655lit

655lit
700 - 800 sq. ft./gal.
HP GYM COAT
Water-Based • Ultra Durable Gloss
Uses
Directions For Use
•
•
•
•
•
Read the entire label before using this product.
PREPARATION: FOR NEW OR SANDED FLOORS: Prepare the floor
using accepted NOFMA or MFMA procedures. Vacuum all dust and
tack with cotton towel. Apply water-based wood sealer following
instructions on sealer label: 2 coats minimum. FOR SCREENING
AND RECOATING: Always clean the floor prior to screening. Mix
wood floor maintenance cleaner at 32 oz./gal. or 250 mL/L (1:4)
with water and tack using a clean towel. Screen using new 100 or
120 grit screens, vacuum and tack using a water moistened cotton
towel. APPLICATION: While stirring product, add catalyst slowly and
continue mixing for 30 seconds. Mix thoroughly and let stand for 5
minutes. Once catalyzed, pot life is 12 hours. Apply at 700 - 800
sq.ft./gal. Pour finish into a clean, dry, plastic pour can. Pour a 4inch wide line of finish along one wall with the grain of the wood.
With applicator at a slight angle, move the puddle line to the opposite
wall, always maintaining a wet edge. At the end of each pass, make
a smooth turn with the applicator and squeeze out excess finish
with the grain next to the puddle line. Allow to dry thoroughly (minimum
3 hours between coats depending on conditions with a maximum
of 6 hours). Abrade between coats if 6 hours has elapsed with a
maroon top scrub pad or 120 grit screen. Apply 2 coats minimum.
Allow light traffic after 24 hours, however, it is susceptible to scuffing
and marring. NOTE: Allow adequate ventilation. Circulate air above
the floor. Allow adequate airflow for at least 24 hours after final coat
is applied. Use air conditioners and exhaust fans where available.
MAINTENANCE: DAILY MAINTENANCE: Dust mop using waterbased dust mop treatment (see product label for additional
instructions). Dust mop as often as possible, at least once per day.
WEEKLY MAINTENANCE: Tack (deep clean) the floor using wood
floor maintenance cleaner (see product label for additional instructions).
Tack frequently, but at least once a week. Refer to the Water-Based
Wood Coatings Application & Procedure Guide for detailed
instructions. NOTE: Slip resistance meets or exceeds (ASTM D
2047-04) James Machine 0.5 minimum.
Any wood floor
Athletic courts
Dance floors
Gymnasium
Racquet clubs
Benefits
• Dries to a clear film bringing out natural wood floor beauty. Won’t
discolor line markings and team logos.
• Low odor.
• Fast drying. Dries in 3 - 6 hours with a maximum of 12 hours,
allowing two coats in a single day and a third coat the next
morning, reducing labor cost.
• Fast curing - Floors can be brought back into service within 24
hours.
• Easy clean up with water. No solvent disposal issues.
• MFMA approved.
Properties
Color (dried)...........................................................................Clear
Coverage .......................................................700 - 800 sq. ft./gal.
Dry time .........................................................3 - 6 hour minimum
Recoat time .....................................................................12 hours
Flash point ............................................................................None
Pot life .............................................................................12 hours
Rubber burn resistance....................................................Excellent
Solids ..................................................................................> 34%
Viscosity ...................................................................30 centipoise
Weight per gallon .............................................................8.69 lbs.
VOC’s.............................................................................< 350 g/L
Shelf life ...............................................................................1 year
Safety
Keep out of reach of children. For industrial and commercial use.
WARNING: Avoid contact with skin and eyes. Wear safety glasses
and gloves. Do not inhale vapors. Harmful if swallowed. FIRST
AID: IF ON SKIN OR CLOTHING: Remove contaminated clothing,
wash skin with soap and water and rinse thoroughly. IF SPLASHED
IN EYES: Flush immediately with large quantities of water. Seek
medical attention. IF INHALED: Remove to fresh air. If person is
not breathing, call 911 or an ambulance, then give artificial
respiration, preferably mouth to mouth if possible. Call a poison
control center or doctor for further treatment advice. If swallowed,
do not induce vomiting unless instructed to do so by poison
control center or doctor. Call a physician immediately.
Available In
Case/4 - 1 Gallon (3.78 L): Item #65504-00
Pail/5 Gallon (18.9 L): Item #65505-00
Literature Item #65592-92
C1510 - Wood Floor - Water Based Coatings
Authorized Betco Distributor
The Cleaning Edge
12.06
©Betco Corporation • All Rights Reserved. • 1001 Brown Avenue • Toledo, Ohio 43607-0127 • 888-GO BETCO (888-462-3826) • [email protected] • www.betco.com
HP Gym Coat uses Urethane Dispersion Technology (UDT) to provide the ultimate water-based wood floor coating. Safer
and easier to use than solvent-based products, HP Gym Coat provides high gloss and extended durability. Its clear formula
lets the natural beauty of the wood shine through.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement