Intelligent RS-232 to CAN Converter I-7530/I-7530T The PC can be the CAN host, monitor or HMI to access/control the CAN device through the CAN network by the I-7530/I-7530T converter. The programmable RS-232 device (For example: PACs of ICP DAS) can use the serial port to connect to the CAN network via the I-7530/I-7530T module. The I-7530/I-7530T is designed to unleash the power of CAN bus via RS-232 communication method. It accurately converts messages between CAN and RS-232 networks. This module let you communicate with CAN devices easily from any PC or devices with RS-232 interface. Compatible with CAN specification 2.0A and B Fully compatible with ISO 11898-2 standard Support various baud rate from 10K bps to 1M bps Jumper for 120 Ω terminator resistor Software configurable CAN and RS-232 communication parameters 1000 frames in CAN received buffer, 900 frames in RS-232 received buffer Watchdog inside Support transparent communication mode Serial COM command error response selection Utility tool for transmitting / receiving CAN messages CAN Monitor & Data log Tools Show CAN messages by hex or decimal format CAN messages with timestamp Easy-to-use data logger for the diagnosis of the CAN networks and recording of the received data Send the predefined CAN messages manually or cyclically Full-duplex communication mode of RS-232 devices is not supported Utility Features Wire Assignments CAN bus baud rate configuration CAN acceptance filter configuration CAN 2.0A or 2.0B specific selection Serial COM baud rate and data bit setting 1 CAN Interface Controller Transceiver Channel number Connector Baud Rate (bps) Transmission Distance (m) Isolation Terminator Resistor Specification Receive Buffer Microprocessor inside with 20 MHz NXP 82C250 or TJA1042 (only for I-7530T) 1 9-pin male D-Sub (CAN_L, CAN_H, N/A for others) 10 k, 20 k, 50 k, 125 k, 250 k, 500 k, 800 k, 1 Mbps Depend on baud rate (for example, max. 1000 m at 50 kbps ) 3000 VDC for DC-to-DC, 2500 Vrms for photo-couple Selectable 120 Ω terminator resistor by jumper ISO-11898-2, CAN 2.0A and CAN 2.0B 1000 data frames UART Interface COM COM Connector Baud Rate (bps) Data bit Stop bit Parity Receive Buffer RS-232 9-pin female D-Sub (TxD, RxD, GND, N/A for others ) 110, 150, 300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200 bps 5, 6, 7, 8 1, 2 None, Even, Odd 900 data frames LED Round LED ON LED: Power and Data Flow; ERR LED: Error Power Protection Power Consumption Power reverse polarity protection, Over-voltage brown-out protection 1W Mechanism Installation Dimensions DIN-Rail 72mm x 118mm x 33mm (W x L x H) Environment Operating Temp. Storage Temp. Humidity -25 ~ 75 ℃ -30 ~ 80 ℃ 10 ~ 90% RH, non-condensing Applications Ordering Information I-7530-G Intelligent RS-232 to CAN converter I-7530-G CR Intelligent RS-232 to CAN converter (RoHS) I-7530T-G CR Intelligent RS-232 to CAN converter (RoHS) 2
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project
advertisement
© 2021