Configuration Training 53MC5000 Instrument Engineer Course No. 5100

Configuration Training  53MC5000 Instrument Engineer Course No. 5100
53MC5000 Instrument Engineer
Course No. 5100
Basic Configuration and Programming
Configuration Training
The Company
MicroMod Automation is dedicated to improving customer efficiency by providing the most ost-effective, application-specific process
solutions available. We are a highly responsive, application-focused company with years of expertise in control systems design and
implementation.
We offer customers application expertise, service and support worldwide.
We are committed to teamwork, high quality manufacturing, advanced technology and unrivaled service and support.
The quality, accuracy and performance of the Company's products result from over 100 years experience, combined with a continuous
program of innovative design and development to incorporate the latest technology.
Use of Instructions
∆
Warning. An instruction that draws attention to the risk of
injury or death.
!
Caution. An instruction that draws attention to the risk of
the product, process or surroundings.
Note. Clarification of an instruction or additional
information.
‘
Information. Further reference for more detailed
information or technical details.
Although Warning hazards are related to personal injury, and Caution hazards are associated with equipment or property damage, it
must be understood that operation of damaged equipment could, under certain operational conditions, result in degraded process system
performance leading to personal injury or death. Therefore, comply fully with all Warning and Caution notices.
i
Information in this manual is intended only to assist our customers in the efficient operation of our equipment. Use of this manual for any
other purpose is specifically prohibited and its contents are not to be reproduced in full or part without prior approval of ABB
Instrumentation.
Licensing, Trademarks and Copyrights
Micro-DCI is a trademark of MicroMod Automation, Inc.
MODBUS is a trademark of Modicon Inc.
Health and Safety
To ensure that our products are safe and without risk to health, the following points must be noted:
1. The relevant sections of these instructions must be read carefully before proceeding.
2. Warning Labels on containers and packages must be observed.
3. Installation, operation, maintenance and servicing must only be carried out by suitably trained personnel and in accordance with the
information given or injury or death could result.
4. Normal safety procedures must be taken to avoid the possibility of an accident occurring when operating in conditions of high
pressure and/or temperature.
5. Chemicals must be stored away from heat, protected from temperature extremes and powders kept dry. Normal safe handling
procedures must be used.
6. When disposing of chemicals, ensure that no two chemicals are mixed.
Safety advice concerning the use of the equipment described in this manual may be obtained from the Company address on the back
cover, together with servicing and spares information.
Preface
About this book
This training manual is for beginners who are new to the Micro-DCI product line and in
particular, the 53MC5000 Process Control Station (controller). This book is a jumpstart
guide and provides the essentials for understanding the 53MC5000 controller. The tutorials
and labs provided in this book explain the hardware, programming methods, and operation
of the 53MC5000 controller. This book does not cover each and every aspect of
programming, setup, etc, that information can be found in the various Instruction Bulletins
for the product hardware, software and communication options. This book will provide an
aid to understanding the controller and allow the user to start using the instrument
immediately.
P- 1
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising