Heat Strip Installation

NOTICE:
WARNING:
Earlier production air conditioner models were manufactured for use with a heat kit with
different mounting requirements and do not have the mounting holes for this kit. If the
mounting holes are not pre-punched, you must use the enclosed template to locate them for
drilling.
PROPER LOCATION IS NECESSARY FOR SAFE OPERATION.
DISCONNECT ELECTRIC POWER BEFORE BEGINNING THE INSTALLATION.
A. Cut along dotted lines marking discharge duct for
your model air conditioner.
B. Peel off backing and LIGHTLY apply to ceiling template
(you will remove it later). Align to the discharge duct
opening as shown.
n
MODEL SERIES 60XXXX,
CAE, CAM, CAW
B
n
C. Hold the element to mounting template and look
at its placement. It should be roughly centered
in discharge opening as shown.
D. Center punch to mark the hole locations.
E. Remove and discard the label.
F. Drill the two l/8” diameter mounting holes.
CAUTION: Take care not to drill through the
base pan or into wires which may be
routed on top of the template.
DISCHARGE
AIR OPENING
Form No. 3101527.004 6/88
MODEL SERIES 559, 570, 579 & CAS
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising