Cleaning Guide (S-Series, S550, S660 S690)

Cleaning Guide (S-Series, S550, S660 S690)
John Deere S-Series Combines
IMPORTANT: Regular and thorough cleaning
of machine combined with other routine
maintenance procedures listed in the
Operator’s Manual greatly reduce the risk
of fire, chance of costly downtime, and
improve machine performance.
Crop material and other debris can
accumulate in various areas. Direction of
wind, type of crop, and crop moisture
content can all impact where and how much
crop material and debris can accumulate.
Be aware of harvest conditions and adjust
your cleaning schedule to ensure proper
machine function and to reduce the risk of
fire. These areas may require more frequent
cleaning, even multiple times per day,
Cleaning Guide
depending on harvest conditions. Inspect and
clean these areas as needed throughout the
harvest day.
Other areas not covered in this section may
also collect crop debris and MUST be cleaned
periodically for machine function and
appearance.
1
Thoroughly inspect the entire machine on a
regular basis throughout the harvest season.
Refer to the Machine Cleanout Section of
your Operator’s Manual for further
information.
1
NOTE: Some shields were removed
for photo clarity.
Engine Compartment
•Top Area of Engine and
2
Turbocharger(s) (1)
•E xhaust Manifold and Manifold
Shield, Turbo Interstage Tube,
Exhaust Gas Recirculation (EGR)
Cooler Tube (2)
•Around Engine (3)
•Underneath Engine (4)
3
READ SAFETY INFORMATION IN
OPERATOR’S MANUAL
Always follow all safety procedures posted
on the machine and in the Operator’s
Manual. Before carrying out any inspection
or cleaning, always shut OFF engine, set
parking brake and remove key.
Thoroughly clean machine from top to
bottom with compressed air. First clean all
4
areas accessible from engine deck. Start with
engine compartment and work outwards
and counterclockwise to other areas around
engine compartment, floor underneath
engine, top rear of rotor and rear deck,
including areas around Exhaust
Aftertreatment Enclosure (if equipped).
Once top areas of machine are clean,
proceed to cleaning areas accessible from
ground level.
From ground level, clean rear underside
of fuel tank area and top of the rear
tailboard of the residue disposal system.
Exhaust Aftertreatment Enclosure area
(if equipped) will also need to be cleaned
from ground level. Once the cleaning from
ground level is finished, recheck engine
compartment for any crop debris that could
have blown in from ground level cleaning.
5
6
Engine Compartment (cont)
•Top rear of rotor and areas around
7
rotor drive (5)
•Main Engine Gearcase (6)
•Areas around and under Exhaust
Aftertreatment Enclosure (7)
•On Top of Fuel Tank (8)
8
7
9
11
Ground Accessible
•Rear Tailboard and underneath
Fuel Tank (9)
•Left Side Walk Area (10)
•Left Side Sidesheet Areas (11)
Copyright © 2013 Deere & Company. All Rights Reserved. THIS MATERIAL IS THE PROPERTY OF DEERE & COMPANY. ALL USE AND OR REPRODUCTION NOT
SPECIFICALLY AUTHORIZED BY DEERE & COMPANY IS PROHIBITED.
All information, illustrations, and specifications in this manual are based on the latest information available at the time of publication. The right is reserved to
make changes at any time without notice.
HXE69533 (05SEP13)
10
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement