Freedom Manual
Easy Installation Guide
Attach this end to your wall
C
A
Installing your Heavy Duty
Plasma Wall Mount, PWM-S/HD
1) Mark the mounting position for the PWM-S/HD bracket on your
wall and ensure the cable entry hole is located a minimum of 70mm
below the wall-mounting plate. Cables should be fastenedto the
underside of the lower front swivelarm
2) Secure the PWM-S/HD wall bracket (C) to your wall using the
appropriate fasteners for your wall type (supplied). Confirm that
the anchor points are sufficiently strong to support the bracket and
your screen when at full externsion.
3) Carefully check the mounting positions on the back of your screen.
Compare these positions to the holes already cut into the front plate
(A). If there are no matching holes then drill the appropriate sized
holes into the front plate (A) to allow mounting of the screen.
4) Extend the PWM-S/HD away from the wall and using at least
2 people, lift the screen into position in front of the front plate (A).
Using the appropriate cap screws provided attach the screen to
the front plate.
NOTE: Check the screw length against that specified by the screen
manufacturer to ensure no damage is caused to the screen.
NOTE: Ensure that the wall structure can carry the total weight of
the mount and screen when at full extension.
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE
PROPERTY OF ULTRALIFT AUSTRALIA PTY LTD. ANY
REPRODUCTION INPART OR AS A WHOLE WITHOUT THE
WRITTEN PERMISSION OF ULTRALIFTAUSTRALIA IS PROHIBITED.
REVISIONS
REV.
DESCRIPTION
DATE
APPROVED
ULTRALIFT AUSTRALIA PTY LTD
10 VERNON AVE
HEIDELBERG HEIGHTS VIC 3081
Phone: 03 9459 0873
Fax: 03 9457 6686
Email: sales@ultraliftaustralia.com.au
www.ultraliftaustralia.com.au
DO NOT SCALE
AS1100-1992
UNLESS OTHERWISE SPECIFIED:
DIMENSIONS IN MILLIMETERS
DEBUR & REMOVE SHARP EDGES
LINEAR TOLERENCE 0.1
ANGULAR TOLERENCE 0.5
SURFACE FINISH N8
DRAWN: TM
DATE: 11/26/2007
FILE:
Installation Guide
PART NAME: PWM-S/HD
PART NO: Installation Guide
DRAWING NO: 1
MATERIAL: Material
PRODUCT MODEL: ULA-PROD
QTY. REQ'D: Quanitity REVISION:
SCALE: 1:1
SHEET SIZE: A4
SHEET NO: 1 OF 1
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising