[2]
and complies with UL 2043 standards for installation in an
environmental air-handling space above a suspended ceiling. Conduit
knockouts are provided on the bottom and lower sides of the unit. All
connections are made via screw terminals behind the front cover.
Connections
NEUT: (3) Captive screw terminals,[3] neutral connection for feed and load
LINE: (2) Captive screw terminals,[3] line power input and loop-through
SW: (1) Captive screw terminal,[3] switched load output
OVERRIDE: (2) Captive screw terminals, sensing input for external lowvoltage contact closure;
Activates override mode when a closure is present;
Accepts up to 12 AWG (2.5 mm2) wire
CRESNET: (1) 4 captive screw terminals, Cresnet slave port
Controls & Indicators
> One channel of switching for 120 Volt or 277 Volt
incandescent, magnetic low-voltage, electronic low-voltage,
neon/cold cathode, fluorescent ballast, high-intensity
discharge, LED, and motor loads up to 16 Amps
>
>
>
>
Cresnet® communications
Built-in air gap relay
Override preset capability
Surface mountable on a wall or above a suspended
ceiling[2]
> UL 2043 compliant for installation in plenum-rated ceilings
Environmental
Temperature: 32° to 104° F (0° to 40° C)
Humidity: 10% to 90% RH (non-condensing)
Enclosure
Surface mount[2] module with (2) integral mounting flanges, galvanized steel
with gray matte powder coat front panel, extruded aluminum heat sink, and
(4) 1/2” or 3/4” conduit knockouts provided on bottom and lower left & right
sides
SPECIFICATIONS
Load Ratings
Dimmer Channels: 1
Load Rating: 16 Amps
Load Types: Incandescent, magnetic low-voltage, electronic low-voltage, neon/
cold cathode, fluorescent ballast, high-intensity discharge, LED, motor
Input Voltage
120/277 Volts AC, 50/60 Hz
Communications
Cresnet®[1]
www.crestron.com
PWR: (1) Green LED, indicates line power is applied to the HOT terminal
NET: (1) Yellow LED, indicates network communication
ERR: (1) Red LED, indicates presence of an error message
ON/OFF: (1) Red LED and (1) pushbutton, LED indicates power is applied to
the load and pushbutton toggles power to the load on and off
RESET: (1) Pushbutton, initiates factory reset
800.237.2041
Dimensions
Height: 8.75 in (223 mm)
Width: 6.36 in (163 mm)
Depth: 3.19 in (81 mm)
GL-EXP-SW-CN
Weight
3.43 lb (1.56 kg)
Available Models
GL-EXP-SW-CN [6507040]: Crestron Green Light® Switching Expansion
Module, Cresnet®
Notes:
1.
Cresnet is for communications only, not power. Must be oriented
upright, mounted to a vertical surface, with 6 in (153 mm) minimum spacing
above and below it for proper ventilation and heat dissipation.Captive
screw terminals accept up to two 22 to 12 AWG (0.34 to 4.0 mm²) wires per
terminal.
This product may be purchased from an authorized Crestron
dealer. To find a dealer, please contact the Crestron sales representative
for your area. A list of sales representatives is available online at www.
crestron.com/salesreps or by calling 800-237-2041.
The specific patents
that cover Crestron products are listed online at: patents.crestron.com
patents.crestron.com.
Certain Crestron products contain open source software. For specific
information, visit www.crestron.com/opensource
www.crestron.com/opensource.
Crestron, the
Crestron logo, Cresnet, and Crestron Green Light are either trademarks or
registered trademarks of Crestron Electronics, Inc. in the United States
and/or other countries. Other trademarks, registered trademarks, and trade
names may be used in this document to refer to either the entities claiming
the marks and names or their products. Crestron disclaims any proprietary
interest in the marks and names of others. Crestron is not responsible for
errors in typography or photography. Specifications are subject to change
without notice. ©2015 Crestron Electronics, Inc.
Crestron Electronics, Inc. 15 Volvo Drive | Rockleigh, NJ 07647
Tel: 800.237.2041 / 201.767.3400 | Fax: 201.767.1905
www.crestron.com
All brand names, product names and trademarks are the property of their respective owners.
©2016 Crestron Electronics, Inc. | 15 Volvo Drive | Rockleigh, NJ 07647
Specifications subject to change without notice. 5/1/2016
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising