Chauvet | Intimidator Sport LED 150 | User manual | Chauvet Intimidator Sport LED 150 User manual

Quick Reference Guide
Intimidator™ Spot LED 150 QRG
About This
Guide
The Intimidator™ Spot LED 150 Quick Reference Guide (QRG) has basic
product information such as mounting, menu options, and DMX values.
Download the User Manual from www.chauvetlighting.com for more details.
Disclaimer
The information and specifications contained in this QRG are subject to
change without notice.
These Safety Notes include important information about installation, use, and
maintenance.
Safety Notes
This product is not intended for permanent installation.
ONLY connect this product to a grounded and protected circuit.
Always disconnect from power before cleaning or replacing the fuse.
DO NOT look at the light source when the product is on.
Make sure the power cord is not crimped or damaged.
Never disconnect this product from power cord by pulling or tugging on the
cord.
• When mounting this product overhead, use a safety cable.
• DO NOT allow flammable materials close to the unit while operating.
• DO NOT touch this product when it is operating because it may be hot.
•
•
•
•
•
•
What Is
Included
To Begin
Product
Description
• The voltage of the outlet to which you are connecting this product must be
within the range stated on the decal or rear panel of the product.
• This product is for indoor use only! (IP20) To prevent risk of fire or shock,
do not expose this product to rain or moisture.
• Always mount this product in a location with adequate ventilation, at least
20 in (50 cm) from adjacent surfaces.
• Be sure that no ventilation slots on the unit’s housing are blocked.
• Never connect this product to a dimmer or rheostat.
• Replace the fuse with the same type and rating.
• ONLY use the hanging/mounting bracket or the handles to carry this
product.
• The maximum ambient temperature is 104° F (40° C). Do not operate this
product at higher temperatures.
• In the event of a serious operating problem, stop using immediately.
• DO NOT open this product. It contains no user-serviceable parts.
•
Intimidator™ Spot LED 150
•
Power Cord
•
Mounting Bracket
•
Warranty Card
•
2 Mounting Bolts
•
Quick Reference Guide
•
Safety Eyebolt
Unpack your Intimidator™ Spot LED 150 and make sure you have received
all parts in good condition. If the box or contents appear damaged, notify the
carrier immediately, not CHAUVET®.
The Intimidator™ Spot LED 150 is a bright, lightweight and compact LED
moving head perfect for mobile applications.
2
Intimidator™ Spot LED 150 QRG
Adjustable Lens
Moving Head
Moving Yoke
LED Display
Cooling Fan
Product Overview
Power In/Out
AC Power
Power Linking
Fuse
Replacement
Fuse Holder
DMX In/Out
This product has an auto-ranging power supply that can work with an input
voltage range of 100~240 VAC, 50/60 Hz.
You can link up to 6 Intimidator™ Spot LED 150 products at 120 VAC and
12 units at 230 VAC.
To replace the fuse in the Intimidator™ Spot LED 150:
1. Disconnect the product from power.
2. Using a flat-head screwdriver, loosen the fuse holder and pull
straight out.
3. Remove the blown fuse from the holder and replace with a fuse of
the exact same type and rating.
4. Re-insert the fuse holder and reconnect power.
3
Intimidator™ Spot LED 150 QRG
Mounting
Before mounting this product, read the Safety Notes.
Bracket Attachment (x2)
Rubber Feet (x4)
Product
Mounting
Diagram
Safety Loop Attachment Point
Control Panel
Description
Button
<MENU>
<UP>
<DOWN>
<ENTER>
Function
Exits from the current menu or function.
Navigates upwards through the menu list and increases the
numeric value when in a function.
Navigates downwards through the menu list and decreases the
numeric value when in a function.
Enables the currently displayed menu or sets the currently
selected value
Menu Options
Main Level
Programming Levels
DMX Mode
001-512
SLAv (Son)
NASL (SLoU)
Operating Mode
NAFA (FASt)
NStS (SrUn)
Normal Pan
PAn
Pan
Inverse Pan
r PAn
Normal Tilt
tiL
Tilt
Inverse Tilt
r tiL
Normal Display
diS
Display
Inverse Display
r diS
11-Channel
11CH
Mode
Channel Mode
6-Channel Mode
6CH
Pan 540
PA54
Manual Pan Restrict
Pan 360
PA36
Pan 180
PA18
Tilt 270
Ti27
Manual Tilt Restrict
Tilt 180
Ti18
Tilt 90
Ti 9
Reset
rESt
Load
LoAd
4
Description
Sets the DMX starting address
Slave operating mode
Automatic Mode, Slow Program
Automatic Mode, Fast Program
Sound Active Mode
Normal Pan operation
Inverse Pan operation
Normal Tilt operation
Inverse Tilt operation
Change the LCD display text
Selects the DMX personality
Select Pan angle restrictions
Select Tilt angle restrictions
Resets fixture
Load factory defaults
Intimidator™ Spot LED 150 QRG
DMX Linking
Starting Address
Master/Slave
Connection
The Intimidator™ Spot LED 150 can work with a DMX controller when
linked by DMX serial connections. Instructions for connecting and
configuring this product for DMX operation are in the User Manual. If you
are not familiar with DMX, download the DMX Primer from
www.chauvetlighting.com.
To ensure full access to all channels in each DMX mode, the highest
recommended DMX address is 502.
The Intimidator™ Spot LED 150 uses the DMX data connection for its
Master/Slave mode. Instructions for connecting and configuring this product
for Master/Slave operation are in the User Manual.
DMX Values
6-CH
Channel Function
1
2
Pan
Tilt
3
Color
Value
000  255
000  255
000  005
006  011
012  017
018  023
024  029
030  035
036  041
042  047
048  053
054  063
064  069
070  075
076  081
082  087
088  093
094  099
100  105
106  111
112  117
118  127
128  191
192  255
4
Shutter
000  003
004  007
008  215
216  255
5
Percent/Setting
0-540°
0-270°
White
Yellow
Magenta
Green
Red
Cyan
Orange
Blue
Light Green
Amber
White + Yellow
Yellow + Magenta
Magenta + Green
Green + Red
Red + Cyan
Cyan + Orange
Orange + Blue
Blue + Light Green
Light Green + Amber
Amber + White
Color cycling rainbow with increasing speed
Reverse color cycling rainbow with
increasing speed
Blackout
Open
Strobe (0-20 Hz)
Open
Intimidator™ Spot LED 150 QRG
6-CH (cont.)
Channel Function
5
Dimmer
6
Gobo Wheel
Value
Percent/Setting
000  255 0-100%
064  071
072  079
080  085
086  091
092  097
098  103
104  109
110  115
116  121
122  127
128  191
192  255
6
Gobo 9 shake, from slow to fast
Gobo 8 shake, from slow to fast
Gobo 7 shake, from slow to fast
Gobo 6 shake, from slow to fast
Gobo 5 shake, from slow to fast
Gobo 4 shake, from slow to fast
Gobo 3 shake, from slow to fast
Gobo 2 shake, from slow to fast
Gobo 1 shake, from slow to fast
Open
Cycle effect with increasing speed
Reverse cycle effect with increasing speed
Intimidator™ Spot LED 150 QRG
11-CH
Channel Function
1
2
3
4
5
Pan
Tilt
Fine Pan
Fine Tilt
Speed
6
Color
Value
000  255
000  255
000  255
000  255
000  255
000  005
006  011
012  017
018  023
024  029
030  035
036  041
042  047
048  053
054  063
064  069
070  075
076  081
082  087
088  093
094  099
100  105
106  111
112  117
118  127
128  191
192  255
7
Shutter
8
Dimmer
000  003
004  007
008  215
216  255
000  255
7
Percent/Setting
0-540°
0-270°
Fine control of panning
Fine control of tilting
Pan/Tilt speed (fast to slow)
White
Yellow
Magenta
Green
Red
Cyan
Orange
Blue
Light Green
Amber
White + Yellow
Yellow + Magenta
Magenta + Green
Green + Red
Red + Cyan
Cyan + Orange
Orange + Blue
Blue + Light Green
Light Green + Amber
Amber + White
Color cycling rainbow with increasing speed
Reverse color cycling rainbow with
increasing speed
Blackout
Open
Strobe (0-20 Hz)
Open
0-100%
Intimidator™ Spot LED 150 QRG
11-CH
(cont.)
Channel Function
9
Gobo Wheel
Value
064  071
072  079
080  085
086  091
092  097
098  103
104  109
110  115
116  121
122  127
128  191
192  255
000  007
008  027
028  047
048  067
068  087
088  107
10
11
Control Functions
Auto Programs
108  127
128  147
148  167
168  187
188  207
208  227
228  247
248  255
000  007
008  135
136  255
8
Percent/Setting
Gobo 9 shake, from slow to fast
Gobo 8 shake, from slow to fast
Gobo 7 shake, from slow to fast
Gobo 6 shake, from slow to fast
Gobo 5 shake, from slow to fast
Gobo 4 shake, from slow to fast
Gobo 3 shake, from slow to fast
Gobo 2 shake, from slow to fast
Gobo 1 shake, from slow to fast
Open
Cycle effect with increasing speed
Reverse cycle effect with increasing speed
No function
Blackout while pan/tilt moving
Blackout while moving gobo wheel
Disable blackout while pan/tilt/moving gobo
wheel
Blackout while moving color wheel
Disable blackout while pan/tilt/moving color
wheel
Disable blackout while moving gobo/color
wheel
Disable blackout while moving all options
Reset pan
Reset tilt
Reset color wheel
Reset gobo wheel
Reset all channels
No function
No function
Auto programs 1-8
Sound active programs 1-8
Intimidator™ Spot LED 150 QRG
Contact Us
Outside the U.S., United Kingdom, or Ireland, contact your distributor to
request support or return a product. Visit www.chauvetlighting.com for
contact information.
World Headquarters
United Kingdom and Ireland
General Information
General Information
CHAUVET®
Address:
Voice:
Fax:
Toll free:
CHAUVET® Europe Ltd.
5200 NW 108th Avenue
Sunrise, FL 33351
(954) 929-1115
(954) 929-5560
(800) 762-1084
Address:
Unit 1C
Brookhill Road Industrial Estate
Pinxton, Nottingham, UK
NG16 6NT
Voice:
+44 (0)1773 511115
Fax:
+44 (0)1773 511110
Technical Support
Technical Support
World Wide Web
World Wide Web
Voice:
Fax:
Email:
(954) 929-1115 (Press 4)
(954) 756-8015
tech@chauvetlighting.com
www.chauvetlighting.com
Intimidator™ Spot LED 150 QRG – Rev. 1 4TL
© Copyright 2012 CHAUVET®
All rights reserved.
Printed in the P. R. C.
9
Email:
uktech@chauvetlighting.com
www.chauvetlighting.co.uk
Download PDF