EDEN DC210XLT Metro Bass Guitar Amplifier Operation Manual

The DC210XLT Metro is a compact bass guitar amplifier that delivers 300 watts RMS output @ 8 Ohms, 550 watts @ 4 Ohms and 750 watts @ 2 Ohms, with +3dB of headroom. It features dual preamp channels, a tube preamplifier section on Channel 2, and a 5-way semi-parametric EQ on Channel 2. The DC210XLT is a modular design built with superior components for years of trouble-free service.

PDF Download
Document
EDEN DC210XLT Metro Operation Manual | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • 300 watts RMS output @ 8 Ohms
  • Dual preamp channels
  • Active cooling system
  • Tube pre-amplifier section
  • 5-way semi-parametric tone control
  • Auto-compression circuit

Frequently asked questions

It delivers 300 watts RMS output @ 8 Ohms, 550 watts @ 4 Ohms and 750 watts @ 2 Ohms, with +3dB of headroom.

The Eden Metro DC210XLT features dual preamp channels, a thermostatically controlled, active cooling system with built-in thermal safeties, a tube pre-amplifier section with Eden Enhance control and a powerful 5-way, semi-parametric tone control system coupled to a gentle auto-compression circuit.

The “Magic Knob” is the Enhance control, which simultaneously boosts the very low bass, upper middle, and high frequencies while putting a dip in the lower middle frequencies.

You can adjust the Semi-Parametric controls to focus in on particular frequencies to achieve your desired tone. It’s best to experiment with these controls to learn how they affect your sound.

We recommend that you use your DC210XLT combo at low to moderate volume levels for approximately ten hours before using it in a high volume situation to allow the suspension components to “seat” themselves and the speaker to break in. It will actually take about 24 to 50 hours of total playing time to fully break in your speaker system.
Preparing document for printing…
0%