B.E.A. KM 3100 K Automatic Door Controller Instruction manual
Below you will find brief information for Automatic Door Controller KM 3100 K. The KM 3100 K is a door controller for use with a Commander System, providing an automated solution for door operation with additional features such as LATCH ASSIST, PUSH-N-GO, and a STACK PRESSURE setting. The controller offers a combination of functions to enhance accessibility, safety, and performance. It can be paired with a wide range of door types, making it a versatile solution for a variety of applications.
Advertisement
Advertisement
Advertisement
Key features
- Latch assist
- Push-n-go
- Stack pressure
- Commander system
- Micro-switch
- Dual control
- Calibration switch
- Safety beam option
- Technical support
Frequently asked questions
The "LO-21K" switch is used for stack and latch assist functions. It needs to be wired to a micro-switch located on the operator oriented 180 degrees from the closed latch speed switch. This ensures the proper voltage is supplied to the "LO-21K" for accurate functionality.
After the initial power-up, activate "SW-1" once and then remove the provided jumper. This jump should be stored on the 1 post for future use.
The "SW-1" switch has four settings: 1. PUSH-N-GO, 2. LATCH ASSIST, 3. RATCHET FUNCTION, and 4. STACK PRESSURE. Select the desired function for your door operation.
Contact B.E.A. Inc. for technical support during eastern standard time at 1-800-523-2462 from 8AM to 5PM.