GEARTOOTH SPEED SENSOR GS1001–GS1002 Series Circuit-protected, Hall-effect geartooth speed sensor with adjustable stainless steel housing. Features Senses motion of ferrous geartooth targets Cable version: 22 AWG, tin plated with drain wire and polyolefin insulation Near zero speed sensing capability Connector version: M12 integral connector meets IEC 60947-5-2 for low voltage devices Immune to rotational alignment 10 bit dynamic threshold detection offers Stainless steel housing - Automatically adjusting magnetic range - Self compensating to target geometry Applications - Immune to target run out Compatible with unregulated power supply CNC machine tools Reverse battery protected to -24 V DC Transmission speed Internal circuit protection to IEC 1000 Industrial feedback control - EMI resistant to 10 V/m, 26 MHz to 1 GHz - ESD resistant to 4 kV (contact discharge) - Fast transient resistant to 2 kV - Conducted immunity resistant to [email protected] from 150kHz to 80MHz - EMC c ompatible 3 0 A/[email protected] Hz Specifications Part Number Operating Supply Voltage Range Current (VDC) (mA max.) Output Output Output Saturation Voltage Current (mV max.) (mA max.) Operating Temp Range (°C) GS100101 5.0 – 24 6 sink 400 20 GS100102 5.0 – 24 6 sink 400 20 Storage Temp Range (°C) Thread Barrel Length Cable Connector – 40 to 125 – 40 to 125 M12-1 65mm 12 mm circular – 40 to 125 – 40 to 125 M12-1 65mm 22 AWG x1 m BBB Notes: These sensors require the use of an external pull-up resistor, the value of which is dependent on the supply voltage. See page 27 for recommendations. Pull-up resistor should be connected between output and Vcc. Dimensions inches (mm) All tolerances ±0.005 (0.13) unless otherwise noted. 4 Open Collector Sinking Block Diagram 3 Magnet Leads Optional 1 PIN 2 Not Used .40 (10.2) VCC 1 (brown) Pull-up Resistor 4 Output (black) 3 Ground (blue) 2.58 (65.5) 15 Specifications subject to change without notice.
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project