AC6310 POWER SUPPLY MODULE

AC6310 POWER SUPPLY MODULE
Product Specification
BCN / Kari Mäki
September 13, 2010
AC6310
1(1)
AC6310 POWER SUPPLY MODULE
AC6310 PSU will be used in AC8000/8800 optical nodes. It can work alone or it
can be operated parallel to split the work load and create the redundancy
system for internal power feeding. The PSU will be installed inside at the lid of
the optical node. The output voltage will be monitored by the EMT module.
All accessories needed in installation are included when PSU is ordered
separately.
Technical specifications
Parameter
Specification
Note
Input voltage
Output voltage 1
Output voltage 2
Output current 1
Output current 2
Max. output power
Ripple voltage
Efficiency
Operating temperature
EMC
Safety
Dimensions
27...65 VAC / 35...90 VDC
24 Vdc
12 Vdc
1400 mA
900 mA
40 W
< 20 mV p-p
20 Hz < f < 1 kHz
> 81 % (Vin > 35 VAC)
- 40...+ 55 °C (for the AC8000)
EN 50083-2
EN 50083-1
95 x 95 x 25 mm
AC6310_spec_v20.doc, created on June 9, 2010, printed on September 13, 2010
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising