4 steel bushing kits
WYCO Quick Reference
REPLACING STEEL BUSHING KITS ON
WYCO BACKPACKS
4
(FOR FULL INSTRUCTIONS AND SAFTEY DETAILS REFER TO OPERATORS MANUAL)
1) Disconnect the throttle cable from the
throttle lever.
4) With the engine removed, take off the socket
head screw and remove the engine mount.
2) Remove the four socket head screws from
the speed increaser.
5) Clamp the speed increaser housing into a vise.
Using a 3/4” open head wrench, remove the
quick disconnect assembly.
3) Using a snap ring pliers, remove the retaining ring, them remove the engine from the
frame.
6) To remove the hex driver, take a vise grip and
clamp down on the clutch drum. With the
clutch drum secure, use a 5/16” allen wrench
to remove the hex driver
WYCO Quick Reference
REPLACING STEEL BUSHING KITS ON
WYCO BACKPACKS
4
(FOR FULL INSTRUCTIONS AND SAFTEY DETAILS REFER TO OPERATORS MANUAL)
7) Insert the new quick disconnect sleeve into
the speed increaser housing. Apply Loctite
609 retaining compound to the sleeve. Make
sure the hole in the sleeve is aligning with
the hole in the housing, then press into place.
8) After the new quick disconnect sleeve has
been pressed in, the speed increaser housing
should look like the picture above.
9) Disassemble the old quick disconnect
assembly. Disregard the pigeon piece (piece
circled) and keep the rest. Apply the new
pigeon into the quick disconnect assembly.
10) Insert the new quick disconnect adapter.
Reattach the throttle cable to the throttle
lever.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising