19556 19556 MARK LT MARK LT

19556 19556 MARK LT MARK LT
19556
19556
MARK LT
MARK LT
06 LINCOLN
06 LINCOLN
Mark LT Logo Plate
Recommended Tools:
10mm Wrench or Nut Driver
Wire Cutters
Parts List / Hardware:
1
2
2
Billet Logo Plate
10-32 Nylon Lock Nuts
#10 Fender Washers
Read and understand instructions before attempting installation
Step 1
This billet plate allows the factory logo
to be installed on a T-Rex billet grille.
Carefully remove the small metal
retaining fasteners securing the logo.
Use a small slotted screw driver to pry
the clips up. Now carefully twist off the
fasteners.
Step 2
Center the billet plate into the factory
logo. Secure one of the factory fasteners
to the center post. Use a wire cuter to
trim the plastic posts on top and bottom.
Step 3
The back of the plate has two threaded studs that secure the logo. Center the logo onto the billet
grille; use the washers and nuts to retain the logo.
Thank you for purchasing your T-Rex billet grille. 8/10/05
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising