PIXCI EB1
PIXCI EL1
®
PIXCI® EL1
Low Cost PCI Express x1 Frame Grabber
for Camera Link Cameras
The PIXCI® EL1 frame grabber supports Full, Medium, and
Base configuration Camera Link cameras. Compatible with the
PCI Express x1 (by one) bus, the EL1 frame grabber interfaces to
more than 100 of the newest, most advanced, highest bandwidth
machine vision cameras available.
The PIXCI EL1 offers:
• Up to 204 Megabyte per second (sustained) data transfer to the
host computer.
• Camera specific controls – exposure, bit depth, gain,
frame rate, etc.
• Camera operation in free-run mode for maximum frame rate
sequence capture.
• Camera operation in control (trigger) mode.
• Low price – only $895.00 with XCAP-Lite imaging program.
The PIXCI EL1 is a plug-n-play frame grabber requiring no
hardware setup or adjustment. Install the board, load the
software, connect the camera, and begin to capture images.
Upon startup, the XCAP imaging program reads a camera
identification chip on the PIXCI EL1 frame grabber, allowing
XCAP to load the appropriate video format and display the
camera’s dedicated Capture & Adjust Dialog.
Full, Medium & Base Configuration
Camera Link Frame Grabber
PCI Express x1 Bus Compatible
250 Megabyte/sec Burst Transfers
Line Scan or Area Scan
Camera Frame Rate Sequence Capture
Triggered Image Sequence Capture
64-Bit Memory Addressing
Camera Integration & Async Reset Control
Integration From Microseconds to Minutes
Images Stored in Motherboard Memory or
RAID Array
Compatible with Windows XP, 2000, Linux &
32-bit DOS
RoHS Compliant
EPIX, Incorporated
381 Lexington Drive
Buffalo Grove, IL 60089 USA
Tel - 847 465 1818
Fax - 847 465 1919
Web: http://www.epixinc.com
E-mail: [email protected]
Specifications subject to change without notice. EPIX and PIXCI
are registered trademarks of EPIX, Inc. XCAP is a trademark of
EPIX, Inc. EPIX ® imaging products are made in the USA.
© 2007 EPIX, Inc. All Rights Reserved. 20 MAR 2007
Interfaces to almost any camera link camera. The PIXCI EL1
frame grabber requires a x1 or wider PCI Express slot. Few high
bandwidth cameras exceed the 204 MB/sec maximum throughput
of the PIXCI EL1 board. Support for higher bandwidth cameras
is available with the PIXCI E4 frame grabber, which transfers
700 MB/sec on a x4 PCI Express slot.
The XCAP imaging program supports up to eight PIXCI EL1
frame grabbers making it possible to use multiple Full,
Medium, or Base configuration Camera Link cameras simultaneously. The XCAP-Std program allows simultaneous use of
the PIXCI EL1 with other EPIX® frame grabbers supporting
different camera models, either Camera Link compatible or not.
XCAP-Std also offers video-to-disk capture, subject to the
performance of the host computer’s RAID array.
Solutions and Support: EPIX, Inc. has been providing imaging
solutions and support for OEM machine vision manufacturers
and engineers since 1984. EPIX, Inc. assembles complete
imaging systems with cameras, frame grabbers, high-performance PCI Express buses, and with RAID arrays for video-todisk capture. EPIX imaging systems, custom-built to your
specfications, feature Intel motherboards and processors.
Contact EPIX, Inc., or an authorized distributor of EPIX® imaging
products, for help selecting cameras, frame grabbers, imaging
software, optics, and computer systems.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement