TVBGONE

TVBGONE
soldering is easy
here's how to do it
Solder
put your part in
place. Bend out
the leads so it
stays in place
THE IRON IS
hot!! Be careful!
your kit should come
with instructions
for what parts go
where and what way!
WIre cutter
SOLDERING
IRON
clean the tip of
your iron before
each solder
connection!
parts
pcb
lead
lead
ok, lets solder!
put the pcb down so
you can solder.
heat
careful with the
surface underneath!
first, you want to
both the pad and the lead
for about
1 second
find some good way
to keep it steady
d
lea
can make
if you need a third hand, you
instead
a standing coil of the solder
of holding it in your hand
d
d
under the tip
a
le
a
le
stop feeding solder,
now feed solder
of the iron
Psst!
clean the
tip first!
pad
about
1-3 mm
then
touch the soldering iron to
both the pad and the lead!
a good connection
hold for 1
second
covers the pad
without touching other pads
so the solder can
flow properly
and
surrounds
the lead
solder
solder
pcb
pcb
3 mm
cut the leads off
with the wire cutter
always
hold on to
the lead!
eyes don't
like jumping
lead bits!
the smoke from the melting solder
is not toxic, but blow gently on it
to avoid breathing it.
lead on the other hand
Is toxic, and gets on
your skin when holding
the solder.
cut
keep soldering each part in its
correct place. remember some
parts need to go in a certain way!
if all your connections are
good, your circuit will
just work!
there are more tricks you will learn as
you keep soldering, but now you know
enough to make many cool things.
Mitch Altman
soldering course by
nics.com
http://cornfieldelectro
short,
some leads are already
those.
you don't need to cut
wash your hands
when you're done!
andie nordgren
comic adaptation by
http://log.andie.se
public domain, use, copy, spread!
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement