Operation Manual for DOD Preamp Overdrive YJM308

Operation Manual for DOD Preamp Overdrive YJM308
YJM 308 manual
2:51 PM
Page 1
1.The warranty registration card must be mailed within ten
days of purchase date to validate this warranty.
2. DOD warrants this product when used solely within the U.S., to be
free from defects in materials and workmanship under normal use and
3. DOD liability under this warranty is limited to repairing or
replacing defective materials that show evidence of defect, provided
the product is returned through the original dealer, where all parts
and labor will be covered up to a period of three years.The company
shall not be liable for any consequential damage as a result of the
product’s use in any circuit or assembly.
4. Proof-of-purchase date is considered to be the burden of the consumer.
5. DOD reserves the the right to make changes in design or
make additions to or improvements upon this product without incurring any obligation to install the same on products previously manufactured.
6.The foregoing is in lieu of all other warranties, expressed or implied,
and DOD neither assumes nor authorizes any person to assume for it
any obligation or liability in connection with the sale of this product.
In no event shall DOD or its dealers be liable for special or consequential damages or from any delay in the performance of this warranty due to causes beyond their control.
DOD Electronics Corporation
8760 South Sandy Parkway
Sandy, UT 84070
Telephone (801) 566-8800
Fax (801) 566-7005
Printed in China
Operation Manual
YJM 308 manual
2:51 PM
Page 2
The YJM 308 Overdrive Preamp is the sound of a
guitar hitting raw distortion.The controls are
straight forward:
Gain: Adjusts the amount of distortion
Level: Adjusts the overall volume.
The switch engages or disengages the distortion.
Input Impedance: 4 M ohms
Output Impedance: 100 k ohms
Max Input Level: 6 V
Power Supply: 9 VDC
Declaration of Conformity
Manufacturer’s Name:
Manufacturer’s Address:
DOD Electronics
8760 S. Sandy Parkway
Sandy, Utah 84070, USA
declares that the product:
Product name:
Product option:all (requires Class II power adapter that conforms
to the requirements of EN60065, EN60742, or equivalent.)
conforms to the following Product Specifications:
IEC 60065 (1998)
EN 55013 (1990)
EN 55020 (1991)
Supplementary Information:
The product herewith complies with the requirements of
the Low Voltage Directive 72/23/EEC and the EMC
Directive 89/336/EEC as amended by Directive 93/68/EEC.
Changing the Battery
1. Remove the back plate screws.
2. Remove and replace the battery.
3. Replace back plate and screws
Note: To prolong battery life, unplug the input jack
when not in use.
President of Harman Music Group
8760 S. Sandy Parkway
Sandy, Utah 84070, USA
Date: October 10, 2001
European Contact:Your local DOD Sales and Service Office or
Harman Music Group
8760 South Sandy Parkway
Sandy, Utah
84070 USA
Ph: (801) 566-8800
Fax: (801) 568-7583
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF