ramvb188
Item Number
RAM-VB-188 & RAM-VB-188-SW1
RAM No-Drill TM Seat Bases
National Products, Inc.
Vehicle base for the
DODGE JOURNEY (2011-2015)
FORD C-MAX (2014-2015)
FORD ESCAPE (2013-2015)
FORD FOCUS (2011-2015)
FORD TRANSIT CONNECT (2014-2015)
JEEP COMPASS (2013-2015)
JEEP PATRIOT (2013-2015)
SPECIFICATIONS
Placement
Passenger side, in front, where seat frame meets
floor board.
Drilling Required
None - uses existing seat bolts
Seat Configuration
Bucket
Complete Vehicle Mount
RAM-VB-188-SW1
Pole or Pedestal
Ordered Separately
Construction/Finish
Steel/Black Powdercoat
Dimensions
A = 15.5", B = 7", C = 1.95",
Hole Center = 13.56"
B
Features
Installs in minutes with no drilling required. Placement is over the top
of the seat frame legs at floor board level. Rock solid construction
Lifetime warranty
A
C
Vehicle Base
RAM-VB-188
National Products, Inc.
8410 Dallas Ave S
Seattle, WA 98108
Phone: (206) 763-8361
Fax: (206) 763-9615
Website: www.ram-mount.com
Email: staff@ram-mount.com
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
Item Number
RAM-VB-188 & RAM-VB-188-SW1
RAM No-Drill TM Seat Bases
National Products, Inc.
Vehicle base for the
DODGE JOURNEY (2011-2015)
FORD C-MAX (2014-2015)
FORD ESCAPE (2013-2015)
FORD FOCUS (2011-2015)
FORD TRANSIT CONNECT (2014-2015)
JEEP COMPASS (2013-2015)
JEEP PATRIOT (2013-2015)
INSTALLATION INSTRUCTIONS
Depending on your make and model, there may be pieces of plastic trim that cover the lower front of the seat frame
legs. This will need to be removed and stored. If you wish to reinstall this piece of trim, you will have to modify it to fit
over the stamped metal base.
1.
Move the passenger side seat to its rearmost position. Using an 18MM wrench, loosen and remove the two
bolts holding the seat frame legs to the floor board.
2.
Place the No-Drill™ base over the seat frame legs with the pedestal platform near the center of the vehicle.
3.
Re-install the two seat frame bolts. Start the thread by hand and then fully tighten with the 18MM wrench.
Ford Transit Connect:
1.
Move the passenger side seat to its rearmost position. Using an socket wrench, loosen and remove the two
bolts holding the seat frame legs to the floor board.
2.
Place supplied stand offs over the holes in the seat frame legs. Next place the No-Drill™ base over the stand
offs with the pedestal platform near the center of the vehicle.
3.
Using the longer bolts provided, start the thread by hand and then fully tighten the bolts passing through the
base, stand offs, and into the floor board.
National Products, Inc.
8410 Dallas Ave S
Seattle, WA 98108
Phone: (206) 763-8361
Fax: (206) 763-9615
Website: www.ram-mount.com
Email: staff@ram-mount.com
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising