SPEAKMAN COMPANY
SE-227 Installation, Maintenance & Operation Instructions
LIFESAVER
® EMERGENCY SHOWER
DESCRIPTION
Emergency deluge shower supplied with stay-open full flow ball valve, activated by triangular pull rod.
SPECIFICATIONS
SHOWER HEAD: 8” Dia. CYCOLAC
® Yellow Plastic.
FLOW CONTROL: Internal 20 gpm Regulator.
VALVE: 1” NPT Female Brass, Chrome-Plated. Stay-Open Valve.
ACTIVATOR: Powder Coated Yellow, Aluminum Triangular Pull Rod.
INLET: 1” NPT Female.
PIPE: 1” IPS Galvanized Steel.
SHIPPING WEIGHT: 8.98 lbs.
EMERGENCY SIGN: 7-7/8” x 7-7/8” Plastic Wall Sign.
OPTIONS
◊ AL1
(Air Horn Alarm)
◊ AL2
(Electrical Alarm)
◊ AL3
(Electrical Alarm)
◊ AL2-C1D2
(Electrical Alarm / Haz. Area)
◊ FLW
◊ PC
◊ BH
(Flow Switch)
◊ STALL
(Shower Stall)
(Brass Shower Head)
(Polished Chrome Shower Head)
◊ AL3-C1D2
(Electrical Alarm / Haz. Area)
◊ SSH
(Stainless Steel Shower Head)
◊ FPV
(Anti-Freeze Protection Valve)
◊ SPV
(Anti-Scald Protection Valve)
◊ VPL
(Vapor Proof Light)
◊ SSBV1
(Stainless Steel Ball Valve)
◊ SGN5
(Shower Floor Sign)
INSTALLATION
Assemble unit to a 1” supply pipe that has an uninterrupted source of potable water. Use pipe sealant on this joint. Review drawing (as shown on other side) to assure proper installation. Failure to use potable water can result in emergency units producing impure or contaminated water causing possible further injury.
OPERATION
This shower is activated by pulling downward on the pull rod. The valve will continue to discharge water until the rod is manually pushed up to the off position.
TESTING PROGRAM
The American National Standards Institute (ANSI) states that all safety emergency equipment shall be activated on a weekly basis to flush the line and verify proper operation. Speakman Company furnishes a testing record tag
(91-0635) with each unit. On this tag the date of inspection and the inspectors initials should be noted.
MAINTENANCE
Should you need parts to repair this unit, please reference the parts listing below for correct part numbers. Reference additional technical sheets
(supplied) for information on the SE-911 stay-open valve and the SE-870 shower head. Before any maintenance is done be sure to shut the water
supply off.
WARNING: Use only genuine Speakman parts
when repairing or replacing components. To order parts call 1-800-537-2107.
SE-227 REPLACEMENT/REPAIR PARTS
ITEM PART/GROUP # DESCRIPTION
1 SE-911-PR 1” Stay-Open Valve
2
3
4
G04-0722
SE-870
G47-0046-29
Short Lever w/Plunger
8” Plastic Shower Head
Aluminum Pull Rod
FLOW DATA
SHOWER:
FLOW PRESSURE PSI (BAR)
FLOW RATE GPM (LPM)
20 (1.38)
20 (75)
60 (4.14)
25 (94)
NOTE: This unit should be connected to an uninterrupted source of potable water, with a minimum flowing pressure of 20 PSI and a maximum static pressure of 125 PSI.
Note: All units meet existing
ANSI Z358.1 2004 Standards and OSHA Rules. Product improvements may cause specification and dimensional changes without notice.
07/05
92-1393 Rev-8
