STC JL STOP - DS Steering Stop Kit
STL JL CC Steering Stops
Installation Instructions for Club Car Models
Please remember to wear appropriate eye protection
Parts List:
A)
Driver Side Steering Stop
B)
Passenger Side Steering Stop
C)
1” x 1/4” Bolts (4x)
D)
1” x 1/4” Lock Nuts (4 x)
Instructions for Cars
A)
Raise vehicle and support with jack stands.
B)
Remove both front wheels.
C)
Use provided template (page 2) to cut out steering stop locations.
D)
Place the driver’s side template on the outside of the driver’s side I-beam.
E)
Tape template in place.
F)
Hold the driver’s side steering stop in position by aligning it with the notched end of the paper tem
plate.
G)
While holding the steering stop in place, mark where the two mounting holes need to be drilled
into the I-beam. Note: alignment can very from car to car and care must be taken at this time to
manually place the stop in place and turn the steering to make sure the hole placement will be
correct. Then mark your holes accordingly.
H)
Remove the template and steering stop.
I)
Using a 1/4” drill bit, drill holes through I-beam where marked.
J)
Install steering stop with supplied 1” x 1/4” bolts/nuts and tighten to 6-9 foot pounds.
K)
While applying torque to bolts, hold steering stop in the correct position.
L)
Repeat this procedure on the passenger side of the car.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement