INSTALLATION INSTRUCTIONS Display Radio Camera Interface for Chrysler, Dodge, Jeep

INSTALLATION	INSTRUCTIONS Display Radio Camera Interface for Chrysler, Dodge, Jeep
INSTALLATIONINSTRUCTIONS
Display Radio Camera Interface for Chrysler, Dodge, Jeep
For Radios RA2, RA3, RA4
(Kit # 9002-2733)
Please read thoroughly before starting installation and check that kit contents are complete.
Items Included in the Kit:
Factory T harness
9002-2733 module
Accessory Power output harness
These instructions
Tools & Supplies Needed:
Wire cutters
Wire strippers
Zip ties
Electrical tape
Heat shrink
Tox t20
7mm socket
Plastic panel removal tools
Safety Precautions:
• Work in well ventilated area that is clear of obstructions.
• Secure vehicle with tire chucks in both front and rear of tires.
• Turn vehicle accessories OFF and ensure ignition key is in OFF position.
• Wear safety goggles and snug fitting clothes.
• Use tools only for their intended purpose and which are in good repair.
• Only perform this task if confidence, skill, and physical ability permit.
NOTE: We strive to provide accurate and up-to-date installation instructions. For the latest full color
instructions, as well as an installation video, please visit www.brandmotion.com
Set Dip Switches First!!!!!
2733 Instructions 3-23-16
Page 1 of 3
INSTALLATIONINSTRUCTIONS
SET DIP SWITCHES BEFORE DOING INSTALL
DIP SWICTH SETTINGS---001110
Switch key: OFF/0 ON/1
2733 Instructions 3-23-16
Page 2 of 3
INSTALLATIONINSTRUCTIONS
10. Connect the ground for the camera to the
black wire on the 12-pin connector.
1. Remove trim around screen/display.
11. Do not use the reverse wire output for this
install.
2. Remove screws that hold screen to dash.
12. Turn the ignition off, shut and lock the
doors. Then turn ignition back on after 5
minutes to test the camera. Start the
vehicle, press the parking brake and shift
into reverse to see the image. (This set may
have to be repeated a second time for CAN
in vehicle to accept the program from the
interface module).
13. If back up camera image stays on when the
vehicle is placed back into park go to next
step. If screen goes back to radio display
then install is done.
14. After install is complete turn off ignition,
close all doors and disconnect the positive
terminal on the battery for 5 minutes.
3. Disconnect main 52-pin harness from the
back of the screen by lifting up on the
“handle” to release the plug.
4. Plug in the main 52-pin factory harness that
was just unplugged, into the female end of
the T harness.
5. You will have to remove the 6-to-4 pin
jumper harness from the T-harness before
the next step.
6. Connect the 6-pin plug on the T-harness to
the 9002-2733 module.
7. Plug in the male 52-pin plug from the T
harness into the factory screen/display.
Lock the plug in by pushing down on the
“handle”.
8. Connect the camera RCA to the yellow RCA
on the 9002-2733 module labeled cam
input.
9. Connect the power for the camera to the
+12 volt accessory wire to the orange wire
on the 12-pin connector.
2733 Instructions 3-23-16
Page 3 of 3
15. Reconnect the battery, check camera again
by placing vehicle in reverse.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising