TPMC-3X Series quickstart guide Isys® 2.8” Handheld WiFi Touch Screens 1 Power To charge its internal battery pack, the TPMC-3X Series touch screen must be placed on the included docking station/charger. Connect the included power pack to the docking station/charger. It takes the TPMC-3X Series touch screen about 2 hours to recharge while in use. A fully charged battery can provide up to 5 hours of use at the full screen brightness setting. NOTE: The TPMC-3X Series touch screen can become unresponsive when battery strength is low. NOTE: Before using the TPMC-3X Series touch screen for the first time, charge its internal battery pack for at least two hours by placing it on the included docking station/charger. 2 NOTE: When not using the TPMC-3X Series touch screen, store the unit on its docking station/charger. Configure the Touch Screen The setup screen is the starting point for configuring a TPMC-3X Series touch screen. When power is applied for the first time, the following screen appears. System Bar 2 3 GUIDE HOME LIST 4 Touch the screen to display the TPMC-3X Series setup screen, as shown in the illustration to the right. The setup screen enables basic configuration procedures prior to regular operation of the touch screen. NOTE: During regular operation of the touch screen, there are three ways to activate the setup functions: 1. Place a button on the project main page and assign the reserved join number (17242) that activates setup. 2. Press hard keys 1, 2, 3, and 4 in sequence twice (i.e. press 1, 2, 3, 4, 1, 2, 3, 4) within a 5 second period. 3. If the system bar is visible at the top of the display, access the setup screen by touching the Crestron swirl logo in the upper left corner. 1 For Regulatory Compliance information, refer to the latest version of Doc. 7409. QUICKSTART DOC. 6790C (2023713, Sheet 1 of 2) www.crestron.com 07.12 Specifications subject to change without notice. 888.273.7876 201.767.3400 TPMC-3X Series 1 TPMC-3X Series quickstart guide Isys® 2.8” Handheld WiFi Touch Screens 3 4 Basic Wireless Setup From the setup menu, touch WiFi Setup to display the “WiFi Setup” screen shown below. In the screens opened by the WiFi Access Point, CntrlSystem IP Address and IP Config buttons, a keyboard application is displayed at the bottom. The keyboard uses the navigation pad (up, down, left and right) to select a character to type. The center button on the navigation pad types the selected character. Use Crestron Toolbox™ for communicating with the TPMC-3X Series touch screen; refer to the Crestron Toolbox help file for details. PC Running Crestron Toolbox Wi-Fi TPMC-3X Series The TPMC-3X Series touch screen connects to PC via Wi-Fi: There are different characters in each row. Move between rows using the up/down buttons and move within a row using the left/right buttons. There are a few “shortcut” keys: The top six hard keys are mapped according to the legend at the bottom of the screen (BSpc, Tab>>, Delete, OK, <<Tab and Cancel). NOTE: It may take 5-10 seconds for the IP address to show once the WAP Connection indicator has turned green. The volume up/down and ▲/▼ keys on either side of the navigation pad also have some shortcuts to help navigate around text and list boxes. The volume up/down buttons act as the up and down arrow keys (use to select items in a list box). The ▲ and ▼ buttons can be used to move the cursor within a text string. A list of available access points is shown. Use the volume up/down buttons to scroll through the list. Select the access point and touch Edit to configure. With DHCP enabled, simply enter the Network key. From the “WiFi Setup” screen, touch CntrlSystem IP Address to display the “Control System Information” screen, which has controls to Enable Autodiscovery and Use Hostname Lookup as well as enter the IP Address, Port and IP ID. On any of these screens, touch the appropriate hard key for Tab>> or <<Tab to navigate editable fields. Touch the appropriate hard key for OK to save settings or for Cancel to exit without saving. NOTE: Make the control system connection after exiting setup. For Regulatory Compliance information, refer to the latest version of Doc. 7409. QUICKSTART DOC. 6790C (2023713, Sheet 1 of 2) www.crestron.com 07.12 Specifications subject to change without notice. 888.273.7876 201.767.3400 1. Establish wireless communication between TPMC-3X Series touch screen and PC via the CEN-WAP-ABG-1G or CEN-WAP-ABG-CM. The TPMC-3X Series touch screen has DHCP enabled by default. 2. Confirm Ethernet connection between TPMC-3X Series touch screen and PC by using the pencil tool in Crestron Toolbox (Alt + D), clicking TCP, entering the IP address (shown on the TPMC-3X Series touch screen’s main “Wi-Fi Setup” screen), then clicking OK. 3. Use the Address Book in Crestron Toolbox to create an entry for the TPMC-3X Series touch screen with the touch screen’s TCP/IP communication parameters. 4. Display the “System Info” window (click the TPMC-3X Series touch screen entry. icon) and select the TPMC-3X Series From the “WiFi Setup” screen, touch WIFi Access Point to display the “Wireless Information” screen, which allows setting up the parameters used to communicate with the control system via a wireless access point (WAP). Crestron® recommends using a CEN-WAP-ABG-1G or CEN-WAP-ABG-CM (both sold separately) as the wireless access point for the TPMC-3X Series touch screen. 2 Establish Communication TPMC-3X Series quickstart guide Isys® 2.8” Handheld WiFi Touch Screens 5 Dimensions 6 Keep the surface of the touch screen free of dirt, dust or other materials that could degrade optical properties. Long-term contact with abrasive materials can scratch the surface, which may detrimentally affect image quality. TPMC-3X Series Overall Dimensions (Front and Side Views) 1.04 in (27 mm) 2.07 in (53 mm) Recommended Cleaning For best cleaning results, use a clean, damp, non-abrasive cloth with any commerically available non-ammonia glass cleaner. Bezels may not provide a complete watertight seal. Therefore, apply cleaning solution to the cloth rather than the surface of the touch screen. Wipe touch screen clean and avoid getting moisture beneath the bezels. 2.64 in (67 mm) 7 Specifications Touch Screen Display Display Type: TFT active matrix color LCD Size: 2.8 inch (72 mm) diagonal Aspect Ratio: 3:4 QVGA (portrait orientation) Resolution: 240 x 320 pixels 2 Brightness: 350 nits (cd/m ) typical Contrast: 500:1 typical Color Depth: 16-bit, 64k colors Viewing Angle: ±75° horizontal, +75/-55° vertical Illumination: LED Backlit Touch Screen: Resistive membrane 7.94 in (202 mm) Power (top): (1) programmable push button, performs hardware reset if held for >10 seconds Hard Keys: (3) programmable push buttons below touch screen Functions: (15) programmable push buttons with white EL backlit labeling for GUIDE, HOME, LIST, MUTE, INFO, LAST, MENU, KEYPAD, EXIT, and icons for Rewind, Play, Forward, Stop, Pause, Record Volume: (1) programmable rocker button with white EL backlit Volume ‘Raise’ and ‘Lower’ icons Navigation Pad: (5) programmable push buttons comprising a 5-way thumbpad (4-way navigation plus “enter”) Up/Down: (1) programmable rocker button with white EL backlit ‘Up’ and ‘Down’ arrows More (right side): (1) programmable thumb-operated side button Charge: (1) Green LED, indicates charging status when docked Memory SDRAM: 128 MB Flash: 256 MB Maximum Project Size: 24 MB 2.55 in (65 mm) (Continued on following page) 3 For Regulatory Compliance information, refer to the latest version of Doc. 7409. QUICKSTART DOC. 6790C (2023713, Sheet 2 of 2) www.crestron.com 07.12 Specifications subject to change without notice. 888.273.7876 201.767.3400 TPMC-3X Series Buttons & Indicators TPMC-3X Series quickstart guide Isys® 2.8” Handheld WiFi Touch Screens 7 Specifications (Continued) Graphics Engine Environmental 16-bit non-palette graphics; 65,536 colors; multi-mode objects; dynamic graphics and text; PNG translucency; full-motion (60 fps) animation; subpage transition effects Temperature: 32° to 104° F (0° to 40° C) Humidity: 10% to 90% RH (non-condensing) Heat Dissipation: 20 BTU/Hr Wireless Communication Enclosure Transceiver: IEEE 802.11a/b/g Wi-Fi (5.8 or 2.4 GHz 2-way RF), static IP or dynamic IP via DHCP, 64 and 128-bit WEP encryption, WPA & WPA2-PSK with TKIP & AES Range: Up to 50 feet (15 meters), subject to environmental conditions Gateway: Requires a CEN-WAP-ABG or similar 802.11a/b/g wireless access point and Ethernet-enabled Crestron control system (all sold separately) ® Roaming: Requires a Cisco controller solution to be installed and commissioned by a Cisco certified technician. Video Streaming Formats: MJPEG Audio Features: Built-in speaker and microphone, Crestron IP Intercom Audio Feedback: WAV format, 8 & 16-bit PCM, 8 – 44.1 kHz sampling rates, mono & stereo Tilt Sensor Wakes touch screen within 0.5 second when unit’s physical orientation is moved from horizontal to vertical Construction: Injection-molded plastic, integral docking station port Dimensions TPMC-3X Height: 1.04 in (27 mm), 6.34 in (161 mm) docked Width: 2.55 in (65 mm), 4.58 in (117 mm) docked Depth: 7.94 in (202 mm), 6.30 in (160 mm) docked TPMC-3X-LP Height: 1.04 in (27 mm), 2.22 in (57 mm) docked Width: 2.55 in (65 mm), 2.99 in (76 mm) docked Depth: 7.94 in (202 mm), 7.84 in (199 mm) docked Weight 7 oz (185 g) including battery NOTES * Connectors Battery Battery Type: Lithium Polymer, 3.7 Volt, 1000 mAh, model TPMC-3X-BTP included Usage per Charge: 5 hours continuous at full brightness Charging Time: 2 hours Cycle Life: >300 cycles (80% capacity) Power Requirements* TPMC-3X Power Pack: 1.5 Amps @ 12 Volts DC 0.6 Amp @ 100-240 Volts AC, 50/60 Hz power pack included. TPMC-3X-LP Power Pack: 1.2 Amps @ 5 Volts DC 100-240 Volts AC, 50/60 Hz power pack included. 4 For Regulatory Compliance information, refer to the latest version of Doc. 7409. QUICKSTART DOC. 6790C (2023713, Sheet 2 of 2) The specific patents that cover Crestron products are listed at patents.crestron.com. Crestron, the Crestron logo, Crestron Toolbox and Isys are trademarks or registered trademarks of Crestron Electronics, Inc. in the United States and other countries. Cisco is either a trademark or registered trademark of Cisco Systems, Inc. in the United States and/or other countries.Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Crestron disclaims proprietary interest in the marks and names of others. ©2012 Crestron Electronics, Inc. www.crestron.com 07.12 Specifications subject to change without notice. 888.273.7876 201.767.3400 TPMC-3X Series USB (bottom): (1) Mini Type AB female behind battery cover USB computer console port, for installer use only Power connection made via the docking station/charger: x The TPMC-3X includes (1) TPMC-3X-DS TableTop Docking Station. The TPMC-3X-DSW Wall Mount Docking Station is sold separately. Refer to each individual product spec sheet for additional details. The TPMC-3X is not compatible with the MTX-3-DS docking station. x The TPMC-3X-LP includes (1) MTX-3-DS Low-Profile TableTop Docking Station. Refer to the MTX-3-DS spec sheet for additional details. The TPMC-3X-LP is not compatible with the TPMC-3X-DS or TPMC-3X-DSW docking stations.
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project