Motorola | L705CM | User`s guide | Motorola L705CM User`s guide

US EN
DECT 6.0 Cordless /
Corded Phones with
Answering System
L702C / L703C / L704C /
L705C / L706C
L702CM / L703CM /
L704CM / L705CM /
L706CM
Quick Start Guide
1
2
3
4
Getting started
Using the phone
Help
General Information
This Quick Start Guide provides all the information you need to get
started. If you need more detailed instructions, please go to
www.motorola.com to download a PDF of this product's User’s
Guide.
Please consider the environment before printing.
Box Contents
Corded base and
handset
Power adapter
for the corded
base
Cordless handset
Power adapter for
the cordless
charger
Cordless
charger
Telephone line cords
Wall-mount
bracket
NiMH rechargeable
battery pack
User’s Guide
Quick Start
Guide
In multihandset packs, you will find one or more additional cordless handsets, cordless chargers
with power adapter units, additional rechargeable battery packs, and battery doors.
IMPORTANT
Only use the telephone line cord supplied.
Please note that only the Corded phone operates during power outage (with limited functions).
1
Getting started
Step 1. Connecting the corded base
Step 2. Installing and charging the
cordless handset battery pack
• Connect the corded handset to the corded base with
the provided coiled cord.
• Plug the power adapter with the smaller pin plug &
telephone line cord into the corded base.
• Plug the other end of the power adapter & telephone
line cord into the wall jack.
• Slide off the battery compartment cover to remove it.
Place the supplied rechargeable battery pack in the
battery compartment, with the battery connector
plugged in, as shown.
• Slide the battery compartment cover back on.
• Put the cordless handset on the charger to charge for
at least 24 hours. Once charged, the will indicate
that the handset is fully charged.
TIPS
Do not place your phone in the bathroom or other humid
areas. Please refer to the User's Guide for more cautions
regarding the location of your phone.
IMPORTANT
Only use the power adapter and telephone line cord
supplied with this product.
IMPORTANT
Use only the rechargeable battery pack provided.
Step 3. Setting the display language
Step 4. Setting date and time
For the corded base:
• Press MENU (Base) and then VOL+ (Base) or VOLto select SETTINGS.
• Press MENU (Base) and then VOL+ (Base) or VOLto select LANGUAGE.
• Press MENU (Base) and then VOL+ (Base) or VOLto select the language you want.
• Press MENU (Base) to save.
For the cordless handset:
• Press MENU and then VOL+ (Base) or REDIAL/
VOL- to select SETUP HS.
• Press MENU and then VOL+ (Base) or REDIAL/
VOL- to select LANGUAGE.
• Press MENU and then VOL+ (Base) or REDIAL/
VOL- to select the language you want.
• Press MENU to save.
For the corded base:
• Press MENU (Base) to select DATE & TIME.
• Press MENU (Base) and then VOL+ (Base) or VOLto change the year setting.
• Press MENU (Base) and then VOL+ (Base) or VOLto change the date setting. Repeat to set the time
continuously.
• Press MENU (Base) to save the settings.
For the cordless handset:
• Press MENU to select DATE & TIME.
• Press MENU and then edit the year and date.
• Press VOL+ (Base) or REDIAL/VOL- to move
between the input fields YEAR and DATE.
• Press MENU and then edit the time in 12hr format.
Press VOL+ (Base) or REDIAL/VOL- to toggle AM/PM
settings.
• Press MENU to save the settings.
NOTE
If you're a subscriber to your network's Caller ID service,
date and time is automatically set when a call is received.
Your phone is now ready for use.
Corded Base LCD Display
On when you are in the phonebook menu.
On when there are repeat calls from the same
number.
Indicates when a new call has been received.
Off when all new calls have been viewed.
Cordless Handset LCD Display
Display Icons
On when the line is in use.
On when speakerphone is turned on.
In idle mode, the current time is displayed
In idle mode the current date is displayed
Display Icons
On when the ringer volume is turned off
On when speakerphone is turned on.
On when there is new voice mail not yet
listened to.
Off when new voice mail has been listened to.
On when answering machine is turned on.
Flashes when new answering machine message
is received.
Indicates together with the sequential number
of the calls list or redial list entry.
Indicates when new call is received.
Off when new call has been viewed.
On when ringer volume is turned off.
On when there is received new voice mail not yet
listened to.
Off when new voice mail has been listened to.
On when a call is muted.
2
Using the
phone
US EN
Full battery power level.
Making a call
2/3 battery power level.
For the corded base:
Enter the phone number and pick up the corded handset
or press
to dial the number.
For the cordless handset:
Enter the phone number and press
/FLASH or
/
SPEAKER to dial the phone number.
1/3 battery power level.
Flashes when low battery level is detected, needs
charging.
Animation in cycle. Battery is charging.
In idle mode, the current time is displayed.
In Caller ID mode, the time of call is displayed.
On when the line is in use.
Off when the line is idle.
In idle mode the current date is displayed.
In Caller ID mode, the date of the call is
displayed.
Answering a call
For the corded base:
Pick up the corded handset or press
incoming home call.
For the cordless handset:
Press
/FLASH or press
incoming home call.
to answer the
/SPEAKER to answer the
Adjusting the volume
through the cordless handset:
During a call, press VOL+ or VOL-. The same way for
both corded base and cordless handset.
1. Press
/MUTE from idle mode. New messages will
be played followed by any older messages.
2. During the message playback, press the keys below
to perform the following functions:
Ending a call
For the corded base:
During either a home or cellular call, put the corded
handset on the corded base cradle.
For the cordless handset:
During either a home or cellular call, press
/BACK or
put the handset on the charger.
/1
/
Repeats the current message.
Press twice to playback the
previous message.
/ABC/2
Stop the message playback.
/DEF/3
Skip to play the next message.
Using your answering machine through the
corded base:
VOL+
Please refer to the User's Guide for details.
REDIAL/VOL- Decrease the volume.
Increase the volume
/MUTE
Delete the current message and
the next message will be played.
/SPEAKER
Toggle the message playback via
earpiece/speakerphone.
/BACK
Exit to idle.
NOTE
For multiple handset models when you are on a call, the
answering system will not answer the second incoming
call.
3
Help
The
icon is not scrolling when the
cordless handset is placed on the charger
• Incomplete battery contact - adjust the cordless
handset on the charger.
• Dirty contact - clean the battery contact by wiping with
an alcohol moistened cloth.
• Battery is full - charging is not necessary at this time.
No dial tone
• If there is no base power, check the connections.
• Reset the phone by unplugging then plugging it back
into an electrical outlet.
• If the cordless handset batteries are empty, recharge
the battery pack for at least 24 hours.
• Move the cordless handset closer to the corded base.
• Be sure to use only the provided telephone cords.
Poor audio quality
• If the corded base is too close to electrical appliances,
reinforced concrete walls, or metal door frames, move
the corded base from these areas.
No ring tone
• The ring tone may be deactivated.
• The volume may need to be increased.
Caller ID does not work
• Check your subscription with your network operator.
• If you subscribe to high-speed internet service (Digital
Subscriber Line - DSL) through your telephone lines,
you must install a DSL filter between the telephone
base and the telephone wall jack. The filter will
prevent noise and caller ID problems caused by DSL
interference. Please contact your DSL service
provider for more information about DSL filters.
A phonebook entry cannot be stored
• The phonebook is full. Delete an entry to free some
memory.
No display
• Try recharging or replacing the rechargeable battery
pack.
• Reset the corded base. Unplug the unit from the
electrical outlet, then plug it back in.
• If the LED is not lit up, then try to unplug the unit's
electrical power, and then plug it back in.
When the cordless handset disconnects from
the corded base during a phone call
• Check that the power cord is connected properly into
the corded base.
• Check that the power adapter is connected properly
into the electrical outlet.
• Move the cordless handset closer to the corded base.
It may be out of range.
• Reset the corded base by unplugging the unit's
electrical power. Wait for around 15 seconds and replug the power again. Allow up to one minute for the
cordless handset to synchronize with the registered
corded base again.
Noise interference on your radio or television
• Your corded base or cordless charger may be too
close. Move it as far away as possible.
Need more help?
For a full explanation of all features and instructions,
please refer to the User’s Guide.
4
General information
If your product is not working properly...
1. Read this Quick Start Guide or the User's Guide.
2. Visit our website: www.motorola.com
3. Contact Customer Service in the US and Canada at 1-888-331-3383.
To order a replacement battery contact customer service or visit our website.
Manufactured, distributed or sold by Binatone Electronics International LTD., official licensee
for this product. MOTOROLA and the Stylized M Logo are trademarks or registered
trademarks of Motorola Trademark Holdings, LLC. and are used under license. All other
trademarks are the property of their respective owners.
© 2011 Motorola Mobility, Inc. All rights reserved.
Printed in China
Version 2.0
Download PDF