Okamoto ACC.8.20ST
15150 – 25th Avenue North, Minneapolis, MN 55447-1981
Phone 763-476-8600 Fax 763-476-4092 Visit us at: www.productivity.com
Service Dept: (MN) 763-476-4191 (IA) 319-632-4288 (NE) 402-330-2323
Productivity is ISO 9001:2000 Certified
Productivity Inc®
Okamoto ACC-8.20ST PRE-INSTALLATION CHECKLIST – Rev 11/2008
Installation of your new Okamoto ACC-8.20ST can be smooth and rapid if preparations are made prior to the
delivery of your machine. Any questions regarding machine installation should be directed to our service
department for clarification. We hope this checklist will aid in a rapid installation of your new machine. NOTE: The
following must be completed prior to our service technician arriving to install your new machine.
¾
Power Requirements for your machine:
230v/3ph/4.5kVa, 15 Amps (460v/3ph/4.5kVa, 10 Amps)
Proper voltage per machine specifications should be ready at machine site. Do NOT power up the machine.
Note: Machine has dual voltage capabilities. Usually wired to 460v unless otherwise specified.
¾
Customer should furnish and have available the proper supply and types of lubricants required for machine
operation at the time of installation.
ITEM
Coolant
Hydraulic Fluid
¾
CAPACITY
31 Gallon (30-1 mix water to coolant)
21 Gallons
FLUID TYPE
Water Soluble Type
Mobil Vacuoline #1405
Air lines should be routed to the machine location and operational for proper air pressure.
Not applicable.
¾
Machine location should be planned to allow enough room for access panels to be opened and serviced with
ease.
¾
Weight requirements should be checked to insure that the surface below the machine would have sufficient
strength for support and stability. The machine must be set on a solid, sound and stable, steel bar-reinforced
concrete slab poured directly on the grade. In general, the 6” concrete floor on industrial buildings is suitable
for machine placement.
¾
The Okamoto Grinder can be moved using either a forklift or overhead crane; however, you will need to
unpack the machine to access the lifting apparatus. Upon arrival of your machine, unpack and immediately
check for visible damage.
SHIPPING WEIGHT
SHIPPING DIMENSIONS OF MACHINE
3,500# (mach crated)
87” L x 68” W x 89” H (machine crated)
300# (accessory skid)
4’L x 4’W x 4’H (skidded – Optional Coolant System, Chuck, etc.)
Operational Dimensions/Floor Space: 94” L* x 64” W x 68” H (*If using a coolant tank, you should plan to
leave an additional 2’ on the left side of the machine.) Also allow an extra 36” behind the machine for
maintenance. Off skid weight is 3,000#.
¾
Remove as much preservative from the machine as possible without having to power up (tables –
slides, pulleys, etc.). We recommend mineral spirits to clean. Apply oil when finished to prevent rust.
PLEASE FORWARD THIS TO THE APPROPRIATE PERSON. THANK YOU.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising