ECD (PA-00323)

ECD (PA-00323)
Instruction Sheet
PA-00323
June 2013
ECD Display Unit
ECD Display Unit Mounting Instructions
Description
The ECD Display Unit is for use with EC3-Series controllers
from Emerson, see table:
Type
ECD-000
ECD-001
ECD-002
EC3-Controller
EC3-612/611, EC3-622/621, EC3-642/641,
EC3-672/671, EC3-752/751, EC3-812/811,
EC3-922/921
EC3-332/-331
EC3-X33/-X32, EC3-D72/-D73
Safety Instructions
•Display unit can be damaged if used with others than the
above specified controllers.
•Keep the temperatures within the specified limits.
Wiring
Use connecting cable ECC-Nxx or any other standard
CAT5-Cable with RJ45 plugs to connect ECD with EC3.
Display
ECD is showing one measured value of the connected EC3
controller. Press the SEL button to scroll through all possible
displayable data. After approximately 2 minutes, the display will
again display the default value.
In case of an alarm, the display is blinking. The alarm code and
the measured value are displayed alternatively.
Consult the controllers operating instructions for a detailed
description of all Alarm Codes.
Parameter Setting
Technical data
Power supply
From EC3 via connecting cable
Display
LED Indicators
Instructions
Temperature
-4...+149°F (storage)
Humidity
Protection class
Connecting cable
RJ45 Plugs
2½-digit red LED with decimal point
Up to 7 Indicators, see EC3 Controller 32...+140°F (operating),
The parameter setting is password protected. Password entry
and parameter modification is described in the respective EC3
controller operating instructions.
All keys can be alternatively operated with the (optional) Infrared
remote control.
Dimensions
ECD-000, ECD-001, ECD-002
0...80% r.h. non condensing
IP65 (front protection with gasket)
ECC-N30 (9.8 ft.) or CAT5 Cable with Mounting
The ECD-001 can be mounted in panels with a 2.8" x 1.1" cutout.
See dimensional drawing for space requirements.
1.42
3.1
•Push controller into panel cutout.(1)
•Insert allen key into front panel
holes and turn clockwise. Mounting lugs will turn and gradually
move towards panel (2)
•Turn allen key until mounting lug
barely touches panel. Then move
other mounting lug to the same
position (3)
•Tighten both sides very carefully
until controller is secured. Do not
over tighten as mounting lugs will
break easily.
EmersonClimate.com/FlowControls
Technical Support: 1-866-625-8416
PA-00323 (06/13) Emerson is a trademark of Emerson Electric Co. ©2013 Emerson Climate Technologies, Inc. All rights reserved.
Cutout 2.8 x 1.1 in
.2
1.44
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement