Flojet Auto shutoff valve replacement

Flojet Auto shutoff valve replacement
Installation For
Model 20308-130
Auto Shutoff Valve Replacement
STEP NO. 2
Move lock on CO2 fitting and unplug from Auto Shutoff
valve. With a small screwdriver locate the slide retainer
clips on the bottom of the pump under the Auto Shutoff
valve. There are two (2), one on each side of the valve.
(See figure #1). Insert screwdriver and push clips as far
as they will go, away from the valve. The Auto Shutoff
valve can be removed without tools. Simply pull the
valve from the pump base.
20 IC
ON, F
RAN
CH, C
T
U
O
A
OUT
IN
STEP NO. 5
Pump should come on and pressurize syrup line. To test
Auto Shutoff valve, remove bag connector and open
dispensing valve, pump should shut off automatically.
Replace bag connector and pump should operate
normally when valve is opened.
T
Slide
Retainer
Clip
C
U
D
R
O
P
Slide
Retainer
Clip
STEP NO. 4
Reconnect product IN line and reset CO2 pressure to
normal operating level. Make sure bag connector is fully
engaged.
Standard
Product Out
Barb Port
3/8" (9.5 mm)
P/N 20325-030
Flojet Brass CO2
Inlet Shutoff Valve
Assemblies
ONE YEAR LIMITED WARRANTY
FLOJET warrants this product to be free of defects in material and/or workmanship
for a period of one year after purchase by the customer from FLOJET. During this
one year period, FLOJET will at its option, at no charge to the customer, repair or
replace this product with a new or reconditioned product, but not remove or install,
in the event that it is found to be defective in material and/or workmanship.
This Limited Warranty does not include service to diagnose a claimed malfunction
in this product at any location other than at Flojet’s corporate head-quarters, nor to
repair damage due to improper installation, incompatibility with accessories not
manufactured by FLOJET, external electrical fault, accident, or misuse.
All other express and implied warranties for this product including the warranties of
merchantability and fitness for a particular purpose, are hereby disclaimed. The
product covered by this warranty is marketed and sold by FLOJET as a business
rather than consumer product. (Some jurisdictions do not allow the exclusion of
implied warranties nor limitations on how long an implied warranty lasts, so the
above limitations may not apply to you.)
If this product is not free of defect as warranted above, your sole and exclusive
remedy shall be repair or replacement as provided herein. In no event will FLOJET
be liable to customer or to any third party for any damages in excess of the
purchase price of the product. This limitation applies to damages of any kind
including any direct or indirect damages, lost profits, lost investment capital or
savings, or other special, incidental, tort or otherwise, or whether arising out of the
use or inability to use such product even if FLOJET has been advised of the
possibility of such damages or of any claim by any other party. (Some jurisdictions
do not allow the exclusion or limitation of incidental or consequential damages for
some products, so the above limitations or exclusions may not apply to you.)
This warranty gives you specific legal rights. You may also have other rights which
may vary from jurisdiction to jurisdiction.
Optional Stainless Steel
Product Out Barb Ports
1/4"
(6.3 mm)
P/N 1510-000
1/4"
(6.3 mm)
1/4"
(6.3 mm)
1/4"
(6.3 mm)
P/N 20324-30
P/N 20607-100
P/N 1521-000
1/4"
(6.3 mm)
1/2"
(12.7 mm)
3/8"
(9.5 mm)
P/N 20606-100
P/N 1520-000
P/N 20608-100
U.S.A.
Flojet
20 Icon
Foothill Ranch, CA 92610-3000
Tel: (949) 859-4945
Fax: (949) 859-1153
Printed in U.S.A.
HILL
IN
STEP NO. 3
Insert new valve. Push valve into pump base as far as it
will go, slide clips in and “snap” into place. Plug in CO2
connection and secure retainer clips.
© Copyright 2001, ITT Industries
OOT
S
A
G
TO V
DIS
CHAENT
TOINGSTA
RG CO2
AS LL
OUHTOSE
E
Model 20308-130 Auto Shutoff Valve
STEP NO. 1
Turn off CO2 supply and open dispensing valve to
relieve syrup pressure. Disconnect product IN line.
UNITED KINGDOM
Flojet, Unit 1, Avant Business Centre
Denbigh West Industrial Estate
Milton Keynes, Bucks, England MK1 1DL
Tel: 44 1908 370088
Fax: 44 1908 373731
All Rights Reserved
Form: 81000-049
11/01
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising