MOTOMCO MOTOMCO MOLE KILLER MSDS5900

MOTOMCO MOTOMCO MOLE KILLER MSDS5900
MOTOMCO MOLE KILLER MSDS
MANUFACTURED FOR:
MOTOMCO LTD. 29 N. FORT HARRISON
CLEARWATER, FL 33755
PRODUCT NAME: MOTOMCO
PREPARED BY:
TELEPHONE NO:
EMERGENCY PHONE NOS:
Medical
(877) 854-2494
Transportation (Spills)
(800) 424-9300 CHEMTREC
(800) 237-6843
CAR
MOLE KILLER
USE:
BAIT FORM:
Acute Mole Bait
MSDS5900
EPA REGISTRATION NO.
12455-101-3240
Formulated Bait
SECTION I. HAZARDOUS INGREDIENTS
INGREDIENT NAME
% BY WEIGHT
CURRENT TLV
0.025 %
N/A
Bromethalin [N-Methyl-2,4-dinitro-N-(2,4,6-tribromophenyl)-6(trifluoromethyl)benzenamine] CAS No. 63333-35-7
This product contains no components subject to the reporting requirements of Section 313 of the Superfund
Amendment and Reauthorization Act (SARA) of 1986
SECTION II. PHYSICAL DATA
APPEARANCE:
Worm-like cylinder
COLOR:
ODOR:
VAPOR DENSITY:
N/A
MELTING POINT:
N/A
WATER REACTIVITY:
N/A
EVAPORATION RATE:
N/A
VAPOR PRESSURE:
N/A
BOILING POINT:
N/A
SOLUBILITY:
Not soluble in water
BULK DENSITY:
N/A
Amber
SPECIFIC GRAVITY:
1.13g/ml
Pungent
SECTION III. FIRE AND EXPLOSION DATA
FLASH POINT (Method Used):
N/A
FLAMMABLE LIMIT:
Upper Limit: N/A
Lower Limit: N/A
AUTOIGNITION TEMP:
N/A
EXTINGUISHING MEDIA:
Extinguish with water, foam or inert gas
SPECIAL FIREFIGHTING PROCEDURES:
Firefighters should be equipped with protective clothing and self-contained breathing apparatus.
UNUSUAL FIRE OR EXPLOSION HAZARDS:
None
SECTION IV. REACTIVITY HAZARD DATA
STABILITY:
Stable
CONDITIONS TO AVOID:
None
POLYMERIZATION:
Will not occur
CONDITIONS TO AVOID:
None
INCOMPATIBILITY (MATERIALS TO AVOID):
Strongly alkaline materials
HAZARDOUS DECOMPOSITION PRODUCTS:
Oxides of carbon and nitrogen, hydrobromic acid
SECTION V. TOXICITY DATA
LD50, ORAL (INGESTION):
2000 mg/kg (rats)
LD50, DERMAL (SKIN CONTACT):
>5001 mg/kg (rats)
LC50, INHALATION:
N/A
EYE IRRITATION:
Minimally Irritating (rabbits)
SKIN IRRITATION:
Non-Irritating (rabbits)
DERMAL SENSITIZATION:
Mild Sensitizer
Trade Name: MOTOMCO MOLE KILLER
Supplier: Motomco Ltd.
Date Created: 16 November 2004
Page 1 of 2
MOTOMCO MOLE KILLER MSDS
SECTION VI. HEALTH HAZARDS
PRIMARY ROUTE OF ENTRY:
Ingestion
SIGNS & SYMPTOMS OF EXPOSURE:
Headache, confusion, personality change, tremors, convulsive seizures, respiratory distress
EMERGENCY FIRST AID PROCEDURES:
Eyes: Flush with cool water for at least 15 minutes. If irritation develops, obtain medical assistance.
Skin: Wash with soap and water. If irritation develops, obtain medical assistance.
Ingestion: Call physician or emergency phone number immediately. Do not give anything by mouth or induce vomiting unless instructed
by physician.
Inhalation: None.
NOTE TO PHYSICIAN: If ingested, limit absorption by either emesis or gastric lavage. Sublethal symptoms, if present, would be the
result of cerebral edema and should be treated accordingly through administrations of an osmotic diuretic and corticosteroid.
SECTION VII. CONTROL AND PROTECTIVE MEASURES
RESPIRATOR TYPE:
Not required
EYE PROTECTION:
Not required
GLOVES (Recommended):
Rubber Gloves
VENTILATION:
Not required
OTHER PROTECTIVE MEASURES:
Not required
NATIONAL FIRE PROTECTION ASSOCIATION (NFPA) RATINGS:
HEALTH: 2 (Moderate)
FIRE: 0 (Will not burn)
REACTIVITY: 0 (Stable)
SPECIFIC HAZARD: None
HAZARDOUS MATERIAL INFORMATION (HMIS) RATINGS:
HEALTH: 2 (Moderate) FLAMMABILITY: 0 (Minimal) REACTIVITY: 0 (Minimal)
PROTECTIVE EQUIPMENT: B
SECTION VIII. SPILL OR LEAK PROCEDURES
STEPS TO BE TAKEN IN THE EVENT MATERIAL IS RELEASED OR SPILLED:
Sweep up spilled material, place in properly labeled container for disposal or re-use.
WASTE DISPOSAL METHOD:
Wastes resulting from use may be disposed of on-site or at an approved waste disposal facility. Dispose of all wastes in accordance with
all Federal, state and local regulations.
SECTION IX. SPECIAL PRECAUTIONS AND STORAGE DATA
STORAGE TEMPERATURE:
Room temperature
AVERAGE SHELF LIFE:
Bait is stable for a minimum of 1 year when stored at room temperature
SPECIAL SENSITIVITY (HEAT, LIGHT, MOISTURE):
Avoid exposure to light and extreme humidity
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE:
Store in a cool, dry place inaccessible to children, pets and wildlife. Keep container tightly closed when not in use. Avoid contamination
of lakes, streams and ponds by use, storage or disposal. Wash thoroughly with soap and water after handling.
SECTION X. SHIPPING DATA
DOT SHIPPING NAME:
None required
DOT HAZARD CLASSIFICATION:
Non-hazardous
DOT LABELS REQUIRED:
None required
FREIGHT CLASSIFICATION:
LTL Class 60
WARRANTY: The information provided in this Material Safety Data Sheet has been obtained from sources believed to be reliable. Motomco Ltd. provides no warranties,
either expressed or implied, and assumes no responsibility for the accuracy or completeness of the data contained herein. This information is offered for your consideration
and investigation. The user is responsible to ensure that they have all current data relevant to their particular use.
Trade Name: MOTOMCO MOLE KILLER
Supplier: Motomco Ltd.
Date Created: 16 November 2004
Page 2 of 2
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising