524be5b3697f7
Manson
MISCELLANEOUS PRODUCTS & ACCESSORIES
SSB - 4112 / 4212
Battery Protector (Low Voltage Disconnect)
Manson
PRODUCT GUIDE & INDEX
Lead Acid Battery Chargers
AC-DC 3-Stage IUoU Charger with High Efficiency Zero Voltage Switching Mode Design
Description
Intended applications
Over-discharging batteries can damage batteries and or load, and
require a longer recharge time. A Low Voltage Disconnect prevents
this happening so it is in effect a battery protector. Manson's SSB4XXX battery protector is all solid state (FET) with micro-processor
control (MCU). There is no metal contacts like most voltage sensitive
relay in the market .
The MCU continuously monitors the battery voltage and load
current, disconnects the load when battery voltage is below the
preset voltage level (LVD) or when load current is above the rated
value of the unit. When the battery is recharged, the voltage is
raised to another preset voltage level (LVR) the load is then
automatically reconnected again.
The FET design limits the voltage drop to less than 0.25V even at
100A load current .It has an extremely low standby (6 mA) and
operation (9 mA) current consumption. It also protects the load
from over voltage (from charging source to the battery) by
disconnecting the load.
To protect starting, house or site batteries and equipments for
caravan, SUV, boat, with DC loads such as DC motors, inverter,
communication equipment, fridge, and etc against damage, and
over discharging.
When battery is connected to a charging source such as solar, wind,
battery charger, it can conserve the battery power by allowing the
load to draw power from the charging dc source when the battery
is full according to your presets of LVR and LVD.
Model
Page Power Rating
Key Features
SBC-2130
25-26 Input : 100-240Vac ; Output : 12Vdc 30A
SBC-2140
Input : 100-240Vac ; Output : 12Vdc 40A
•
•
•
•
•
•
•
SBC-2150
Input : 100-240Vac ; Output : 12Vdc 50A
SBC-2215
27-28 Input : 100-240Vac ; Output : 24Vdc 15A
SBC-2220
Input : 100-240Vac ; Output : 24Vdc 20A
SBC-2225
Input : 100-240Vac ; Output : 24Vdc 25A
SBC-2408
29-30 Input : 100-240Vac ; Output : 48Vdc 8A
SBC-2410
Input : 100-240Vac ; Output : 48Vdc 10A
SBC-2413
Input : 100-240Vac ; Output : 48Vdc 13A
AC-DC 3-Stage IUoU High Frequency Charger
Model
Page Power Rating
Key Features
SBC-2105
31
• Selection for sealed & Wet type battery
• LED indicator for charging & full
• Electronic protections with auto recovery for short circuit, reverse
polarity, OVP, OTP and battery under voltage (<7.5V)
• Plastic clip on mounting bracket and crocodile clip
•
•
•
•
•
10 selections of Low Voltage Disconnect and Low Voltage
Reconnect
All Solid State with Micro-processor Control
Extensive Protections: Over Temperature, Over Voltage / Over
Current.
Manual over-ride connection
Extruded Aluminum housing with PC plastic end caps
Minus 40°C to +60°C operation temperature.
DC-DC 3 Stage IUoU Charger / 13.8V / Half Input Converter
Model
Page Power Rating
BBC-3140 32
Specifications
MODELS
BATTERY VOLTAGE SYSTEM
PROTECTOR SETTING
LVD = Cut Out
LVR = Cut In
Mode 0
Mode 1
Mode 2
Mode 3
Mode 4
Mode 5
Mode 6
Mode 7
Mode 8
Mode 9
ON/OFF Delay Time for Protector Mode
PROTECTION
Low Voltage Protection (No Delay)
Over Voltage Protection
Over Temperature Protection
Protection Current (Start Point)
CONTINUOUS OUTPUT CURRENT
MAXIMUM OUTPUT CURRENT (delay 10-60 seconds)
OPERATION CURRENT CONSUMPTION (LED ON)
IDLE CURRENT CONSUMPTION (LED OFF)
VOLTAGE DROP WITH 100A (MAIN BATT. to AUX. BATT.)
OPERATION TEMPERATURE RANGE
OVER-RIDE FEATURE
INDICATION BY LED (TWO COLOR RED AND GREEN)
APPROVAL
DIMENSION (L x W x H)
WEIGHT
Input : 180-260Vac ; Output : 12Vdc 5A
Features
•
SSB-4112
12VDC
Tolerance: ±0.1Vdc for 12Vdc sys.
LVD
LVR
10.5V
12.9V
10.9V
13.0V
11.2V
13.1V
11.5V
13.2V
11.9V
13.3V
12.1V
13.4V
12.4V
13.5V
12.6V
13.6V
12.8V
13.7V
13.0V
13.8V
15 seconds
8.5VDC ±0.5VDC
18.5VDC ±0.5VDC
Yes
140A
100A
120A
9mA
6mA
250mV
-40°C to +60°C
YES
YES
CE EN 61000
162x75x50 mm
6.3x3.0x2.0 inch
486g
17oz.
◘ All values are based on the Standard ambient Temperature 25°C and Pressure 0.1Mpa.
◘ SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT PRIOR NOTICE
SSB-4212
24VDC
Tolerance: ±0.2Vdc for 24Vdc sys.
LVD
LVR
21.0V
25.8V
21.8V
26.0V
22.4V
26.2V
23.0V
26.4V
23.8V
26.6V
24.2V
26.8V
24.8V
27.0V
25.2V
27.2V
25.6V
27.4V
26.0V
27.6V
Wide AC input range
Zero voltage switching design for high reliability and efficiency
4 battery type selection: Wet / Calcium-Calcium / AGM / GEL
Power supply mode / Charger mode selection
Auto-soft start bulk charge
Remote temperature sensor is included
Dual LED indicators for bulk, absorption, Float charge;
Fault, Power supply or Charger mode and Power ON
• Thermal control variable speed fan cooling
• Auto-recivery short circuit, Overload, Over temperature,
Over voltage protection, Thermal fuse reversed polarity protection
Input : 22-30Vdc ;
Output : see operation modes
As 3-Stage 12V charger varies with battery type
Voltage Converter : regulated 13.8Vdc
Voltage Reducer : half input voltage
Key Features
Software based power conversion technology
• 3 operation mode:
3 stage 12V charger, voltage reducer with 13.8V output or half input voltage
• 3 stage charger for Wet, Gel, AGM & Calcium-Calcium type battery
• 2 user defined charging profiles; Auto on & off with ignition control;
MCU control
• Optional remote control panel & temperature sensor
Low Power Smart Charger
Model
Page Power Rating
Key Features
SBC-8168
33
Input : 100-240Vac ; Output : 12Vdc 5A
SBC-8268
34
Input : 100-240Vac ; Output : 25Vdc 2.2A
• MCU control 4 stage charging: Repair, Bulk, Absorption, Float
• Pulse width modulation PWM charging for Repair, Absorption
and Float Charging
• Charger self-checks and scans battery for Repair / Reversed polarity / Fault
• Selection of Car / Motorcycle / Cold weather charging mode
• Thermal control regulates charging current in hot or enclosed conditions
• Suitable for all types of Wet, Gel, AGM lead acid battery from 5 to 120AH
• Supplied with two swappable leads with clamps and eyelet terminal
• Universal AC input 100 to 240V
• Can be connected permanently to battery
• Auto returns to last selected charge mode when mains returns after
power outage
High Power Smart Charger
17VDC ±1.0VDC
34.5VDC ±1.0VDC
Model
Page Power Rating
Key Features
SBC-8138
35
Software based MCU control 7-Stage Lead Acid and selection
to Power Supply mode
• 4 Battery type selection: Wet / AGM / Gel / Calcium-Calcium
• Adjustable output current from 10% to 100% for wide battery capacity AH
• Extensive protections with Alarm & LED including auto thermal decrease of
output current to shut down
• LED indications of 8 Charging stage and 8 Protection status
• Supplied with charging cable and battery clamp mounted with temperature
sensor
SBC-8238
SBC-9138
SBC-9238
Input : 180-260Vac ; Output : 12Vdc 25A
Input : 180-260Vac ; Output : 24Vdc 12A
36
Input : 180-260Vac ; Output : 12Vdc 25A
Input : 180-260Vac ; Output : 24Vdc 12A
A deluxe version of SBC-9138 / 9238 with LCD showing :
All the charging stages in a graphic format
Amp, Voltage, AH values
Types of fault, battery selection type, setting of charging current limit
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement