ART 600VA
LINE INTERACTIVE UPS
USER MANUAL
CONTENTS
1. Introduction
2. Safety Caution
3. System description
4. Specification
5. Installation and operation
6. Battery
7. Trouble Shooting
1
2
4
5
6
8
9
I
400/600/800 VA UPS User’s Manual
To insure safe installation and assure the best possible benefit from the
product, please read this manual before installing and using your UPS.
1. Introduction
This UPS is specially designed for Personal Computer with multifunctions. Its light weight, compact design perfect fits to the limited working
environment. The line of UPS is equipped with boost and buck AVR to
stabilize input voltage range. It is also built-in with DC start function. This
function enables the UPS to be started up without AC power supplied.
Although it’s a small UPS, it’s equipped with Smart RS-232 Communication
Port to offer users more benefits. The download software helps users
monitor UPS inside status. The main features of UPS are listed below:









Microprocessor control guarantees high reliability.
Equipped with Boost and Buck AVR.
Built-in RS-232 Communication Port.
Free Software Download from the Internet.
(Please check Free Software Download in Installation & Operation
for detail information).
Green Power Function for energy saving.
DC Start Function.
Auto restart while AC recovery.
Compact size, Light Weight.
Provides Modem/Phone line surge protection.
1
2. Safety – CAUTION!
 This UPS utilizes voltages that may be hazardous. Do not attempt to
disassemble the unit. The unit contains no user serviceable parts. Only
factory service personnel may perform repairs.
 Connection to any other type of receptacle other than a two-pole, threewire grounding receptacle may result in shock hazard as well as violate
local electrical codes.
 In the event of an emergency, turn the power switch to the “off” position
and disconnect the power cord form the AC power supply to properly
disable the UPS
 Do not allow liquids or any foreign object to enter the UPS. Do not place
beverages or any other liquid-containing vessels on or near the unit.
 Avoid installing the UPS in locations where there is standing or running
water, or excessive humidity.
 Do not plug the UPS’ power cord into itself.
 Do not attach a power strip or surge suppressor to the UPS.
 Do not attach non-computer-related items, such as medical equipment,
life-support equipment, microwave ovens, or vacuum cleaners to UPS
 To reduce the risk of overheating the UPS, do not cover the UPS’
cooling vents and avoid exposing the unit to direct sunlight or installing
the unit near heat emitting appliances such as space heaters or
furnaces.
 Unplug the UPS prior to cleaning and do not use liquid or spray
detergent.
 Do not dispose of battery or batteries in a fire. The battery may
explode.
 Do not open or mutilate the battery or batteries. Released electrolyte is
harmful to the skin and eyes. It may be toxic.
 A battery can present a risk of electrical shock and high short circuit
current. The following precautions should be observed when working on
batteries :
1) Remove watches, rings, or other metal objects.
2) Use tools with insulated handles.
3) Wear rubber gloves and boots.
 Servicing of batteries should be performed or supervised by personnel
knowledgeable of batteries and the required precautions. Keep
unauthorized personnel away from batteries.
 When replacing batteries, replace with the same number of the sealed
lead-acid batteries.
2
★Wichtige Sicherheitshinweise
Bitte lesen Sie diese Hinweis sorgfaltig durch.
 Vor jedem rcinigen ist das Gerät vom Stromnetz zu trennen.
Verwenden Sie Keine Flüssig-oder Aerosolreiniger. Am besten eignet
sich ein angefeuchtetes Tuch zur Reinigung.
 Das Gerät ist vor Feuchtigkeit zu schützen.
 Öffncn Sie niemals das Gerät. Das Gerät darf aus Gründen der
elektrischen Sicherheit nur von authorisicrtem Servicepersonal
geöffnct Wcrdcn.
 Bei der Installation is darauf zu achten, das der Gesamtableitstrom
der USV und der and der USV angeschlossenen Verbraucher den.
Maximalwert von 3.5mA nicht überschreiten.
 VORSICHT: Explosionsgetahr bei unsachgemäßen Austausch der
Batterie. Ersatz nur durch denselben order einem vom Hersteller
empfoblenem ähnlichen Typ. Entsorgung gebrauchter Batterien nach
Angaben des Herstellers.
3
3. System Description
Front Panel
1.
2.
Power Switch
LED Indicators –
AC Mode: Green lighting
Battery Mode: Green flashing
Back Panel—
1. Output receptacles
2. AC input with AC fuse
3. Modem/Phoneline Surge Protection
4. Communication Port
5. Circuit Breaker
4
3
2
5
1
4
4. Specification
Specificatio
nMODEL
CAPACITY
INPUT
OUTPUT
BATTERY
TRANSFER
TIME
400 VA
800 VA
VA/W
400VA/240W 600VA/360W 800VA/480W
VOLTAGE
220VAC
VOLTAGE
165-260VAC + 5%
RANGE
FREQUENCY
47-63 Hz (Auto Sensing)
VOLTAGE
220VAC
VOLTAGE
REGULATION
+/-10%
(Batt. Mode)
FREQUENCY
50Hz or 60Hz
FREQUENCY
REGULATION
+/-1 Hz
(Batt. Mode)
OUTPUT
MODIFIED WAVEFORM
WAVEFORM
BATTERY TYPE
12V/7AH x 1
12V/7AH x 1
12V9Ahx 1
& NUMBER
10 MINUTES AT 8 MINUTES AT 10 MINUTES AT
BACK UP TIME
HALF LOAD
HALF LOAD
HALF LOAD
RECHARGE
8 HOURS TO 90% AFTER COMPLETE
TIME
DISCHARGE
TYPICAL
AC MODE
BACKUP MODE
BACKUP MODE
BATTERY LOW
AUDIBLE
ALARM
OVERLOAD
FAULT
FULL
PROTECTION
PROTECTION
DIMENSION
PHYSICAL
(MM), DXWXH
WEIGHT
NET WEIGHT
OPERATING
ENVIRONMENT ENVIRONMENT
NOISE LEVEL
INDICATOR
INTERFACE
600 VA
SMART RS-232
LESS THAN 6MS
GREEN LIGHTING
GREEN FLASHING
SOUNDING EVERY 10 SECONDS
SOUNDING EVERY 1 SECOND
SOUNDING EVERY 0.5 SECONDS
CONTINUOUS SOUNDING
DISCHARGE, OVERCHARGE, AND
OVERLOAD PROTECTION
330X100X140
6KGS
6KGS
6,5 KGS
0- 40°C, 0-90 % RELATIVE HUMIDITY (NONCONDENSING)
LESS THAN 40dB
SUPPORT WINDOWS 95/98/NT/2000,
NOVELL AND LINUX
5
5. Installation and Operation
1. Inspection
Remove the UPS from its packaging and inspect it for damage that may
have occurred during shipping. If any damage is discovered, repack the
unit and return it to the place of purchase.
2. Charging
This unit is shipped from the factory with its internal battery fully charged,
however, some charge may be lost during shipping and the battery
should be recharged prior to use. Plug the unit into an appropriate power
supply and allow the UPS to charge fully by leaving it plugged in for at
least 8 hours with no load (no electrical devices such as computers,
monitors, etc.) connected.
3. Placement
Install the UPS unit in any protected environment that provides adequate
airflow around the unit, and is free from excessive dust, corrosive fumes
and conductive contaminants. Do not operate your UPS in an
environment where the ambient temperature or humidity is high. On the
other hand, place the UPS away from the monitor at least 20cm to avoid
interference.
6
4. Connection
Plug the UPS into a 2-pole, 3-wire grounded receptacle. Then connect one
computer-related device into each of the power receptacles supplied on the
back of the UPS.
5. Turn On/Off
To turn on the UPS unit, press the power switch lightly. To turn off the
UPS unit, press the power switch again.
6. DC Start
This Series are equipped with DC Start. To start the UPS when AC utility
power is not available, simply press the power switch.
7. Green Power Function
This UPS is equipped with Green Power Function. If no load connects to
the UPS, it will automatically shut down in 2 minutes for energy saving while
power failure.
8. Free Download Software – Win Power
Win Power is a brand new UPS monitoring software, which provides
user-friendly interface to monitor and control your UPS. This unique
software provides safely auto shutdown for multi-computer systems
while power failure. With this software, users can monitor and control
any UPS on the same LAN no matter how far from the UPS.
Installation procedure:

Go to the website:
http://www.ups-software-download.com/winpower.htm

Choose the operation system you need and follow the instruction
described on the website to download the software.

When downloading all required files from the internet, enter the serial
No: 511C1-01220-0100-478DF2A to install the software.
When your computer restarts, the Win Power software will appear as a
green plug icon located in the system tray, near the clock.
7
6. Battery
UPS has a battery that expected trickle life 3-5 years. The battery is stored
without charging 3 Months and temperature above 40°C trickle life is shorter
than expected. Store the battery after fully charging it otherwise its life may
be shorted. Battery must be charge every three months.
Battery discharge time is changed load and charge level.
Caution
1. When replacing batteries, replace with the same number of the sealed
lead-acid batteries.
2. The following precautions should be observed when working on
batteries :
1. A battery can present a risk of electrical shock and high short
circuit current
2. Do not short the battery terminals.
3. Do not charge in a gas tight container.
4. Do not dispose of battery or batteries in a fire.
5. Flush with water at once if contact is made with electrolyte
(acid)
Store
The Battery gradually loses its capacity due to self is charge during storage.
If the battery is used without being charge ,its capacity may not be fully
utilized.



The battery is not stored without charging.
The stored Temperature of battery beloved 40°C
The battery is charged ever three months.
8
7. Trouble Shooting
Symptom
Possible Cause
No LED display 1. Missing battery.
on the front
2. Battery defect.
panel.
Remedy
1. Charge battery up to 8 hours.
2. Replace with the same type of
battery.
3. Press and Hold power switch
for at least 5 seconds.
3. Power switch is not
pressed at least 5
seconds.
Overload of the UPS.
Alarm buzzer
Verify that the load matches the
beeps
UPS capability specified in the
continuously
specs.
when AC
supply is
normal.
When power
1. Overload of the UPS. 1. Remove some non critical
failure, back-up
load.
time is shorten. 2. Battery voltage is too 2. Charge battery 8 hours or
low.
more.
3. Battery defect due to
3. Replace with the same type of
high temperature
battery.
operation environment,
or improper operation to
battery.
Mains normal 1. Fuse is blown.
1. Replace the same type of
but LED is
fuse.
flashing.
2. Power cord is loose.
2. Reconnect the power cord
properly.
9
ARTronic Elektronik San. Müm. Tic. Ltd. Şti
Adres : İMES Sanayi Sitesi, D Kapısı Karşısı,
Kuru Sk. No:26 Y.Dudullu – İstanbul
Tel
: + 90 216 365 82 21 (pbx)
Faks
: + 90 216 420 97 70
Web
: www.artronic.com.tr
E-posta : artronic@artronic.com.tr
Download PDF